Having problems with your Zanussi 18 in. DA4342 Free-standing Dishwasher ?

Zanussi da 4142 not pumping water away. filter not blocked


Answers :

Repair Help & Product Troubleshooting for Zanussi 18 in. DA4342 Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Zanussi da 4142 not pumping water away. filter not blocked


... Zanussi 18 in. DA4342 Free-standing Dishwasher

Zanussi da 4142 not pumping water away. Filter not blocked


... Zanussi 18 in. DA4342 Free-standing Dishwasher

HI dishwasher will not drain if i remove all the water will run thro cycle and stops with a couple of cms of water left have tryed to find filter inside and failed, removed sides and can see a pump on right hand side can turn impeller easily, is this the drain pump? if not how do i get at pump and or filter. is it possible that plastic chamber on left hand side could be blocked assume this transfers heat Robert


... Bosch 18 in. SRS55L02 Logixx Slim-Line Free-standing Dishwasher

My zanussi zsf6128 dishwasher is blocked I took out the filters and the water is still there how can I unblock the outlet pass the filter ??


... Zanussi Dishwashers

Zanussi DES 959 - AL5 warning keeps coming up indicating either the filters are blocked or there is no water coming in. Filters are clear and there is water coming in - what next?


... Dishwashers

My dishwasher starts as usual by pumping the remaining water away. Than it starts taking in clean water ... and stops. The arms don't start to turn and the machine just remains blocked. No beeping or anything, just silence. Can I adjust this myslef? Evert from Bologna in Italy


This is the wash motor not running. You will need a engineer to fix this for you. ... Whirlpool 24 in. ADG7540 Built-in Dishwasher

We have a smeg df612sdx7 dishwasher. the water is not draining away properly. i've taken the filter out but its not blocked and there is water sitting under it. we don't have a manual with which to check what to do.


... Smeg Dishwashers

I have a Karcher G2600 OR Pressure Washer, 2600 psi, 2.5 gpm. PN 1.194 506 0. gas engine works fine and water flows fine but pump is not adding pressure to stream. Checked and cleaned inlet water filter.


... Pressure Washers

OE Error on LG Dishwasher model LD-14AT2. Filters arent blocked and chord not kinked. Wont stop pumping water out in wash cycle. Seems to think there is still water in there when there isnt any at all. Any ideas as to what could be wrong?


... LG 24 in. LD-12BS6 Stainless Steel Free-standing Dishwasher

Dishwasher wont push water around inside tub correctly something is blocking water flow to pump i looked for filter could not find


The units diosposal screen is probably clogged.\015\012This is a relatively simple procedure that requires 2 tools. There is a screen behind the cutter in the built in disposal unit that gets clogged easily. You may want to order a new part bef ... Kenmore 24 in. 16032 Built-in Dishwasher

Hi I have a LG LD-2052 dishwasher. It gives me an E 0 error - the water does not pump out when I open the machine after a few minutes when started to wash and message of E 0 appears? Have cleaned an


... LG Dishwashers

Miele G 870 SC dishwasher drain was plugged due to blocked sewer line, now won't stop pumping even though all water is been excavated and the drain, trap, and filter have been cleared


There is a tray at the very bottom of the Miele. If the machine overflows for any reason, the tray will fill. (Your drain probably backed up into the machine.) This causes a float valve to put it into "pump it out" mode. The machine will be stuck in ... Dishwashers

I have a SGS53E72AU and it isn't draining away. I have cleaned the filters, checked to see that the pump isn't blocked by removing the cover and also checked for kinked hose. It is 2 and a half years old. Any suggestions would be greatly appreciated thanks Sally


First of all you must set the machine to a soft/quick wash and let the cycle run. During the process of the program check the voltage on the pump during the drain cycle. It is important that the controller unit supplies voltage to the pump. If power ... Bosch SHU4006 Dishwasher

Dishwasher ZTD 5052 : small amount of water won't drain away so I keep getting warning (flashing light on quick wash) it's only a cm or so deep at bottom of dishwasher, cleaned filter etc. still no luck. Sink is not blocked. Thanks


... Zanussi 18 in. ZDT5052 Slim-Line Built-in Dishwasher

Hi, I have a De Dietrich dishwasher model VW8810U2/2 approx 12 years old. The water is not draining, I have checked the filter is not blocked and the drain hose is clear of any kinks etc. I'm guessing it could be the pump. Can you advise of the cost of repair please. Many thanks Derek Springthorpe Willaston Nantwich Cheshire


... De Dietrich Dishwashers

Water not pumping away, filters are clear and the waste pipe is not kinked


Drain out is done via the pump out motor. Is the pump out motor working? Check by deternining with a AC voltmeter to see if supply voltage is across the terminals in pump out mode. If voltage is present and motor does not spin - the motor is open cir ... Bosch 22 in. SKT5002GB Built-In Dishwasher

Bosch Dishwasher SGS43E02 Exxcel. Switches on at main switch (0 appears in the numerical display) but none of the right hand programme buttons seem to be working! Have checked filter on water supply hose and that doesn't look blocked.


Obviously a faulty connection. Lots of switching off and on and holding down the buttons eventually sorted it! ... Bosch 24 in. SGS43E02 Exxcel Built-In Dishwasher

Hello My zanussi diva edw1500 stopped working half way through a wash and there is i30 flashing. According to the manual this is some protection against flooding. I thought it was my external drain was blocked and this was stopping the water from being pumped out of the machine. The drains have now been unblocked but when I tried to resume the dishwasher cycle ther same error appears. Please can you advise? Many thanks. Kind regards Jo


... Zanussi Dishwashers

Haier dishwasher Hi my Haier dishwasher is flashing 3 of the 4 leds and beeping 10 times while the suction pump drains the filter then will not start. Can you tell me what this fault is? water pressure OK ,drain isnt blocked,none of the buttons have any effect. Any info would be helpful thanks.


I useto have same problem. For some reason there was water under machine, then i tilted machine, clean water and problem solved. This is built-in dishwasher that is why water acumulates under machine and "leak cut off switch" turn off machine. You ca ... Haier ESD200 Built-in Dishwasher

Whirlpool ADP 5540 filter blocked up. Did not empty all water after cycle. Pump not coming on when start a wash. Light comes on but nothing happens.


... Whirlpool Dishwashers

Top wash arm does NOT spin, but is not blocked or hard to move by hand. Does this run off water pressure? Whatshould Itry next. I have already removed the filters and cleraned around the pump. The bottom wash arm works great.


Remove the dishwasher from the cabinet and look at the hose going up to the top. Make sure it isn't clogged and that there is nothing in the port where it comes out of the pump. The top arm is powered by water pressure from the pump. ... Frigidaire 24 in. FDB750RCC Stainless Steel Built-in Dishwasher

RE: SIEMENS SE26230GB/12 DISHWASHER Machine runs for over an hour on both wash and rinse program - just seems to circulate dirty water around. Is there a filter other the accessable one which may be blocked thus inhibiting pump out?


... Siemens Dishwashers

Zanussi dishwasher, z t i 6865, 6 years old. when put on, normal beep and noise begins;machine pumps away water, stops too early, never finishes a chosen program ( so no end-beep is heard) and the first 2 lights are on, the first programlight(cold wash) flashes. i have checked main-watersupply, cleansed with soda.Nothing helps sofar, please give instructions soon. ellen.


... Zanussi 24 in. DE6544 Built-in Dishwasher

Dishwasher seems to be blocked all water not pumped out cleaned filter can't find blockage


\012Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... Dishwashers

I ran a load of laundry in whirlpoo[ duet ht, model ghw9400pl4, error code p-09 was indicated. water was overflowing from door, and water was continuing to fill the tub. I turned off the faucets, unplugged & restarted in drain mode it hummed but would not drain. I turned the faucets back on and retried to drain but it would only hum. I manually removed the water by losening pump filter. There was no debree in filter except for a little bit of hair. The pump & vain was free & clean, and I co


It is your mixer value that is malfunctioning. ... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1552 seconds