Having problems with your Dishwashers ?

Zanussi DES 959 - AL5 warning keeps coming up indicating either the filters are blocked or there is no water coming in. Filters are clear and there is water coming in - what next?


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Zanussi DES 959 - AL5 warning keeps coming up indicating either the filters are blocked or there is no water coming in. Filters are clear and there is water coming in - what next?


... Dishwashers

Miele g977 inlet/drain light comes on: drain clear and working. Sound of pump indicates attempt to get water, it stops after a few seconds and light comes on. Filter in solenoid clear and pressure adequate


... Dishwashers

Water drainage I have followed the manual instructions for clearing all appropriate filters on the intake and outflow side but the cycle does not complete and leaves a pool of water in the base. What next? I have the G568/858 Plus Incognito unit (thisis the closest part # to my actual unit--can't even find teh right # listed...), and aI m dealing with the sme issue. I have followed all of the recommended steps in cleaning the filters, traps, etc. There are no kinked hoses. The water drains to b


YOU NEED TO REMOVE THE LOWER SPRAY ARM AND REMOVE THE SHELL THAT IS COVERING THE PUMP AND FOOD SHREDDER ,HERE IS WHERE YOU LOOK FOR A CLOG. ... Miele 24 in. G892SCU Plus Built-in Dishwasher

Sgs43t Water warning light coming on - water in filter and hose clear, drain pump/filters appear clear No water pooling in base!!


... Bosch Dishwashers

I have a Kitchen Aid KUDS03CTSS3 dishwasher. Dirty water is staying at the bottom and nothing comes out the drain hose during the entire cycle. The drain hose is looped above the kitchen P-trap, although for a time it wasn't. I use a wet vac to get the water out but there is still water below the fine filter. I thought if I could get the fine filter off, I could clean out the bottom as I think that it's full of crud down there that may be blocking things. I can't figure out how to get the l


Hi,Thanks for the follow up. I am glad it worked out for you. If I can Help in the future let me know. http://www.fixya.com/support/c64627-kitchen_aid ... KitchenAid 24 in. KUDP02FR Built-in Dishwasher

WP dishwasher seams that the water preasure has droped and the thing that the water comes out of and spins is spinning very slow and water only comes up about 1/2 of what it use to. We have took it apart to make sure there wasnt anything blocking it or clogging it up. what do we do next? Help


Water valve screen on dishwasher could be clogged up or you could have a bad water valve ... Whirlpool 24 in. DU920PW Built-In Dishwasher

I have a GE Profile, GSD4930X73WW, dishwasher. The upper wash arm is not spraying well at all. I checked the water line from the pump to the upper arm and it's fine. I cleared the filters and cleaned the float. I also took the inlet valve off and cleaned the screen. Although the washer works better overall, the upper arm still does not work well. Nothing appears to be in the upper arm assy to clog water from spraying out. All seems clear from the turbid sensor (next to the pump) through t


... GE Dishwashers

Dishwasher fdw60g fault lights i have the eco and prewash light flashing. i know that this means the filter is blocked. i have cleaned the filters and checked the hoses for blockages and they are all clear and kink free. i have tipped the machine on its side and checked the pump , which is clear aswel. i dont know what to try next to get the machine working and the lights to stop. thanks


... Dishwashers

I have a kenwood dishwasher KDW12ST3A. It is coming up with the code E4 and apears to be working but not emptying. I am assuming it is blocked. It mentions in the instruction manual that I have to ensure that the water outlet valve is open, however it does not discribe how to do this? can you explain how I should do this and best advise me how to unblock it. I have undone the filters and have not found anything, water is slowly coming out the outlet pipe in to a bowl. I broke a glass some months


... Dishwashers

My Miele G641 dishwasher indicator light 'inlet/outlet' is flashing and the programme does not continue. I've cleared the filter, the water line filter and all of the spinning arms and have 'increased the water intake time'.


The indicator light for 'inlet/outlet' reports that the water doesn't flow as it should be so either:1 - the intake valve is malfunctioning - since you aren't flooded it must be completely shut:      a - calcar deposits hav ... Miele 24 in. Novotronic G641 Plus Built-In Dishwasher

My Bosch dishwasaher model SGS53 has stopped working and has water in the bottom of it , i have cleared this and checked the small impeller for blockages - this is ok. i have also checked the water inlet filters and the drain tube is clear . I have the top and left sid panel of and when i lift the red rod it allows watrer to come in but stops if i release the rod thr lever in the base of the machine int which the red rod fits appears th be at its lowse level and therefore the red rod cannot be p


... Dishwashers

Model bfi680. tripped electric halfway through cycle. water left in bottom. cleared out water and checked filters - clear. Now program selection button not working either


... Hotpoint 23 in. BFI68 Built-in Dishwasher

Hi I have a Bosch dishwasher model SGS43T72GB/09. It has been working normally until lunchtime today and we noticed water pouring out of the door. We emptied the water and realised that the fitler was blocked with grease. We have cleaned the filter and tried to reset it. There is no water in it but all three lights are on check water, active & end when we try to reset it. If we put it onto a cylce active light comes on and you can hear it doing something but its not filling with water. Can you


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a Bosch Diswasher that is not draining. I have disconnected power for 35 minustes and used shop vac to excess water out of drain line. i also pulled all water thru the drain line from the tub itself. i assume that because i could pull the water, all baffles and lines are clear as i emptied the tub from drain line. you can hear the pump come on to drain water but no water is moving. What would be my next step. If it is to replace the pump, how do i easiest access the pump to remove and rep


Either the selector switch or pump is faulty. If there is not any clogs anyways. The system may need to be reset. Most resets are done by entering a series of numbers on the touch pad to enter diagnostic/test mode where the machine can be reset. This ... Dishwashers

Our bosch dishwasher runs but no water is spraying on the inside. Is there a water filter clean out or is there a water pump that might be broken? I checked the line coming in and it isn't plugged. I made sure where the stainless line goes into the electric valve that it wasn't plugged to that point. I could see anywhere else to check if it was plugged. I figure there has to be a water pump, but I guess I'm not sure of that either. Thanks for any help..


Hi, welcome to Fixya. \015\012 \015\012By the description you've provided, it sound's like the wash motor is either seized or just stuck, let's hope it's the later. \015\012 \015\012Bosch had issued a service tip about this ... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher

My Bosch Classixx (about 10 years old) dishwasher won't fill The problem has only started since I pulled it out and cleaned! The programme sounds are as normal but no water enters the machine. I detected a small leak on the inlet pipe and tightened that. The machine drains when I add water manually though it has made a lot of gurgling noises for some time now when draining. When tipped on its side water comes out of the bottom of the machine (not entirely clear but not dirty either). When upri


... Bosch SHU9915UC Dishwasher

We have a Siemens Extraklasse Hydrosensor dishwasher that is not letting any water in. It switches on and the filters have been cleared but there is no water coming in. It will drain away water. Please can you help?


... Dishwashers

Kitchenaid dishwasher - small pieces of food are left on otherwise clean dishes. Water level comes to about 1 inch below heater coil. I ran it without dishes (or soap) and added about a quart of water so that level came to about 1/4 inch below heater and that's when I noticed food pieces on drain surfaces (nylon filter under bottom spray arm unit and circular plastic "trap" surrounding it). Spray arms holes are clear and water is hot.


It sounds as if you figured the solution out. The holes in the spray arm(s) get plugged by small debris, (tooth picks, seeds, bits of plastic like candy wrappers, etc) and the water does not reach the dishes to wash and rinse effective ... Dishwashers

My siemens dishwasher has the water tap indicator light on when washing starts. i have cleaned the water filter and the spray arm but the light doesnt go off and the washing doesnt take place. Instead i can just see water coming into the drain in intervals. what do i do?


... Siemens Dishwashers

The check water supply indicator is alight. I have checked the incoming supply and this is ok, the filter is not blocked. If I try to run the dishwasher I just end up with water at the bottom of the machine and the programm will not progress any farther.


My phone has frized and i forgot the pasword ... Neff 24 in. S5555X0GB Built-in Dishwasher

This is the 2nd time I've had problems with my dish drawer. After I cleaned the filter and replaced it, I had standing water on the bottom of the drawer. The last time this happened, I had someone come to repair it - ended up it was me. I didn't put it together properly. This time I did the same thing I was told to do. I still have the standing water. What should I do. By the way, the coils are not kinked in the back either. Can you please give me some advice? Please respond to me at F


Unfortunately I have to respond to you through this post per policy of fixya.com. This s to ensure we have a visibility on the quality of the solution and also allow other consultants to help if necessary.\015\012\015\012Water standing a ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Smeg diswasher model numbe4r DF612SDX. Just coming up for two years old, various codes re error messages. E2, E5, E8. We have taken off the front panel where the buttons are - nothing obvious. We have taken the bottom off and tried to locate a reset button, but can't find one. We have cleared all the filters inside and checked the water intake and the filter there. Out of ideas, can anybody else suggest what we can try?


Any signs or sounds on the machine you here when the problem occur? ... Dishwashers

Westinghouse 921dishwasher Fault FL comes up through cycle, removed hammer resistor because it was blocked. Have good water flow but still comes up with fault. Checked and cleaned all filters, is there a over ride or am i missing something else. Cheers


... Amana 24 in. DWA33A Built-in Dishwasher

Havnt used my dishwasher in 2 years on account of saving water. now when i push the start button some water flow into machine for a few minutes and then just stops. manual says to clean filters and drain pump but all clear. what is next plan of action?


Try pouring water from a bucket through the front. maintain the level. It should not overflow.Run a empty cycle. If there is a air block it will get cleared. ... Asko 24 in. D3120 Dishwasher

I have a GE monogram zbd5900 that continues to drain, won't shut off. The drain pump just runs. None of the lights on the control panel will come on, tried pressing and holding buttons to clear, nothing. Turned off and on circuit breaker (even left it off overnight) and did not change. Drain is not blocked, pulled the unit out and put water in the bottom and it pumped the water out just fine. any thoughts?


See if you can access the tech sheet, should be on the right side of the underside of the unit after you remove the toe panel, or perhaps in the console. Almost sounds like a stuck key pad but the tech sheet might shed more information on this malf ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1908 seconds