Having problems with your Zanussi & Electrolux Fridge Freezer Handle Genuine ?

Can u put screws into fridge doors?

\015 Need to screw bottom milk container to door as lug has broken off\015

Answers :

Repair Help & Product Troubleshooting for Zanussi & Electrolux Fridge Freezer Handle Genuine

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Can u put screws into fridge doors?


... Zanussi & Electrolux Fridge Freezer Handle Genuine

Bosch Dishwasher I have a stainless steel Bosch dishwasher, I made the "mistake" to try to see if I could fix the jammed handle from the door. Unfortunately, (did not realize the top panel comes off without opening the entire door). I removed the screws from the door frame (Inside panel), and the door springs/latched got loose. I would like to put it back together, but I dont have any diagrams on the door to make sure all parts are in place to put the door back together. I have been havin


Hi ED,\015\012\015\012It sounds like a real problem here. If the springs are still in one piece, my best guess is to to remove the springs from the door. Then attach the springs to the dishwasher body first, then reattach the spring to the door. Not ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

I need the diagram for the door pulley system so I can make sure I am hooking it up right. The original door chord/pulley assembly broke. I ordered new parts, Now I want to make sure I am putting it back together the right way. The edge of the screw- on floor panel is pushing the plastic hook off of the door hook when you shut the dishwasher door.


... KitchenAid Dishwashers

Panel door to integrated prima dishwasher has fallen off. Cant find instructions to put it back. It only has 4 shortish screws straight into panel and 2 strips of Velcro-is this right


... Dishwashers

Handle on BOSCH Dishwasher Model SHX46L05UC/18 became loose and now is off on one side. How do we get into the door to put the screws back where they belong and tighten.


To fix the door handle, first you need to remove the outer door, open the door and remove the T-20 Torx screws located on each side of the inner stainless door. \015\012 \015\012Return the door back to its\015\012upright position, and bri ... Bosch Dishwashers

It was not draining so i put a screw driver in the latch to simulate the door closed and the catch is stuck in


... Kenmore 16919 Built-in Dishwasher

Soap door on my Whirlpool dishwasher model # DU810SWKU0 does not open.I had inner door off to check rinse agent problem.Is there something i did putting inner door back on? If I close soap door and turn timer knob on outside of door the soap door will open after I make two full turns of the knob.If this cant be fixed can I just put soap in the bottom tray that has no door or put soap in both trays and do not close the soap door? Thank You RH.


... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

The door handle is broken which enables the opening of the door. Therefor we can't open the door and need to replace the handle but dont know how . The handle is situated inside the door and there are no screws around it to to take it apart. It is an Indiset DG5000 model. There are screws at the edges of the door.


I had a similar problem with a similar model.\015\012Insert a fine screwdriver into the small space immediately abive the handle. Press the inside end down firmly and the lock should release.\015\012I ran mine for about 3 weeks, this wa ... Dishwashers

Close the Maytag dishwasher, cycle starts, but I noticed a leak! Dishwasher door can be opened by putting your fingers on the edge and pulling it open. Tried it again, door clicked, thought it was ok but still could open door with fingers. Emptied the washer, door locked. Put in a few dishes, same problem


Your problem appear to me like it come from your upper basket .\015\012pleas try 1st to ensure the basket goes inside\015\012untill the end it is important..\015\012 thank you ... GE Dishwashers

I have a built in tecnik tkd7000%2F2 dishwasher. The door which the fitter attached was held on by 4 screws which were directly screwed into the wood of the door. After a short time the door fell off. Can you advise whether the door should be held on with some sort of fixing kit? thanks


Some DW have a fixing kit, but doors can also be secured as yours is. You could put slightly longer screws in but please check as you do not want to screw right through the door. If you look around the inner edge of the DW door there are sometimes ot ... Tecnik 18 in. TKD7000 Built-in Dishwasher

I have a KUDM22 dishwasher. I need to replace the soap dispenser. Which screws release the inner panel of the door; the 10 screws around the moulding or the 6 screws on the inner door panel ?/


... KitchenAid 24 in. KUDM25SH Built-in Dishwasher

Dishwasher leaking We bought our dishwasher in Sep/07, it was fine for a year, then started leaking out the bottom of the door on the left. We had the seal on the door replaced (didn't work) and then the door gasket replaced. That worked for less than a year, now it is leaking again in the same place. What could be going on? Have already put $400.00 repairs into this machine and am reluctant to put more money in to have it break again the same way. What do you suggest?


This sounds like a hinge problem to start with.\015\012\015\012Test the seal by dragging a strip of paper through it with door closed. Probably that left hinge isn't holding door close enough which was probably the original cause. As se ... KitchenAid Architect? II S SERIES KUDS03FT Stainless Steel Built-in Dishwasher

Screw drop Hi I was installing my new LG dishwasher and I droped a screw in the hole in the side panel where you can put a screw to connect to the side of your cabinet. There is a small plastic cover which I removed where you can screw a screw into the cabinet. However the head of my screw was too small and fell in the side panel. I can not get the screw out or see it now although I know it is in the dishwasher. Is there anyway of getting it out or will this cause a problem? Since it is in t


A great retrieving tool for this is a flexible shaft magnet wand. I strongly recommend this tool be placed in everyone's toolbox.\015\012\015\012as far as leaving it there if not found? probably safe from electrical. will years of vibration allow it ... LG 24 in. LD-12BS6 Stainless Steel Free-standing Dishwasher

I have a bosch dishwasher model number SGS0902GB/05. I use tablets instead of detergent. I put the tablet in the Dispenser and close the lid, noproblem. I then set the programme and shut the door, I usually set the programme to delay start so that it washes dishes in the small hours when all are in bed, however, when I have set the programme and close the door within a minute the dispenser assembly opens and the tablet falls into the dishwasher, I then try and put the tablet back in the dispe


Hello Andrew,\015\012\015\012I'm more than happy to give step-by-step instructions for replacing the detergent dispenser, however it's not cheap (about \302\24350) and it probably doesn't need to be replaced. Some of the smaller component ... Bosch Dishwashers

I have a sears pressure washer, model 580752300. The pump on the underside vibrated lose and broke a couple screws. It came off and the oil drained out. I replaced the screws and it's ready to go except I can't find out how much replacement oil to put back in. Sears has larger containers but won't tell you how much oil to put in. However, there's a pricey pre-measured container they want to make you buy. Anybody know how much oil goes in that pump?


... FAIP Non Marking Pressure Washer Hose 4000 Psi, 50ft. Length

Reverse swing freezer door in fridge - Indesit Ariston Fridge Freezer Door Hinge C00144877


... Indesit Ariston Fridge Freezer Door Hinge C00144877

My daughter put the wrong detergent in the dishwasher (!). Now its stuck in drain cycle. If I put it onto wash cycle I can hear it draining even with the door open, but when I shut the door it doesn't go to wash and the bottom fills up with water. Thanks!!!


Hi,You need to find the bottle of white vinegar or cooking oil, if you have one...that will cut the suds and get you working again...Check this out...http://www.acmehowto.com/howto/appliance/dishwasher/wrongsoap.ph ... Bosch Dishwashers

Front panel My dishwasher wouldn't drain. I read I had to remove the front panel under the door and get to the hose to look for a blockage. I screwed out two screws on the side of the dishwasher and removed the white front panel just under the door. But then there is another metal panel and I can't loosen it. Is it just stuck or is there soem way of doing this? Elmi


Did you knock out the plug on the disposal before you hooked up the drain hose ? ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Bosch KGV2620GB/03 Hi, I have a Bosch KGV2620GB/03 fridge freezer (bottom freezer, free-standing, the product listed below isn't right) and the light in the fridge won't switch off when the door closes. Any ideas? I assume it's something to do with the switch that registers the door has closed, but not sure how to fix. It's an electronic control, so there's no temperature wheel/switch inside, and we don't have the user guide (which I also can't find online!). Any help much appreciated. Dan


Hi,\015\012 If it is the one I am thinking of, then the whole light assembly is actually able to move and this also acts as the switch.\015\012\015\012Turn off the appliance and unplug.\015\012\015\012You should be able ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Maytag model mdbtt70aww. After the end cycle. open the door and found detergent tab on the bottom and the main wash cover is opened. Maytag diswasher model MDBTT70AWW. Put dishes and so forth in the dishwasher. Put detergent tab and jet-dry rinse agent in the pre-wash section. and close the cover. Start wash cycle after done over door and found the detergent tab on the bottom new the heater. The cover to the main wash is opened. Dishes are are clean. Wish someone would tell me


... Dishwashers

How do i put the lower spray arm back together? I had to replace the top screw part and it seems to stand up to high. I have a small white plastic ring, a larger white split ring and the arm itself. I have tried every configuration to put this back together but it is not right - the new "screw" part number is the same as the original.


... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

DOOR TENSION The door is too "savage" the tension need adjusting but how there are no obvious screw's available or do we have to remove the dishwasher from its fixed position to get at screws on the side that is if they are there?


Open the dishwasher and look at the top of the chassis, where the door catch is. You'll see 2 screws with hexagonal heads, one on either side of the catch. Turning these screws will apply or reduce tension on a wire liked to a spring on ... Indesit 23 in. DV62 IX Built-in Dishwasher

AEG Favorit 80820 dishwasher tablet door opens as soon as switched on and door closed. When you put the power on and select a wash and then close the door the small grey dishwasher tablet inside the door can be heard to open as soon as the door is closed. Normally this door remains closed until asked to opened automatically by the dishwasher at the correct point in the selected wash program.


... AEG 24 in. Favorit 80820 Free-standing Dishwasher

KitchenAid Dishwasher KUDP01FL: Called repairman to replace balance link kit. Then door extremely stiff to open & heard loud pop when one of the ropes came off the roller. Repairman came back & put rope back on & replaced door seal, then the door won't close & he claims need a new door latch. When he left, door again extremely stiff to open & heard same loud pop when one of the ropes came off the roller. Now he says he can't fix it and to call someone else. I now have three problems: (1) The doo


May have bent door hinges,, need to check all alignment of door, hinges and latches... ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have a Fisher & Paykel fridge (freezer top, fridge lower) probably approx 3 to 4 years old, fridge and freezer works ok, but drips water from top plastic tray below freezer into fridge and into door trays. I'm thinking that defrost or whatever line is blocked (possibly/hopefully ice) Will turning fridge off for a few days fix it ? or is it something worse ? The round plastic bowl/catcher is always empty thank


Hi,\015\012The drain may very well be blocked with ice....that is not at all uncommon...\015\012\015\012Let the fridge off for a day to clear any ice and then blow through the drain to make sure it is open...\015\012\015 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0901 seconds