Having problems with your Dishwashers ?

Westinghouse Silhouette 906 dishwasher cuts out after pre-wash, sometimes goes through cycle to rinse, then cuts out. Obtained service from sole dishwasher technician in Ballarat - he was very discourteous, claimed to have corrected fault, charged $125.00. Fault not fixed - that was many months ago but don't want him back. Please advise


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Westinghouse Silhouette 906 dishwasher cuts out after pre-wash, sometimes goes through cycle to rinse, then cuts out. Obtained service from sole dishwasher technician in Ballarat - he was very discourteous, claimed to have corrected fault, charged $125.00. Fault not fixed - that was many months ago but don't want him back. Please advise


... Dishwashers

KUDS30IXBL My dishwasher stops mid cycle. Technician said it was too many suds and cutting off. I use cascade and jet dry and nothing else. There has been no other soap in the dishwasher. After it cuts off on normal (soap dispensed) I restart on light/china with no detergent. Sometimes it runs through with no problem and sometimes it stops with all lights off. Any suggestions? I have already had technician out twice for other problems with this dishwasher that is only 2 years old and don


... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

I have a JennAire jdb1090aws dishwasher. It's about 4 years old. The symptom is no water flowing through dishwasher. Approx 3 months after installation, the same symptom occurred. Tech resolved with float switch adjustment (no charge). Has run fine every since. I have not checked water supply, but doubt this is the problem (new water heater 3 months ago, sediment gone). I suspect the float switch is bad or out of adjustment. How do I trouble shoot float switch in dishwasher? Connect ohm mete


Hi,The procedure to test the float switch :-http://www.partselect.com/dishwasher+test-float-switch+repair.htmMost for no water entering the dishwasher, there are 2 main causes. One is the float switch and the other ... Jenn-Air 24 in. JDB1100AW Built-in Dishwasher

Our KitchenAid KUDS011JBS1 dishwasher sometimes leaks water on our kitchen floor. It seems to drip from the bottom edge of the door onto the floor. It's not a huge amount of water, but is enough to be a concern... it leaves a small puddle on the floor. What should I check and how do I fix this? I'm hoping it's an inexpensive and easy fix. Note that we've had this dishwasher for 8 years and have only noticed leaking during the past 6 months.


... Dishwashers

I have a Kenmore Elite Dishwasher about 7 years old. The Model # is 665-16462300. It works beautifully, except that about every 2 months the spray flow intensity ( and the cleanliness of the dishes) drops significantly. The cause is the metal screen located just upstream from the sump is clogged with food particles. I have taken apart the dishwasher several times to remove, clean and replace the screen. This fix works for about 2 months, then another cleaning is required, even though we h


... Kenmore Dishwashers

I have a Viking dishwasher made by Asko. It is less than 6 months old. Today I had a problem with my disposal (water not draining through it and leaking under the sink) and ran the dishwasher, which cleaned/dried the dishes fine. BUT, since the water was not properly draining from the disposal, apparently the dishwasher was not draining properly either. A repairman came to fix the disposal before I knew about the dishwasher issue. Now, the dishwasher won't turn off "draining mode" - button pu


... Viking DFUD042 Built-in Dishwasher

There's a foul smell coming from the dishwasher evert time I open it. Doing a wash does not solve this. I'v had this since it was new, months ago, and have had the installer look at it, said it wasn't his problem. Had a tech. come in and said it wasn't his problem. I've owned many dishwashers and never has it had a foul smell. Last fall I went to Nova Scotia, ran the dishwasher before I left, came back in two weeks and noticied water was still in the bottom of the dishwasher-it didn't drain all


... Frigidaire FGHD2433K 24 in Builtin Dishwasher

I have a Kenmore Elite Dishwasher about 7... Problem with the Kenmore Dishwashers I have a Kenmore Elite Dishwasher about 7 years old. The Model # is 665-16462300. It works beautifully, except that about every 2 months the spray flow intensity ( and the cleanliness of the dishes) drops significantly. The cause is the metal screen located just upstream from the sump is clogged with food particles. I have taken apart the dishwasher several times to remove, clean and replace the screen. This fix wo


Check the inlet hoses; if the catch screens have sediment build up, that will reduce the pressure of the rinse water. Also, look for missing plugs on the rinse arms... ... Kenmore 24 in. 16462 / 16464 / 16469 Built-in Dishwasher

My Fisher and paykel dishwasher drawers are showing a F1 fault on the top drawer screen, But it was the bottom drawer that was in use at the time of the fault occured. The top drawer will open but the bottom drawer is locked. I need to unlock this drawer to get my cooking equpiment out. Please Help. I know that the F1 fault is a flood fault but how do fix it.


... Fisher and Paykel Dishwashers

Ther's a foul smell coming from the dishwasher evert time I open it. Doing a wash does not solve this. I'v had this since it was new, months ago, and have had the installer look at it, said it wasn't his problem. Had a tech. come in and said it wasn't his problem. I've owned many dishwashers and never has it had a foul smell. Last fall I went to Nova Scotia, ran the dishwasher before I left, came back in two weeks and noticied water was still in the bottom of the dishwasher-it didn't drain all t


... Frigidaire FGHD2433K 24 in Builtin Dishwasher

Whirlpool Dishwasher ADG 450. Start as normal and it keeps intermittentlly stopping and starting. Washs / drains fine, but sometimes cycle seams to last for a couple of hours. I think it is four beeps when it is stopping and then immediately starts again. We had a problem months ago where as the sink was draining into the dishwasher out pipe, so dishwasher wasn't draining / filling up. Fixed the problem by turning the pipe the other way so water couldn't flow that way - but I don't know if that


... Dishwashers

I have a DS605 and DD605, F1 fault comes up everytime I try to cut the dishwasher on also water will emerge in it and the impleller floats up under the rack on the top dishwasher. Both dishwasher comes on the same time and make noise and the F1 with a little rench shows up. They said when the red light comes on the salt reservoir is empty. What kind of salt do I put in.Please advise


... Fisher and Paykel DD605HSS 23 in. Built-in Dishwasher

Viking professional dishwasher DFUD142 panel lights flashing, and cannot turn of pump, need to cut power, will not go on? worked perfectly 4 yrs. what to do? repair man did not fix.


... Viking DFUD142 Built-in Dishwasher

Beko Slimline Dishwasher DE2541FW - Eratic Behaviour & Programme Failure (also filling problems)


Location UK? Do not use tabs please. Only loose powder is best.I have seen so many dishwashers fail because of wrong detergent. You need a new control board. Or microprocessor board you say in the UK? ... Beko Dishwashers

Hi, I have not use my GE dishwasher for over six months now. I just turned it on yesterday and discovered that the dishwasher will fill the water but then it does not go to the next step. I tried different dial cycle and nothing happens. I suspect there is an issue with the timer? What should I do to fix this problem? Thank you


The heating element has gone more than likely, check condition £25 to replace ... Dishwashers

A11 Fault I have a A11 fault code on my dishwasher how do i fix this


A 11 is a heater problem. It is given a certain amount of time to reach the proper temp then the fault code A 11 comes on. The heat element may not be working. If you select no heat (if available) it may not show the fault. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have tried many many dish soaps and rinse products. I paid 800 dollars for this dishwasher a month ago. And every time I use it, the dishes have food specks still on the dishes, and the water glasses all have spots no matter what soap or rinse products I have tried. i am at my wits end.rnwhat can be doing this????


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Maytag MDB5100A Dishwasher

Dishlex global 450 _ how do i fix fill level time fault? displaying oF? Hi There, I have the above dishwasher and saw your advice on fixing fill levels - my display is showing the oF message and the pump to drain remains on whilst mains is connected. turning off mains does not clear message. holding eco button down does not clear message? is there anything else i should do in terms of removing parts to assist the process? I have cleaned out all of the drainage bowl and all is clear. i would pref


... Dishwashers

Hello i have a slimline beko de2431fw dishwasher and it will not fill up with water. None of the settings seem to alter the noise it makes which indicates there is power going to it. Any help please! I have had a dishwasher repair person look at it and i thought it was fixed but its not. He charged me £50 for nothing.


... Dishwashers

I have the 4000 Series AquaSurge with speed clean Professional series. I have a white film on the dishwasher and all dishes, glasses and silverware. The right bottom of the door always has a leak about the size of quarter. I have had several repairs and nothing has fixed it. It is 14 months old. How do I get it fixed?


I cannot understand Y this dishwasher does not have the dishes come out dry...I have tried every button and it still is not drying as it should. ... Frigidaire Dishwashers

Kenmore Dishwasher Model 665.11643300 Cycle will not run. Normal Wash light blinking Cancel light will also blink (but can be cancelled by holding button down) I tried shutting down the power and resetting at the breaker. I tried other buttons like Air Dry, etc to see if there was some sort of sequence Note* last cycle ran was rinse cycle many months ago - house has been vacant and dishwasher has not been in use.


I will look a bit further in detail about your dishwasher problem. I am assuming you have checked the inlet water tap to the dishwasher is turned on. ... Dishwashers

Leaking dishwasher leaks intermittently. I removed the side panels and there is no sign of water in the base of machine. Door seal seams to be intact. What else can I check. Seal that needs replacing? Machine is 18 months old. seams to leak on the right side of the machine. Please advise. many thanks. My dishwasher showed the error code either OE or E1, I think it was more OE. I stuck my hand in the filter in the bottom of the machine and then it was okay but the next time it was used it leake


What sort of soap powder do you use\015\012some soap powders foam a lot in machine causing dishwasher to leak through seals\015\012also check that the machine is square that is the door is closing parallel with cabinet\015\012do no ... Dishwashers

I have a kenwood dishwasher kdw12sl3a. It shows fault E3. It states in the manual that this fault means longer heating time but not reaching required temp and its a malfunction of temp. sensor or heating element. Is there anything I could do to fix it or will it have to be sent back.


Aye have same problem!? how did ya get it fixed if ya did thanks ... Dishwashers

Dishwasher Did you fix your dishwasher? Mine is doing exactly what you posted yours was doing last month. Mark


It ended up being a bad Control Board (or panel) which had to be replaced.  I tried all of the other solutions online;  push this button twice, then that button 3 times --  sometimes its just easiest to call in the professionals.   ... Kenmore 24 in. 15079 Built-in Dishwasher

I noticed some leakage during operation of my 6 month old dishwasher. After pressing the cancel button, no water runs through the machine when I try to cut it on yet the machine itself cuts on. Please advise.


The circuitboard that runs the timer has possbly shorted out. This isn't something that can be replaced by a novice due to the cause of the shortage may damage the new circuit. I would suggest if the unit is under warranty to have them come out and ... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1722 seconds