Having problems with your Zanussi Dishwashers ?

Jan kolbe dishwasher knob not coming on - Zanussi Dishwashers


Answers :

Repair Help & Product Troubleshooting for Zanussi Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Jan kolbe dishwasher knob not coming on - Zanussi Dishwashers


... Zanussi Dishwashers

I have a zanussi tempoline dishwasher, I have loaded this as I usually do, turn the knob to the right and select the 2nd programme the light next to this comes on, I have pressed this to start the machine although it seems as if it is going to start this light flashes and the top arrow on the right of this flashes intermitanly, but the machine does not start the wash programme. The 3hr delay button if I had pressed this by mistake which I am sure I have not would light up. When I found it did no


Hi Ruth.The machine can be in error mode. In this case one or more lights in the control pad will stay on or flash and the cycle will not start.One of the most common fault in your situation, and at start of the cycle is no wa ... Zanussi Dishwashers

Westinghouse undercounter dishwasher. after shutting door with latch, comes on when dial knob turned to selected wash. was taken out to redo floor underneath. after being placed back in position, did at least 2 loads fine. now after dial knob gets to selected wash, dishwasher light comes on and i can hear the motor try but then starts clicking. there is also water at the bottom inside the dishwasher


This seems to be a drainage problem, obviously. There may be some food debris in the drain tube where it connects to the drain pipe. It would be easy to detach and do a visual check, and see if you can clear the clog. Also, try to s ... Dishwashers

Model #363.14232100 dishwasher. When you turn the switch to on, it will not come on. If you keep turning the knob slowly you can hear the dishwasher trying to start up,but it doesn't. Keep turning the knob and its the same thing, sounds like it will start, but it doesn't. It did fill with water, but once it was opened it didn't start up where it left off. The lock switch was in position, and still nothing. Now I have water in the bottom but can't get the thing to come on. Any suggestions? Help!


... Kenmore 24 in. 16539 Built-in Dishwasher

My Whirlpool Dishwasher ADP931 has stopped working. It stopped in the middle of the cycle with 2 to 3 inches of water on the floor of the compartment. I mopped out the water and tried to restart the dishwasher. The green "on" light now comes on when I press the start button. but nothing happens (no motor comes on,no water enters).Repeating the above action several times does not help the washer to restart even though the other function lights will come on when the knob is turned. saturn1914


Hi,Whenever you see such symptoms, Time for you to investigate it properly. Check the below guide :-\015\012\015\012\015\012\015\012\015\012Power from the house\015\012\015\012Is\015\012there power getting to the dishwa ... Dishwashers

My dishwasher SMS 448 works up to the point in the cycle when the dispenser is supposed to dislodge the Powerball detergent. It doesn't, and the machine stops. If I open the door and click the dispenser, the Powerball falls into the dishwasher unit itself. But when I close the door, the machine doesn't operate until I turn the knob a bit farther on in the cycle. Then, no water comes out, but the knob moves on in the cycle and the heating pipes heat up


... Bosch Dishwashers

I have Whirlpool dishwasher about 3years old it is the ADP7966 AAA 6th sense. When I put it on and turn the temperature knob, only the first temperature green light comes on althou I can turn the knob all the way round none of the other lights come on, my rinse aid and salt programmes light up thou ,and when I press the start button it flashes twice stops a bit then flashes twice again, and thats all it keeps doing. I would be very grateful if you help to solve the problem. Many thanks to you.


... Dishwashers

DISHWASHER PROBLEM HI, Last night I ran the dishwasher down in our kitchen down stairs. Four hour later I heard a humming sound coming from down there. I noticed the dishwasher went through the cycle perfectly , except on the hot drying cycle the timer knob was stuck and won't budge. I cannot move it either way. So I just unlatched it. Want do you think happened?


Do you see any error message on the display? ... GE Nautilus 24" Built-in Dishwasher

Zanussi DW908 dishwasher will not fill with water, when filled manually completes cycle untill fill time again. when filled continues on until water needed again. Only cold supply to machine. Water coming to valve, removed valve and freed it up as it was stuck, water flows through the valve when disconected from the dishwasher at filler pipe which leads up the side of washing chamber. When all connected up water will not enter the dishwasher. I,m beaten as I cannot access this area without maj


\012\012Hi,\012Here\012is a tip that will help you to find out why water will not come into\012the dishwasher... Dishwasher Trouble ... Zanussi Dishwashers

Hi, I bought a used fridgaire dishwasher, installed it. But, the water is continuously coming inside the dishwasher even the dishwasher is switched off. The only way I can stop water is from the main faucet knob. Is there any problem with pump?


Replace the water inlet solonoid valve asm. Located where the water line connects to the unit. ... Frigidaire Dishwashers

My zanussi dishwasher model LS9p coming only C8


... Zanussi 29 in. LS14 Free-standing Dishwasher

Water not coming into dishwasher - Zanussi 24 in. DE6965 Built-in Dishwasher


Pour a bucket of hot water into the dishwasher (be careful not to overfill) then turn the dishwasher on. You'll probably have to wait a couple of minutes before it will start up. If it starts spraying water around inside the dishwasher, you have a ba ... Zanussi 24 in. DE6965 Built-in Dishwasher

My Zanussi dishwasher DE6744 leaks clean water during the wash cycle. The water appears to be coming from the plastic tank overflow holes, left hand side as you look from the front. Any ideas?


I have the same machine and I took mine outside and turned it on its side and removed the clean water feed and all the screws holding the white plastics off and then un-clipped them off and I saw that there was a blue tube that was leaking on mine, I ... Zanussi 24 in. DE6744 Free-Standing Dishwasher

ZANUSSI Da 6341 dishwasher, Flooding in middle of cycle. Sometimes at start of cycle (5-10 mins) washers floods and water comes out of front. If i move timer to end of cycle pump works and water is pumped to sewer. This doesn't happen every time. Sometimes cycle works perfect and after that doesn't


... Zanussi 24 in. DA6141 Built-in Dishwasher

Zanussi de6754 dishwasher. the lights for wash & dry keep flashing & no water coming in


... Zanussi Dishwashers

GU2300XTSB dishwasher, bought in Jan 09. The dishes come out with film on them and especially on plastic handles of utensils. We have run a couple of cycles with vinegar, with no luck. We use one teaspoonful of soap.


We are having the same problem. Have you come up with any solutions? It is so frustrating. ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Zanussi ZSF 6126. With door shut and knob turned to position A (or any position) only the WASH LED comes on. DRY and END are extinguished. No water enters machine. Supply is OK. Filters are clean. Any clues please?


... Zanussi Dishwashers

I have had no problems with my GE dishwasher for the last 3 years. All of a sudden, when its draining, the water is coming up through the extra knob on the sink. I am not sure what it is called, but it is the unit next to the sprayer on the sink.


The drain line between the air gap (thingie next to the sprayer) and the sewer drain piping. If the sink drains fine, the clog is between the air gap and the point at which it connects to the piping under the sink.Please take the time to ... GE 24 in. GSD4060JSS Built-in Dishwasher

My opening knob has come off - Bosch Dishwashers


Put it back on.what is the model #? ... Bosch Dishwashers

Zanussi zdt6053 in built dishwasher not starting. When pressing the control panel on/off button the 65 deg normal wash light comes on. When pressing the program selection button nothing happens. When closing the door the machine does not start up. Is there a fault in the control panel circuit board? Would water pressure prevent the machine from operating?


... Zanussi 23 in. ZDi6053SX Built-in Dishwasher

I have a zanussi dws909 dishwasher and there is no water coming in when I switch on. Have checked pipes which are ok


... Dishwashers

Dirty dishes I have a zanussi slimline dishwasher, but no matter what I do the dishes still come out gritty and sometimes food particles stuck to inside of cups and glasses, glasses have a white film over them and have to be done by hand, pointless really, I use finish tabs or persil or anything that is of good quality, and use a rinse aid and salt. What is the problem


Try putting a cup of white vinegar in the empty dishwasher & running it on fast wash. Should eliminate film; do you have hard water where you live? If so lime build up could be the problem.\015\012Hope this helps.Cheers. ... Dishwashers

Zanussi zsf4123 slimline dishwasher switch on, power light comes on, noyhing happems when program is selected. Is it likely it is the control unit? if so where can I get one in the UK


... Zanussi 18 in. ZSF4123 Slim-Line Free-standing Dishwasher

Intermittent Dishwasher fault Zanussi 23 in. ZDT6252 diswasher only partially drains in some of the wash cycles. I suspect it's a faulty float valve & sometimes too much water is taken in at the start of the cycle. Anyone else come accross this??


Fixed the problem by replacing the ELECTRIC ANTI-OVERFLOW VALVE. Simple enough installation - bit fiddly.\015\012\015\012\015\012 ... Zanussi 23 in. ZDT6252 Built-in Dishwasher

Zanussi DA6141. Dishwasher will not progress from turning on at wash code c1. Test 1: No kinked hoses Test 2: Put water in by hand and it empties it. Lift out the central sieve/filter and it all appears very clean. Test 3:Inlet water filter clean. No actions except low buzz (?solenoid?) after emptying. (Possible Hint: Previously this washer sometimes stalled with knob rotated 15 degrees clockwise from C1 position and would continue to wash dishes indefinitely, if unattended. This was


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. If the\015\012cycle doesn't complete, check these:\015\012\ ... Zanussi Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2171 seconds