Having problems with your Zanussi ZT485 Built-in Dishwasher ?

GE roll around dishwasher

\015 Dishwasher is at lesast 6 years old I hook it up... turn it to start and it runs but the dial stays in place ... when I opened it there was no water in it... \015\012line is clear...\015

Answers :

Check to see if water is in basin. If so remove with dry rag until dry. Then run. If water is in basin, float will trip to stop inflow (flood precaution)
Repair Help & Product Troubleshooting for Zanussi ZT485 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

GE roll around dishwasher


Check to see if water is in basin. If so remove with dry rag until dry. Then run. If water is in basin, float will trip to stop inflow (flood precaution) ... Zanussi ZT485 Built-in Dishwasher

BOSCH DISHWASHER SG157MO5GB REFITTED AFTER NEW KITCHEN INSTALLED. FOUND PLASTIC PART (LIKE SMALL SHOWER HEAD) ROLLING AROUND INSIDE. WHERE SHOULD IT BE FIXED, PLEASE ?


... Bosch Dishwashers

I have a GE roll around dishwasher, Model GSC3200Z03BL. It worked one night, did not work the next. After hooking intake/discharge hose to faucet and turning to start, no water is pumped in. Only a humming noise much like something is stuck preventing pump from allowing water in. What to do? Appreciate the assist.


First off.. the pump does not let water in.. it takes water from your sink faucette via the hose and allows it to enter the DW via an inlet electrically operated valve. If that valve is not commanded by the control system to open, then no water will ... GE Dishwashers

I have a 7 year old Kenmore 24" (mod. 16532201) built-in dishwasher. For the past several months now I have noticed a dark almost greasy film covering the inside of the dishwasher after doing a load of dishes. It can also be found around the soap dispenser door, basically everywhere. I'm wondering if the black rubber around the inside front of the dishwasher is deteriorating. It doesn't appear to be damaged or cracked. I have tried "Finish" dishwashing cleaner several times, but to no avail


There are several items apart from the door seal in the dishwasher that comes in contact with the wash water that circulates inside the dishwasher.\015\012\015\012One will have to eliminate one by one - the most likely cause is the washer ... Kenmore 24 in. 16352 / 16354 / 16359 Built-in Dishwasher

My dishwasher has a leak around where the motor and pump connect. I tried to tighten screws, but they are tight. Do I need to replace pump? GE Appliance Website says that pump is no longer available. This dishwasher was purchased around 1998 timeframe. Thank you.


Hi\015\012\015\012Though it seems that the pump should be replaced however,\015\012please post back with the model no of your GE dishwasher. Hope this\015\012helps...please post back for further assistance.\015\012\015\012Daniel ... Dishwashers

FDW60 dishwasher - taken apart pump and that is clear. Seems that dishwasher fills, and empties and heats all OK but water wont go around the machine ie the motor pump doesnt start - any idea how to take this out and replace without having engineer around? Taken small pump apart and its clear. First of all the Eco and fast light flashed, then we took it apart with some direction from online discussion advice. Now Eco and Pre wash lights are flashing. Machine empties water, then fills with


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

LG Dishwasher I just purchase a new LG Dishwasher. The installer told me that the dishwasher can not be flush to the Kitchen cabinets because of the metal cases around the dishwasher and also it can not be aligned with the top and bottom of the cabinets because the door is too thick to give it clearance to open. I have had two other dishwashers in this spot and never had any issue. Thoughts? Thanks, Jen


I can't say for sure, but it is possible this unit is deeper than previous units. The only way to tell for sure is to measure the previous unit and compare to this one.I would be suspect there may be something simple preventing the dishwa ... LG LDF6810ST Stainless Steel Built-in Dishwasher

Nasty dishwasher there is nasty wet grunge at the bottom of the door, around the place the heating unit in the bottom of the dishwasher. half the time the dishes are clean in the bottom of the dishwasher. half the heating element is melted..for some reason...what do i do. the dishwasher still works, if we make sure the dishes are clean before they go in. using more for a sanitation thing than a dishwasher. can ya'll help me?


Sounds like your heating element is broken and you should replace it to prevent a possible fire hazard. \015\012You can replace the element easily for not alot of cash. You'll need to pick up a new one at an appliance parts store, just bring them the ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I was told by a repairman that the seals around the motor swelled because I had gone on vacation for two weeks and not used the dishwasher. He charged $85 to turn the motor manually and restart the dishwasher. The dishwasher is 5 years old. Does this mean I can never leave for two weeks at a time and come home to a working dishwasher?


No. The unit most likely had some debris stuck in the macerator. The seals are water lubricated and its possible that some detergent dried between the seals. Detergent is a lot like glue when it dries. You are probably using the factory recommend ... GE Dishwashers

My dishwasher emits a dead animal smell immediately after filling. I have a 20-year-old KitchenAid KUDS220T3 dishwasher. The racks are a little corroded, but it still cleans dishes just fine. About two months ago, it started smelling like a dead animal immediately after the dishwasher fills with hot water, during the time the water is being heated, but before agitation begins. The smell appears to be coming from around the door. If I open the door, everything inside the dishwasher smells fine.


This vent that you are describing is to allow air to flow in for the heat/dry cycle. Some times little creatures want to "mark" their territory by "spraying". Spray some type of cleaner like ammonia into it and **** it out with vacuum a few times. Mo ... KitchenAid Dishwashers

Water won't drain from bottom of dishwasher. I pulled the dishwasher out, blew through the drain tube, disconnected the drain tube and felt around inside. Ok there. The dishwasher has not been in use for 4 months, due to low hot water flow. I replaced a clogged valve today and restored water flow, and I'm wondering if non-use causes a problem with dishwashers?


Sorry to hear that you are having problems with your DW.Actually, yes. Not using a dishwasher for a while can damage some parts. Sediment from water damages the water valve. Food residues clogs the drain and drain pump. More likely the ... Dishwashers

Dishwasher I am getting a run around with getting my LG dishwasher fixed properly. We had a tech more than once come in and look at our dishwasher. It has not been fixed and never dried the dishes properly. It is now leaking and going to a "del" level when we attempt to wash the dishes. It is also leaking on our fairly new tiled floor and under our new kitchen cabinet. Your tech stated the dishwasher was not installed properly. The installation dept , Francine stated it is not their problem


Not sure what you mean by a "del" level, but as far a drying issues:\015\012\015\012LG chose to use a very energy efficient drying method which relies on the residual heat of the dishes to help dry them rather than many manufacturer ... LG LDF6810 Built-in Dishwasher

"crud" around the bottom of dishwasher, around drain


If this buildup is external, and around wet areas, it may be a rubberised seal which has been applied wet to seal leakage. This is done in the factory using tube products like Selleys ar SikaFlex liquid silicon sealant and once it hardens its like a ... GE Nautilus 24" Built-in Dishwasher

Leaking This is a problem that I have when the dishwasher is in drying mode. I will find a 5X5 and sometimes smaller, size water spot under the dishwasher after the dishwasher has stopped. I was told it was the vent were the steam comes out and I had that replaced. It still leaks, then they told me to replace the rubber around the door, still leaks now they order a whole new plastic interior door. Please if you have any ideas what could be causing the problem, please let me know. Thank you


\015\012open the bottom panel 2-4 screw\015\012take a flashlight and turn the machine on\015\012see where it come from\015\012if you need take the unit out a bit f ... Jenn-Air JDB4000AWS Stainless Steel Dishwasher

Disposal plugged up and water backed up into dishwasher. Cleared disposal and dishwasher drain line. Checked around sump but dishwasher won't pump out. Sounds like pump is trying to run. I can blow air through the drain hose from the disposal and get bubbles in the water. Turned off breaker for 1 min. then tried reset. Can hear pump humming.


The pump is humming because its still trying to get all the water out of the unit. Deinstall the dishwasher and pull the entire dishwasher out from under your cabinet. Next step would be to disconnect the drain line from the drain pump and check to ... Dishwashers

Dishwasher is model DWD1SSE type11045 Initially the dishwasher leaked water on the floor On investigation the bottom tray under the dishwasher was wet The motor was wet Tested the motor which was fine although the capacitor on the motor impellor was dead. Replaced capacitor, now no water going around the spray heads so found the impellor inside broken. Replaced that. No hoses are leaking. Machine now works fine heats up etc etc but over fills and the E5 fault shows


... Smeg 24 in. DWD1SSE-1 Built-in Dishwasher

My Kenmore Elite dishwasher (model 665.17462300) is not spraying the water from the basin in the bottom up through the rest of the dishwasher. The basin fills with water, then just makes a humming noise and appears to splash a little of the water around the very bottom of the dishwasher. When we cancel the cycle, it does drain out the water from the basin. I cleaned all the gunk and debris out of the basin in the bottom, but it didn't make any difference.


... Dishwashers

My dishwasher (frigidaire, quiet clean 1) there is some sort of black stuff (for lack of a better word)underneath the screen in the bottom of the dishwasher and it comes out around the dishwasher when the cycles are done...


Run a cup of vinegar ... Frigidaire Dishwashers

My LG dishwasher -LDF7810st has been a huge problem from the beginning. However I will just focus on the current issue. Previously it was leaking and I kept towels under the dishwasher. Then one night there was a deluge of water all over the place. One guy says the seal is bad then another no its the whole seal around the dishwasher is bad. No one seems to know and I dont want to spend $250 to find out. I remember a previous post that said their was a design flaw with a part of this but cannot f


... LG 24 in. LDF7810 Built-in Dishwasher

INSULLATION BLANKET Today I had two KitchenAid dishwashers installed. The installer took the insullation blanket off and told me that it was not necessary. He did this because the dishwashers did not fit under the counter with it on. I bought these dishwasher because if had a 51 Db rating for sound. They are noisy. Is it possible that this wrap around polyester foam like blanket actually helps decrease the sound?


Get his **** back out there. ... Dishwashers

Portable Dishwasher I have a older model portable dishwasher. It works great and until it goes out I would like to keep it. I am wondering how or what I will need to make the dishwasher a non-portable. I get so tired of moving it across the kitchen floor. Is there anyway I can hook something up to my lines underneath the sink so it will stay where it is? it is only about 10 ft away from my sink but that it alot of moving around when it is full of dishes. Please help. [email protected]


I sent you and email with some instructions, Look to hear from you soon!! ... Kenmore 17252 Free-standing Dishwasher

Its a GE dishwasher and water is left in the bottom of the dishwasher. I have run it through its cycle twicw it sprays water around in the dishwasher but doesnot want to drain.


There is a solenoid valve located near the motor which should activate to either drain or to spray. These often get jammed up with food particles. Locate it and take it apart. Clean out what ails it and put it back in service. ... Dishwashers

Matsui mf145 dishwasher appears not to finish its washing/drying cycle. first couple of washes machine bleeped 8 times and dishes were clean and dry. now after around 2 hours machine bleeps for around 1 minute and when opened a lot of suds are left in the bottom of machine and dishes are still wet.


... Dishwashers

Dishwasher leak I have a General Electric Potscrubber Mobile Maid dishwasher (model GSC720?) that hasn't been used in some time, but appears to still work OK. It has a leak from the left hand vent opening in the bottom of the door when operating. The seal around the door appears intact and doesn't leak. Can you suggest a probable cause, and remedy? Thanks, Bob.


With dishwasher empty and disconnected, find the screws around the area of the "vent",you may need to open it from the bottom. There will be a hose that has either ruptured or just needs the clamp tightened with a screw driver. I think that the hose ... Dishwashers

Kenmore Dishwasher Model #110703412 leaks, likely around the motor shaft. Are there motor shafts seals and how are they replaced? Does the motor assembly remove through the tub or does it require being removed from the bottom? Do you have to remove the dishwasher from the cabinet to do this job?


... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1343 seconds