Having problems with your Zanussi 23 in. ZDT6252 Built-in Dishwasher ?

Washer fails to start. Power o.k. and water supply on. Filters cleaned. When set to start makes regular sound as if trying to start cycle. Any advice please?


Answers :

Hi.


Check if the water is flowing inside machine or not.


If the tub is not filling, test the water level device (usually a float switch located on a side inside the tub).

Ensure that the switch is not stuck, and test the switch using a multimeter to ensure it is closing and opening. Disconnect power before testing the switch.


If water level is OK, then test the water valve.

The inlet valve is tested reading impedance on valve solenoid contacts. Disconnect power and remove the valve first.

If the valve solenoid is showing no continuity, then the valve must be replaced.

A dual valve sometimes can also be tested swapping hot and cold inlet contacts.


All test and repairing must be done by a professional.


To get a quote on repair, check warranty status or get parts, call Zanussi at the number listed on the owners manual.
Repair Help & Product Troubleshooting for Zanussi 23 in. ZDT6252 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Washer fails to start. Power o.k. and water supply on. Filters cleaned. When set to start makes regular sound as if trying to start cycle. Any advice please?


Hi.Check if the water is flowing inside machine or not.If the tub is not filling, test the water level device (usually a float switch located on a side inside the tub).Ensure that the switch is not stuc ... Zanussi 23 in. ZDT6252 Built-in Dishwasher

My ariston lsv 66 dishwasher will not start washing cycle. It makes the pumping noise as it normally does at the start of the cycle and some water enters the bottom of the machine but then it stops. I have checked to make sure that there are no leaks so the problem is with the filling up of the machine. I live in a hard water area and haven't used anything to help reduce the limescale so expect this to be playing a part. I have tried all the washing cycles but the same thing happens. Any advic


HERE I AM I LIKE THIS JOBE\015\012 PLEASE CHECK THE WATER INLET FILTER I FEEL FROM YOUR DESCRIBE IS IT\015\012 YOU NEED TO CLEAN IT BY ASMALL BRUSH >\015\012 THANKS ... Dishwashers

I have a Tecnik TKD795/3 built in dishwasher. It is now making a gurgling noise as though it is draining water when I try to start the cycle, but the cycle does not start and no lights come on at all. I have tried pressing the outside two buttons to reset, but absolutely nothing happens and the gurgling noise continues until I release the power button. Can you help please?


... Tecnik 24 in. TKD795/3 Built-in Dishwasher

Hi. Our DS603I dishwasher starts on the Rinse cycle on its own - it beeps, red light flashing and no water entering the tub. It does this even if it is open. Similarly, when we try to turn it on to do a normal or heavy cycle, it starts (making quiet a loud noise) and then goes to the Rinse cycle, beeping, red light flashing, no water going into the tub. The pump wheel is turning. We can't find any blockages in the tubes. We have power-cycled it many times. Please help!


Dishwasher Repair Guide: How To Fix a Dishwasher - ACME HOW TO.com\015\012\015\012\015\012\015\012 ... Fisher DS603W / DS603B / DS603I Dishwasher

Dishwasher: Kenmore ultra wash sensor quiet guard plus. I'm in a rental so I don't have the manual or model number. A few days ago it just wouldn't start the wash cycle. When you press normal wash then start the no heat dry and lock lights flash every other second or so but nothing happens. I can hit the cancel button and it will make sounds like its trying to drain, and after about 5 minutes stops. I've done the heated wash/ no heat dry sequence to try to reset but no luck. Also tried turn


... Kenmore Dishwashers

I have a Whirlpool quiet partner III dishwasher that began to make a loud scratchy noise when the cycle started. This went on for a few months but it was still cleaning the dishes. Last weekend we tried it and it just kind of stopped---there is a kind of buzzing at the point when the cycle should start and then it does nothing. It does still drain of the cancel cycle. What does this sound like


There could be some debris obstructing the spray arm assembly from turning freely, puting extra working load on the motor and it now started to cut off(thats why you get the buzzing noise) since the motor also activates the water pump(reversible) it ... Whirlpool Dishwashers

Bosch Dishwasher model : SHV4313GB/17 The machine won't switch off and the pump is still trying to drain water ( there is no water left in machine ) The cycle seems to have finished as it has made the beep sound as if it has finished. The dishwasher is still working even when you open the main door. Have tried to reset it but to no avail. Even after turning it off at the mains it still starts up again as if in mid cycle ! HELP PLEASE


I have a SHV. My sink drain backed up, and the water accumulating in the sink then migrated to the dishwasher, through the drain pipe, causing the dishwasher to fill up and, it turned out, overflow a little. When I turned on the dishwasher, the wat ... Dishwashers

Hi. I have a smeg slimline DF140 BA dishwasher. It will not start any program. The lights come on but it just makes beeps and doesnt start. Have tried turning off and trying to cancel the cycle all to no avail. Please help


... Smeg 18 in. DWF409WH Slim-Line Free-standing Dishwasher

My Beko dishwasher dwd 4310 w will run a full cycle but makes a choked, gargling sound and takes hours to complete a cycle. I mean 7-8 hours! There are long periods of inactivity with the machine before it goes into the next part of the cycle. It is the same on all settings. Please help!


... Beko 24 in. D3731F Free-standing Dishwasher

All of a sudden, my Kenmore dishwasher (Model 363.1411691) will not cycle. When I lock it shut and try to set it to wash, all I hear is a click--no motor running, no water sounds. As I advance the timer knob, I just get clicks where each cycle should begin. There is standing water in the bottom of the dishwasher which does not drain out. Any advice would be much appreciated, for sure.


Hi.The clicks are simply the relays in the timer board that try switching on. The control module is likely working.The cycle does not start because of a different problem.If no light is coming on, then ensure that wall socket ... Dishwashers

Hi My dishwasher stopped mid rinse cycle, with a little water still in it. Lots of beeping later i managed to set it back to start but it wont go, just beeps. The line to sink seems to be clear. There is no gurgle sound when i try to start it. model number SB907WJ*00


Hi,Is there my error code there?If you set the appliance to drain do you hear the pump running?Bail the water out manually and then take the filters out.Bail out the water below the filters.Take off the ... Dishwashers

Frigidaire dishwasher model fghd2433kb1 fills with water but then doesnt start wash cycle makes intermittant humm sound like trying unsussessfully to go into wash cycle


... Frigidaire Dishwashers

GE triton xl dishwasher has power but will start a cycle. Lights come on when buttons are pushed. When you push start it makes a locking sound but does nothing. I've tried restarting by turning power off for 30 seconds to a minute and still does not help.


... Dishwashers

LG dishwasher. Stopped working mid cycle. Model LD~1204W1. Able to turn on and off. Able to press all other settings so can change wash temp, half load, full load etc. but cannot start programme. When press start makes a double beeping sound and nothing happens. Help as live in hot country and water is going to smell bad pretty quick. Thank you.


... LG Dishwashers

My Milee dishwasher indicated that I should add salt to the salt reservoire. I did this and then started to run a quick wash. However, the machine started to make a strange grinding noise. I turned it off immediately, tried again, but its still there. Please can you provide any advice?


Hi\015\012If noise occurs within first minute of starting program, then the is most likely something in the drain pump. Remove filter, On left of sump you will see a non return valve with a metal clip keeping it in place push clip ti centre of ... Miele Dishwashers

Bosch SMU 2000 (2042-600). Will not start wash cycle. Can hear very faint clicking sounds with ear next to control switches, but motor does not start, etc. Tried various switch combinations (pots/pans, etc.), but does not make any difference.


... Bosch Dishwashers

Telmann Dishwasher TEL 12DWM. Dishwasher started to make weird wooshing start-stopping sounds at the beginning of the wash cycle so I stopped it. Since then the lights are on but wont go regardless of where the switch is set to. Have pulled the pump off and the inlet pipes and blown to remove any blockage but still no luck. Cant get into the water jet part due to connectors that require specfic tools to remove and replace. Any thoughts?? thanks in advance, Michael


... Dishwashers

After 3 years it just started making a loud noise, I am no expert but it sounds like a fan in a motor. I have only heard it today, but I am betting it will still happen next load too. I didn't change any of the settings, have been running the same way forever. When I did hear this noise I started pushing buttons to see if I could get it to stop, no good, no change. The cycle has completed and everything looks ok, waiting on the dishes to dry. Drainage has never been a problem for me either.


I would say this is a build up of lime.try changing your tablets and checking your salt levels.there is no fan .try what i say and see what happens.have you found a glass broken it could be as simple as that but i dont think its serious.adrian,,,, ... GE Nautilus 24" Built-in Dishwasher

My dishwasher started making a whirring sound around 20 minutes into its cycle. I took off the drain pipe to check for obstructions, however it was clear. I started the cycle from the start again, and it started the whirring sound from the start of the cycle. There was a small amount of water that drained into the bucket where I had placed the drain hose, however there was not much water in the machine to start with (I checked when it started whirring the first time and there was no water in the


Hi.\015\012\015\012A blocked pump in absence of water won't be noisy from start. Check that\015\012 the whirring sound is not given by the spray arms. Test without baskets\015\012 and check the spray arms assembly.\015\012\015 ... Fisher and Paykel DS605I Built-in Dishwasher

I turn on my dishwasher and press regular cycle and try to start a cycle but pressing start does nothing. I am unable to change cycles to anything other than the regular cycle and I cant start. Have turned off and on. Ideas?


... Bosch SGE63E05UC 24 in Builtin Dishwasher

My Professional series model fdbb4365fc2 Makes a slight intermittant thumping sound a few times when its started and than after a few moments it shows the error code uo. For a while we could cancel and try a different cycle and it would work. I checked drain hoses and sink trap all looks o.k. What is my options


... Frigidaire Dishwashers

Prima lpr601 problem- filled dishwasher up sa normal set the wash pressed button on far right (dont know what it is but needs to be done), closed door and loud raattling so i opened door to make sure all spray arms were clear which they were, closed the door , again the rattling . now the green light has gone out on far right and cant get it back on so program wont start at all. Any advice?? please help


... Dishwashers

I have a bosch she5al06uc/05 and it seems to run for a long period of time. I end up manually shutting it down. It doesn't make any sound indicating that the cycle is done and I have tried resetting it to the default settings with no success. I'm not sure wat exactly is suppose to be flashing wen in the control panel either. any help would be appreciated.


Hello,Welcome to FixYa.Based on your description I'd say the issue is with the control...unfortunate ... Bosch SHE5AL06UC 24 in Builtin Dishwasher

Bosch dishwasher Dishwasher given to me two months ago and everything came out brilliantly clean. This week everything coming out white. Salt and rinse aid full. Have not changed settings. Does not come off glasses. Baked on. Everything getting ruined. Also started to sometimes make whiny sound at certain times in cycle. Filters clean.Please help!


Check the salt cap is not split and tight. if this is o.k try to empty out the salt and use 3 in 1 tabs as they contain salt and rince aid ... Kenmore 13869 / 13864 / 13862 Dishwasher

Our hot water supply to the kitchen sink became disconnected and flooded the kitchen. Since then it appears that we are not getting any water INTO the dishwaher (just makes a terrible grinding sound..solenoid stuck ?? ). I did put 3 or 4 quarts of water inand it drained alright. Also tried cancelling the cycles but that hasn't helped. We also discoonected the power for a day but still no luck. Please help Ron


... Bosch SHX55M02UC Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1848 seconds