Having problems with your Zanussi Dishwashers ?

Disher washer is stuck on first part of cycle and will not move on to next part of cycle


Answers :

Replace the dishwasher timer control assembly.
Repair Help & Product Troubleshooting for Zanussi Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Disher washer is stuck on first part of cycle and will not move on to next part of cycle


Replace the dishwasher timer control assembly. ... Zanussi Dishwashers

I have a whirlpool for Ikea dishwasher that is built in and I put it on the normal 30 minute cycle before I went to bed and 8 hours later it was still going. I opened the door and machine was full of suds. It is like it gets stuck and can't move on to the next part of the cycle. I have checked the filter in the bottom of the machine and checked the salt and rinse aid levels.


It could be waiting for the temperature to reach the required level.\012\012Sounds like the heater element has died. ... Whirlpool Dishwashers

Ge model # gsc3200j01ww dishwasher. when the door latch is closed, nothing happens. motor does not start. if the timer is advanced to the next part of the cycle, water will spray into unit until float valve is triggered. water will not pump out, motor does not start. bailed out water, checked for stuck float valve-ok. removed drain screens and filters, cleaned. no motor, drain, or start. what parts should i check? always rinsed dishes before putting in washer. unit is portable or undercounter


... GE 25 in. GSC3200J Built-in Dishwasher

I have a Bosch (SHU5302UC/U12). The washer often takes 2 or more hours to run. Sometimes it gets stuck for a long time part way through (e.g. just sits at "43"). Other times, it gets stuck at 1 and won't stop on its own. The latest thing is 2 dots have appeared on the display that I've never seen before. For example, instead of "43", it reads "4.3." Eventually it gets to "C.L." but does not stop running. Also, its been making very strange noises during part of the wash cycle.


... Bosch 24 in. SHU43 Built-in Dishwasher

The dishwasher does not complete a cycle. It starts the cycle just fine but then it stops after one minute. It seems like it gets stuck and won't move to the next step. I do hear a slight clicking noise similar to a clock ticking, like its trying to move on, but then it stops. It clicks three times. When I open the door the "fine china" light is on even though I set it on "normal". Is there a "re-set" button?


The Control Board is gone, the part is $475.00 Find a new one.... ... Viking Designer Series DFUD041 (Premium) Built-in Dishwasher

The washer won't complete it's cycle. It just runs and runs. One time I got it to complete by turning it off, then switching to the Rinse and Hold cycle, but now nothing works. It doesn't drain the water, it appears to be stuck in the wash part of the cycle.


... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

The spray arm, above the top rack, keeps unscrewing during the wash cycle. Just the arm comes off leaving a round plastic part attached to the top. This can be unscrewed and inside is a white 'washer'. The arm can be clipped back but comes off again in the next wash. The plastic 'washer' has to be turned over to allow re-attachment. Is a washer missing from inside?


Could the arm be mounted upside down and rotating the wrong way? Just an idea... Some of these can fit either way and the retainer will fit either side of the arm. ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

It makes a grinding noise in the middle of the cycle like it is stuck and can not get to the next part of the cycle. We have tried starting the cycle over, but that does not always work. MOD DU1055XTPQ4


... Whirlpool DU1055XT 24 in Builtin Dishwasher

Kenmore elite 2 front loading washer model#110.45872400 It first flashed the code FH and then went to the running time is now flashing and it sounds like it is running but the cycle never starts and I cannot cancel the cycle by pressing pause/start two times. I have checked the water lines and the screens and cleaned out the drain catch below. what next


... Kenmore Dishwashers

My Kenmore Elite dishwasher doesn't proceed past the first few minutes of any cycle. It gets stuck at the "add a dish" part of the cycle and then stops and starts. It won't go further into t


... Kenmore Dishwashers

I have a Kenmore Model # 587.1430590. It's stuck in the drain part of the cycle and I can't get it out. I've checked to be sure that the float isn't obstructed or stuck and I've tested the float switch to ensure that it is working properly. What should I check next?


Stuck in the drain would not have any thing to do with the float . the the float and it's sw only controls the power to the fill valve . i would think that in the start of any cycle it will drain first then advance to ... Kenmore Dishwashers

Washer keeps spinning water and not moving on to the next cycle


Sounds like the timer has gone bad and is not letting anything work. Washers, dryers and dishwashers have a timer that you set at the start and then the system counts down off of that. If that stops working it will run forever ... Bosch 24 in. SHU43 Built-in Dishwasher

Hi, I have a Siemens SE24A230GB/17 dishwasher and it is not completing the wash cycle (any selected). It appears to be stuck on the 'wash' part of the program. I have done the reset actions as advised in the User Manual and tried another program, without success. I have found that the possible causes could be the timer or thermostat. The estimated time remaining display counts down, but the program does not complete the wash and move onto rinse and dry. Any help or advice you can provide would


... Siemens Dishwashers

Have a hoover hed6612 dishwasher just over a year old, it pre rinses and part washes and then doesnt move to the next rinse cycle instead it stops and beeps continuously with the prerinse and wash buttons both on. this is not a problem happening constant just now and again but more recently.


We have had the same problem but have found a fix. 1. If any of the wheels have come off the top sliding basket/rack you need to make sure they are all back on for each wash ( ours are very loose! ) 2. Push the top rack in FIRMLY be ... Hoover Dishwashers

I have an Indesit d62 dishwasher, approx 10 years old. It gets stuck part way through a wash cycle and I have to switch it off and move it on manually for it to finish it. Could you tell me what is wrong and how much to fix?


... Indesit 24 in. D61 Free-standing Dishwasher

My bosch dishwasher gets stuck in wash mode. We have to turn the dial to move to the next cycle. When we check inside soap suds are built up on the bottom. We use less than a 1/2 of an Electrasol tablet, no wuick dry ball. We just ran the dishes with no soap and there's still soap on the bottom?


... Dishwashers

Timer stops during wash cycle, washer continues to wash but does not move to next function.


Hi,That is a good indication that it is time to replace the timer...The timer motor is not strong enough to overcome the resistance of the switches or the timer is jamming up.\012Here\012is a tip that will help ... Westinghouse Dishwashers

Set the dishwasher going and no it seems to be sticking and not moving onto the next part of the cycle, there is no water in the machine what do i do.


The water-inlet valve lets water enter the machine. First Check to see if the valve is getting water. Make sure it's not clogged. There is a screen on the inside of the valve, this sometimes gets clogged up with debris. Check to see if you g ... Dishwashers

The green clean light is flashing on my Kenmore Elite Ultra Wash dishwasher. After the reset sequence, the washer will run only 1 part of it's washing/drying cycle, then flash the clean light again... I have only owned it about 14 months, and this is the first problem I have had.


You may just need to reset your control board. Go to the link and it will explain how to reset the control board as well as explain what might cause the issue and how to fix it.http://www.appliancerepairlesson.com/dishwasher-2/dishwasher ... Kenmore 24 in. 17032 Built-in Dishwasher

I need to move the dishwasher on to the next part of the cycle manually ie by operating the dial rather than allowing it to run automatically.


Hello, welcome to FixYa.\015\012\015\012Based on you description of the timer not advancing I wonder, does it appear to heat the water ? I doubt it if my suspicion is correct. \015\012\015\012The SHU 30** unit`s w ... Bosch Dishwashers

Bosch dishwasher, Model SMU 7056, UC 09, FD 7309. My older unit has operated flawlessly for years. Two days ago it started to "stall" in one cycle and not progress to the next, e.g., stayed in the wash cycle and would not move on to rinse. In addition the heat generated in the machine was way below normal. A repairman told me that if the water doesn't get hot enough, the unit will not move on to the next cycle. I always use the "Regular Wash" option, but tried other options such as 'Economy


... Bosch Dishwashers

Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk


... Dishwashers

I have a Jade RJDW2470A dishwasher which was re-branded Jade. (It is a Maytag product.) It get's stuck between cycles and will run forever unless I manually advance the dial to the next cycle. It seems to get stuck around the "rinse" cycle and the soap door does not open until after I advance it past that cycle.


... Jade RJDW2470A Free-standing Dishwasher

Hotpoint Model HDA 3500N 10 BB Unit is only about a year old. The dial does not move. I noticed it when the washer was on for more than 3 hours and saw that the dial was still in the middle of the wash cycle. I then turned it to the rince cycle which operated there (not moving) until I manually moved it to dry. Did not move from there either. Thank you for any help you can give me.


HiThanks for using FixYa. From what you have described it seems to be an issue with the timer that has gone bad, they don’t often fail but if everything else is working fine then it is the Timer ... Hotpoint Dishwashers

KENMORE DISHWASHER STUCK IN WASH CYCLE it will not move off of this postion water heats up it cleans but does not move off this cycle. New 2008 Kenmore 1610 built-in dishwasher won't leeave wash cycle. repair person says it is supposed to take 3 hours.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1134 seconds