Having problems with your Zanussi Dishwashers ?

Door springs DOOR WONT STAY SHUT HOW DO YOU LOCATE THE DOOR SPRINGS


Answers :

If the door won't stay shut the issue is with the door catch not the door springs, But if you want to know where the door springs are you need to remove the outer cabinet of the dishwasher and you will see them on the lower sides.
Repair Help & Product Troubleshooting for Zanussi Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Door springs DOOR WONT STAY SHUT HOW DO YOU LOCATE THE DOOR SPRINGS


If the door won't stay shut the issue is with the door catch not the door springs, But if you want to know where the door springs are you need to remove the outer cabinet of the dishwasher and you will see them on the lower sides. ... Zanussi Dishwashers

Soap door wont stay shut


Mark,You can find what you asked for as far as manuals in our web directory.It sounds like a door latch to me!huuum,happy to assist you!How old is the appliance? If th ... Bosch 23 in. SHU33A Built-In Dishwasher

How do I replace the spring in the soap door? Spring appears to be broken because it is sticking out from the door. Door will not stay shut.


It depends on the breakage. Contact service center and get the part replaced. ... Bosch 24 in. SHU43 Built-in Dishwasher

My miele dishwasher door all of a sudden drops and stays open half way. If i lift it up to close, it falls back down to half way. Adjusting the tension spring makes the door slam shut and not stay open in the down position


... Miele 23 in. Novotronic G841 Built-In Dishwasher

Wont start cycle unless i open door all the way and shut it . when cycle starts it stays on that cycle until i open and shut door again. is their a way to reset


... Maytag 24 in. MDB8751A Jetclean II Built-in Dishwasher

The door wont stay shut on frigidaire 4300. I have cleaned all around including gasket. Halfway through the wash cycle, cycle stops and we get CL code for open door. If we push on door, it goes for another few minutes.


Something is wrong with the door latch. Replace or make adjustment. ... Frigidaire Dishwashers

KITCHEN AID STAINLESS DISHWASHER MODEL #kuds02frssWe just replaced both springs in the door and the latch mechanism and the soap dispenser that still does not work. Our door will not stay shut. MY HUSBAND NEEDS HELP.. PLEASE HELP. HE IS VERY GOOD AT REPAIRS AND IS STUMPED!!


Hi.Your husband must check wiring harness from electronic control to door lock solenoid.The solenoid should also be tested reading Ohms with a multimeter.Here parts and diagrams: ... KitchenAid 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

Thor dishwasher door springs too tight and door wont stay open


... Dishwashers

Door wont stay shut - Jade RJDW2470A Free-standing Dishwasher


... Jade RJDW2470A Free-standing Dishwasher

Bosch SHU4302 WITH REPAIRED PC BOARD has been working fine for several years now seems stuck in rinse/drain mode and is not quite pumping cabinet dry. I have removed the screens and located the small impeller at bottom below cover. The impeller rotates as though it has multiple spring loaded stop positions. When I turn on the unit and open the door water is trickling from the sprayer arms at low pressure. It seems stuck in rinse mode and will not advance cycles or reset when shut off.


... Bosch Dishwashers

My KitchenAid dishwashers door will not stay shut. I have replaced both hinges, the plastic rollers for the tension lines that atached to the spring. Still no luck. Could it be that the locking (?) switch has worn out?


Sure thing. \015\012Our dishwasher is one that we put our own "Door on it" in our case, it matches the cabinet. It is designed for that. \015\012I went on-line and ordered the replacement parts. I can't recall the site but I will look thr ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Door open light stays on when door shut.


Sounds like a faulty door switch not sensing that the door is shut. test the switches for continuity to determine the faulty switch ... KitchenAid KUDS24SE Built-in Dishwasher

We have a siemens dishwasher model #SL34A015UC/29. When we push the door in to shut it , it clicks but does not stay shut, it clicks back out. It will not work because the door won't stay closed for us to turn it on.


... Siemens Dishwashers

I have a GE dishwasher (purchased in1992) the door falls open I suspect a broken spring. I looked all over the door hinge and cannot locate a spring(s). Where are they located. Also because of the age would I be better off to just replace the washer?


... Maytag Dishwasher

Door wont shut properly and washer will not start


Is this a problem that just happened at once or gradually got worse?Does the D/W seem to be installed tightly to counter??If it is firmly mounted than you need to take loose the screws that are holding it in place to your counter.Usually there ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!


... Whirlpool GU2400XTP Built-in Dishwasher

Electrolux Dishlex Door wont shut When I shut the door of my dishwasher, the clip does not seem to engage and you can open the door even when the cycle is running!


Spring it catch still working you just may need to replace it ... Dishwashers

Door will not stay shut when not in use. The only way it stays shut is to push all the way in until it latches.


If automatic door check the solenoid if plunging correctly if not check the supply voltage ... Frigidaire 24 in. FDB635RF Built-in Dishwasher

The spring on the door broke (loud sound) and now the door is heavy and doesn't stay up unless we latch it each time. How do we find instructions for installing a new spring?


Its hard to find instructions but go to sears parts direct and order parts .you will see the location of the parts and a image that should put uyou in the right direction ... Frigidaire PLDB998A Built-in Dishwasher

My Miele dishwasher turns off (light goes off) when door is shut and wont work


... Miele Optima G2470SCVi Built-in Dishwasher

Dishwasher door When I opened the door I heard a pop and now the door drops to the fully open position. It used to stay as open as I pulled it, but now there is no tension as if a spring broke.


You're right a spring has either snapped or come off of it's anchor point. Should be 2 ...one on each side of the door. you can order parts on line at several appliance replacement part suppliers... have your make and model so you'll get the right pa ... Kenmore Dishwashers

I own model KUDIO1FLSS2, perhaps 3 yrs old. When I opened door this a.m. I heard a loud "boing/clunk" noise. Thought perhaps silverware had fallen. When I re-shut door, realized there is no spring action, hence the door just falls of its own weight. HELP! Jeff Glew 139 Essex St Beverly, MA 01915 phone 978 922 7635


Do you still need help with this? I dealt with the same issue with my kitchenaid dishwasher. ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have a Frigidaire FDB2410LDC3 Dishwasher. It was working great until my 5 year old fell on the door and it does not spring back up now. I tried looking with a flashlight in the sides and the springs may be OK. What is most mystifying about this is something has gone wrong with the part your hand uses to close and open it. The latch is limp so I wonder if there was some other spring in there that broke in the incident. Now after some time of forcing it to shut (due to that pesky latch that


Prhandle and latch.obably sprung the hinges. The reason it dont want to work right is the door latch is not latching properly and therefore it wont start. I would start by replacing the hinges and springs and the ... Dishwashers

DOOR SPRINGS TOO TIGHT WILL NOT STAY DOWN ON ITS OWN


You did not post the make and model number but you need to pull the unit out and check the spring location to see if there is a hole that ison the bracket and you change the hole that the spring is in to loosen the tension ... Dishwashers

Renlig dishwasher door will not stay shut


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1136 seconds