Having problems with your Dishwashers ?

Candy cs455 m dishwasher tripping out power

\015 My Candy cs 455 m dishwasher trips my main incomer when half way through a wash cycle\015

Answers :

Check heating element
Not familar with this specific model, but you may have a bad heating element the heat portion of the wash cycle usually turns on about half way through if it has an exposed element take a good look at it see if you see any unusual marks on it or open areas, you other then that you would have to check it from under the unit useing a multimeter to check continuity and for grounds.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Candy cs455 m dishwasher tripping out power


Check heating element ... Dishwashers

Candy Dishwasher Power Trip Problem...........................


Hi Adam,\015\012\015\012Those are tough questions, it depends on accessibility of the parts in question, and the tools you have available to you. \015\012It’s worth remembering that 80% of d/washer faults are mechanical in nat ... Dishwashers

Dishwasher I have had above integrated dishwasher which is intermittently tripping the mains fuse. Power is getting to dishwasher and the washing cycles work until a certain point (not the same time) where a loud bang can be heard and the main fuse is tripped. Reset the main fuse and power still gets to the dishwasher and it works again. It has just started to trip the fuse when its not running any cycle (just when power is getting to it). I've checked the fuse on the spur and it looks ok. I hav


Its quite common for the interferance filter to fail on these models its situated in the base of the dishwasher connected to the mains block usually when they fail you can see black dust around it, ... Neff 24 in. S5456 Built-in Dishwasher

No Power I have a bosch shx33 dishwasher. I just replaced the water valve because of a leak and now I can't start the dishwasher. It's like there is no power to the unit. I know there is power because I get a shock if I touch the two wires that are connected to the water valve. Is there another trip switch or something somewhere?


First let me say that using parts of your body to test for mains electriciy is a VERY VERY bad idea. You are lucky you are not dead. Please do not touch live parts again, get a multimeter or a mains tester.\015\012\015\012If there is mains across the ... Bosch 24 in. SHX33A02 / SHX33A06 Free-standing Dishwasher

Hobart AM14/1 free standing dishwasher with booster. Booster will not heat up beyond 41C. All three heating elements check ok with Ohm meter. High limit not tripped. Temperature screw up at maximum, when you turn the screw, you can hear thermostat click at lower temperature on and off. When turning on main power for dishwasher, heater in dishwasher works fine, but no relays click in the booster tank area. Have not checked for power at booster, have checked all fuses with meter and are ok. Ple


... Hobart AM14-253 Free-standing Dishwasher

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

Power tripping When I press the power button on my 6141 dishwasher it trips all power to the house. There is no visible external reason and I have changed the fuse but still have the problem. Could you please help?


First off, lets make sure its not the wiring in your house. disconnect the dishwasher and plug in something else and see if it trips the fuse. also what amps is the breaker rated at? ... Zanussi 24 in. DA6141 Built-in Dishwasher

Main power safety tripping when i turn on dishwasher power - Help


In the long run i would go with a new one...use less power get parts longer looks better wife will be happy hi hi ... Dishwashers

Dishwasher Normally, after the dishwasher cleans the load, it displays green light next to clean. Once the door is opened, the light goes off an dishwasher is ready for next load. But from few days, after opening the dishwasher door, the clean light does not go off, it remains lit. Dishwasher doe snot reset for next cycle. So, I have to go in the basement and trip the main power to dishwasher. That resets the dishwasher. This needs to be done before each cycle. Not sure how to resolve the issue.


Make sure that you do not open the door during the wash cycle. Wait until all the cycles \015\012are complete before opening the door. Especially don't open the door \015\012during the drying cycle. ... Dishwashers

My AEG Favorit 86011 dishwasher keeps tripping the power off- sometimes it works but then trips the power when you open the door mid-cycle. There is no obvious blockage in the draining pipe. Any ideas what could be causing the issue?


... AEG 23 in. Favorit 86070Vi Built-In Dishwasher

Miele dishwasher trips power switch


... Miele Dishwashers

The dishwasher trips the safety switch in the meterbox. whirlpool ADP 5000 made in germany (not on the drop down list) the 1st time was after a finished cycle and the power was off in the morning. the second time the power was on at the wall and when thw nob to select the cycle was turned, the power went off. any ideas would be really appreciated. julian


\015\012Please DO NOT touch this machine IF the power is ON. There is a possibility of shock. The reason, the ONLY reason, that the Breaker "Trips" is, if there is a, Phase fault to Earth/Neutral, in other words the CA ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Got a Indesit Di620 Dishwasher that trips RCD after power up & immediateley as you shut door.Fault is definately related to pressure switch, disconnected pipe to switch and then able to start cycle, without tripping, small amount of water out of pipe,but cycle only lasts for a few minutes, then stops. ( blowing into pressure switch trips rcd )How can i test switch, or is it a water level problem ??Any help would be good, thanks S.C


... Dishwashers

I have a hotpoint LFT04 dishwasher. Recently it tripped the power supply, and now when we start a cycle after a few minutes it stops and the lights on the power button and cycles 2 and 4 flash constantly. If the power button is turned off and the door closed, after a period of time it starts up again automatically. Any ideas appreciated.


... Dishwashers

Our Dishwasher is not draining. We tried to run a test cycle and noticed there is no power. We checked the Electrical Panel and noticed that an unmarked breaker was tripped. We turned it on but still have no power. All other electrical items are working in the house. Is the power being cut off as a fail-safe function due to the water not draining? How do I fix the drain/pump? Please Help!


Hi,No, the water is a result of the dishwasher going off mid-cycle...Take the front kickplate off and see if you have power at the makeup box...you will need an electrical meter to check that...if there is power there then you have ... Dishwashers

Bosch logixx dishwasher tripping the power out! HELP!!!!


... Dishwashers

Kenmore dishwasher model #665.16039401 no lights, no power, breaker is not tripped? Any suggestions? There is some water in the bottom of the dishwasher, like it stopped mid cycle?


... Kenmore 24 in. 16039 Built-in Dishwasher

I have a Frigidaire FDB1100...I have no power to the dishwasher. I've checked the breakers and none of them have been tripped. Not sure where the plug actually goes to but I have checked the power cord and it's tight which means that it's still plugged in...of course Frigidaire has no customer service on the weekend.


Same problem . i will check for line voltage in box under unit and then continuity to panel. have no schematic for LV troubleshoot ... Frigidaire Dishwashers

I need to reset my Kenmore Elite dishwasher 665 16919 front panel. Drain tube was blocked and the dishwasher shut down. Now there is no power to the front panel. No circuit breakers were tripped.


... Kenmore 16919 Built-in Dishwasher

Own a Frigidaire Dishwasher Model Number FDB4315LFSO and now after about 2 years suddenly the display will not light and function anything. Without pulling the power panel off the whole line circuit seems to have power as they have my disposal unit tied into same electric line and that runs and so does everything else and no breaker is tripped. Is their a reset somewhere to check or any ideas what can casue the display panel not to function any commands at all. Nick


... Dishwashers

Whirlpool ADP5550 causes electrical points to trip safety switch. have confirmed it is definately located to the dishwasher being turned on - at the dishwasher not the power point. Will I need a whirlpool technician (& how to find one locally) or electrician? TE


... Whirlpool Dishwashers

Bosch SHV 4300 Dishwasher stopped in mid cycle Power Lights now don't come on No Power Will not run. Main fuse in electrical box not tripped.


... Bosch Dishwashers

No Power Hi Timon90, I used the dishwasher like normal yesterday today I went to use it and there is no power at all. I have checked our electricity box and none of the switches are tripped. I have put the door in as hard as I can and have checked whether the electricity plug has been pulled out by accident. Can you suggest anything or should I call a serviceman. Thanks from Julie


Remove the door skin dont forget the two screws under the door in the middle,the control panel will lift off remove the power board(unclicks)remove the plastic case and see if its blown.But first also remove the lower kick plate at the front and chec ... Asko 24 in. D3350 Dishwasher

My dishwasher tripps out when it is plugged in, how can it be resolved? ----- when i plug the dishwasher into the socket, it cuts the power supply to some electrical points around the house. It trips out a switch in the electrical terminal box, what can i do about this?


There is a shorted component in the dishwasher that must be found and repaired. Requires hands on troubleshooting.Eric ... Dishwashers

Smeg e2 error (water level tripped). Filter is clean and no rubbish below filter on inside of dishwasher. I have taken the front panel off but am not sure where the float device is located - I am wondering if it is just to the left of what looks like a solenoid. There is no water in the base of the unit in the front panel so would rule out any leaks. Reset program and turned off power at socket but still not using hot water. Possible PCB issue ? Any advice appreciated. Smeg DI612C Dishwasher.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1351 seconds