Having problems with your Zanussi Dishwashers ?

Zanussi DX6453 stops mid cycle and the end light flashes 6 times


Answers :

Repair Help & Product Troubleshooting for Zanussi Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Zanussi DX6453 stops mid cycle and the end light flashes 6 times


... Zanussi Dishwashers

I have a Whirlpool ADP6515. It's been working fine for about 2 years now but recently cycles are not completing properly, it can run for 30-40 minutes depending upon cycle. The start light is flashing a 4 times repeatedly, I think this happens when it moves from a wash to a pump cycle but not sure. We have to hold down the start button to force it to go to the end of the cycle and the the lights stop. If we do that we can then use the dishwasher the next time, but only after we force it to go to


While replacing the console board, the replacement should be of same version. The boards are using programmable IC. Hence matching the software version is a must. Only the manufacturer or his authorized provider can help regarding t ... Whirlpool Gold 24 in BuiltIn Dishwasher w Adaptive Wash Cycle 24 in Builtin Dishwasher

Kenmore elite dishwasher stops in mid cycle green clean light flashes 8 times pauses and then flashes one more time


Float Switch\012\012\012The float switch may be hung up and this can cause the dishwasher to be stuck in a cycle. see the diagram\012\012\012Timer / Control\012\012\012If your dishwasher gets stuck in a cycle fir ... Kenmore Dishwashers

I have a Kenmore 665.1373 Ultra Wash dishwasher that will not work. In the past few weeks, it stopped mid-cycle, the the clean light began to flash. Sears sent out a technician who told us that the latch was not catching. He adjusted it, did something with a computer and the dishwasher worked for a couple of days. This time, it would not start a cycle, it would only show heated dry if you pushed the smart wash button and nothing if you press start. It looks like some of the lights are continuous


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Indesit d41 problem.My d/w stops mid cycle and the 4th light flashes rapidly,this does not happen every time and sometimes it will complete the cycle without any problems.It seems to be an intermittent fault.When it fails to work the heater doesn't work.


... Indesit 18 in. D41 Slim-Line Free-standing Dishwasher

My cda dishwasher cw448 is 18 months old, and has recently begun to stop before the end of the cycle. When I open the machine, 3 lights flash, (one of them the rinse button), and the machine bleeps repeatedly. Why doesn't the cycle complete? I've checked the filters, the spray arms, all the dispensers, and manual doesn't give any answer. This doesn't happen all the time, but is occuring more often now.


... Dishwashers

Whirlpool model DU960 - from 2001, I think. Stopped running mid-cycle and the cycle lights flash. Won't run. How to fix? If I press 'Cancel/Drain', it flashes that button light. If I press one of the wash cycles again, it turns on the pump for about 1 second, shuts off and the lights flash again. I tried turning off the circuit breaker and turning it back on, but it still won't run. Is this fixable? Do I need to call for service? Or, would I be better off just replacing it?


I have a whilpool du960 the rinse only light is flashing and the light wash light is also flashing. ... Whirlpool Dishwashers

Hi my Tecnik DW2677 repeatedly beeps at the end of (or sometimes during) it's cycle. I have to open the dishwasher door to stop the beeping noise, but then the light on the "START" button flashes 4 times over and over again. Any ideas please?


... Tecnik TDW2677 Built-in Dishwasher

Zanussi dishwasher zsf6126 drains water, won't go to fill, red light end cycle flashes three times


... Dishwashers

My GU 120 stops mid cycle and the indicator light starts blinking a humming whirring sound preceeds the ctcle stop nad light blinking. Pressing the button for 5 seconds causes the flashing light to extinguish but the sound continues untill the unit stops. It does not complete the full cycle. Your help would be appreciated. Tony


... Whirlpool Dishwashers

Diplomat dishwasher ADP8112 - stopped mid cycle, full of water, no lights on. Thought on/off switch faulty so fitted a new on. Now when you switch it on, lights 4 and 5 flash, then there's a beep and then flashing lights stop and lights 3 and 5 come on and stay on. Any ideas as to how to fix, please?


... Dishwashers

Kitchenaid kudc03fvss0 dishwasher stopped mid cycle without drying dishes last week and then stopped altogether with lights flashing and full basin. I disassembled filter/pump cover in bottom and cleared several plastic pieces and cleaned chopping blade and screen. After unplugging/plugging and pressing cancel button the pump runs for about 10 seconds and stops with normal and heavy duty lights flashing. What should I check next?


... Dishwashers

First 2 weeks ago i put an electric control module into the upper section. what comes on is the green flashing light for clean. in checking connections i found the paper for trouble shouting. i did what they said to do. they said hit the time saver - high temp - time saver - high temp. from there all the lights went on & the wash cycle started and ran. then it just stopped & the green light for clean just flashes. the water is still in the bottom & won't drain.


The error indicates that the machine has taken too long to drain the water. Do the following.\015\012 \015\012\015\012Switch off the machine, unplug or disconnect the ma ... Kenmore 16874 Built-in Dishwasher

I have a Beko DE2431FW Dishwasher which has stopped working. I select a cycle and then press start, the green light starts to flash and the cycle begins to start but after about 30 seconds it stops and the red 'end' light comes on. this happens no matter what cycle I chose. Can anybody help me with this please?


... Dishwashers

I HAVE A WHIRLPOOL DISHWASHER AND THE LED LIGHT FOR CLEAN KEEPS FLASHING AND IF I PUSH THE CANCEL BUTTON IT PUTS IT IN TO A DRAIN CYCLE THEN THE LIGHT KEEPS FLASHING I CAN SELECT ANY CYLCE I WANT BUT WHEN I PUSH THE START BUTTON ITS LED FLASHES SEVERAL TIMES AND THEN STOPS AND THE CLEAN LED LIGHT STARTS FLASHING AGAIN


Check out it there is a water leak to the bottom housing. Usually this happens when there is a leak activated the flood sensor causing LED light turned on. Dry out the leak then leave it unplug for 24 hours so the sensor dry out by itself. Make sure ... Whirlpool Dishwashers

It stops when it has only done the rinse cycle and a light flashes 4 times quickly and pauses and the light flashes 4 times again and again


The IC module controlling the rinse operation is faulty. It is not sending the control to the next module. Or the IC module controlling the drain operation, which is not taking the signal to get working. Either of the two is at fault. Please have it ... Dishwashers

My Whirlpool ADG 7561 Dishwasher is not completing a cycle. Is completed standard rince, but when put on a full cycle it is stopping after around 10mins and constantly beeping. When I open the door, the green Start light is flashing 3 times then stopping, then 3 times again etc. Any idea what this means?


... Whirlpool ADG 7561 Dishwasher

Whirlpool dishwasher adg7540, light flashes 4 times, water at end of cycle, goes to rinse


... Whirlpool 24 in. ADG7540 Built-in Dishwasher

Dishwasher malfunction stops after approx 2 mins of any cycle, green light flashes 7 times then stops, 7 times then stops etc. does not appear to be taking in any water. have cleaned all filters.


BAD WATER SELONOIDE, OR BAD BOARD ... Dishwashers

My SHE4402UC/36 dishwasher malfunctioned all the lights were flashing and the machine was trying to drain. The guy came out and replace the control board. The dishwasher now read 199 on all cycles except the rinse and hold, the santitized light does not come when its done. The repair guy told me the count down timers were flakey on the the Bosch dishwashers and it would learn my dishwashing patterns in time. So 6 cycles later the dishes are still damp at the end of the cycle-the length of the cy


Well its not baloney but it is cheesey. normally changing the module is the cure but it has to be programmed correctly. bosch has a recall so check it out and see because the recall is free and the tech is suppose to know how to program it. go to the ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Bosch dishwasher I have a month old Bosch dishwasher. It was stopped mid cycle. I drained the water at the bottom, but the active light keeps flashing, and when I press the start,reset button, then turn it off, it does the same thing when I turn it back on. active light keeps flashing and the wash light is on. It won't even lock the door. How do I fix this because there is no Bosch dealers here to help with the problem.


... Hotpoint 23 in. BF41 Built-in Dishwasher

Hello , we have a blanco BFDWC65 dishwasher supplied to us by our builder , The dishwaser fills with water ok then once in cycle it starts (with all operating lights ) then stops , it continues to start then stop for the rest of the cycle , Quiet some time later it finished and then drained the water ok , now it struggles to get to the end of the cycle. have checked all filters , water pressure and for clogged hoses , everything is ok in that department. Any help would be apprieciated


I would suspect the control board in this type of behaviour. As the machine is new I advise no interference, but to open a claim under warranty. You would have all the warranty papers for this unit, or should have received them from your builder. The ... Dishwashers

Frigidaire fdb1500lfco stops mid cycle and high temp light and heat dry light flash, does not ever restart to finish cycle.


... Frigidaire Dishwashers

I have a Frigidaire Series PLD2855RFC3 dishwasher. Near the end of the cycle the dishwasher stops and begins flashing "PF" on the display and the lights for "Hi Temp. Wash" and "No Heat Dry" also flash. I know "PF" = Power Failure, but the power never goes out... so what is causing this error and disruption in the cycle?


... Dishwashers

Stops mid cycle often Our westinghouse 905 dishwasher often stops at the rinse part of cycle, flashing lights, water sitting in base of ...


... Westinghouse Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1422 seconds