Having problems with your Dishwashers ?

Kenmore Elite Ultra Wash Dishwasher 665 1343 leaks intermittently from bottom of control panel

\015 Using Smart Wash Cycle with Heated Dry option turned OFF. No other options selected. Starts to leak about half way through cycle, generally water leaks down the face of the dishwasher. Can't really determine where the water is coming from. Tried tightening the screws on the door, but it did not stop the leaking. Appears to be coming from the vent on the front of the door, just below the control panel.\015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore Elite Ultra Wash Dishwasher 665 1343 leaks intermittently from bottom of control panel


... Dishwashers

I have a Kenmore Elite Ultra Wash HE. Model #66513122K701. Serial #FY0310281. Purchased New 1/31/09. It only works for a full wash cycle on on 1 hour wash. Super Wash and Normal wash both stop mid cycle and leave dishes sopping, dipping wet and with green light blinking. Been doing this almost its entire life...has ahd control panel replaced once under warranty...but if it is a factory defect...they probably just repaced it with another defective part...what to do? What should I do.


... Kenmore Dishwashers

I have a Kenmore elite ultrawash HE dishwasher Model 665.13129K700 , serial # FU3801153 , Stock # 13129K , Type 586-0. My normal wash red light flashed constantly and will not allow me to reset the control panel. I disconnect power for 1 hour then it allowed me to run 1 cycle. Upon completion the normal wash red light started flashing again. I tried to toggle between high temp wash and heated dry but no other button will work since normal wash is flashing. I again disconnected power but this tim


Hi,Push push thishi temp wash / heated dry hi temp wash / heated dry hi temp wash / heated dryIf this does not reset the control then you will need to replace the control board.Let me know,if needed fur ... Dishwashers

I have a Kenmore Elite Ultra Wash dishwasher. Model #17572. All the lights on the control panel went out. Get no response at all. Circuit breaker is fine. Any reset tips? Or, do I need a new control panel?


... Kenmore 24 in. 17572 Built-in Dishwasher

Kenmore Elite Ultra Wash Dishwasher 665.1397 Nothing Working on Control Panel


... Kenmore Dishwashers

Has anyone else had the Kenmore elite ultra wash melt the rubber gasket running along the bottom of the dishwasher frame in the front? It is not leaking yet.


... Kenmore Dishwashers

My kenmore elite ultra wash dishwasher flashing start button 1 hr light on. And control lock flashes but does not run just beeps


... Kenmore 24 in. 16059 Built-in Dishwasher

Control panel not working - Kenmore 24 in. Elite Built-In Dishwasher w/ Ultra Wash Filtration


... Kenmore 24 in. Elite Built-In Dishwasher w/ Ultra Wash Filtration

Recently replaced the control board for Electrolux EIDW6105GW1; after nearly a month of working w/o any problems this evening the machine made it through the wash cycle and then stopped working (all lights on wash cycle door menu are flashing). Took kick plate off bottom to check control board and the leak dectector is lit. I can see no leaks in front and am reluctant to do anything else with this POS. I spent nearly $1000 on this 18 months ago and have already sunk over $300 into a new contr


... Electrolux EIDW6105GW 24 in. Built-in Dishwasher

I have a Kenmore Elite Dishwasher Model 665.13773K600. It seems to have no power to the touch pad (top) control panel. I have already checked the circuit breaker and the power to the dishwasher. A friend said that it may perhaps be the thermo fuse cut out that needs to be replaced. 1) Is this true? 2) How can I remove the 1" thick control panel touch pad after removing the six screws- it seems to be stuck, and I don't want to break the plastic touchpad.


... Kenmore Dishwashers

Control Panel won't let me hit the start button. The dishwasher is a little over a year old and is used at most once a week. The blue light on the bottom right of the dishwasher seems to no longer light up. The control panel will let me select the wash, but the start button and time indicator does not light up. Not sure if this a real defect and if just a simple exchange of the front control panel will fix the problem? Already tried resetting the circuit breaker and that did not help. Than


... Dacor Epicure ED24 Stainless Steel Builtin Dishwasher

Water in bottom of kenmore elite ultra wash dishwasher


You must check the filters that are at the bottom under the spray armthen you must start and then hold down cancel or stop and it should kick in the automatic water discharge mode and activate the water pump if this does not work you need new dis ... Kenmore Dishwashers

I have a Sears Kenmore Elite Ultra dishwasher 665.1315 model. For the last 3 weeks, it keeps having the clean light blinking 6 times pause then 1 blink and pause and repeats cycle again. I have turned off the breaker...I have reset by pressing the heated dry and normal wash until all lights are flashing. It then completes some type of cycle and looks ok. When I opened the door, steam came out and all was hot inside. However, once I try any new wash cycle, it seems to wash but after 1-2 hours and


Call sears service and tell them you need service there is a service flash and will be no charge ... Kenmore 24 in. 15932 Built-in Dishwasher

Quit working during wash cycle, about 6 liters of water left in bottom, looks like it quit during rinse cycle. There is power to the door switch and door switch works shutting off power when door is opened. However the control panel does not respond to any push button. I have had a problem in the past with moisture from the door vent getting into the control panel area causing the push buttons to become eratic.


The capacitors in the control panel could be bad or have burnt out. Do check all connnections and if necessary, check the continuity of the power to and from the control panel with an ohm/voltmeter. ... Dishwashers

Kenmore Model Ultra Wash Model 665- 45955 Problem: Dish washer leaks at bottom intitially during sudding cycle only...first 5-10 min... then no leaks/drips thereafter thru balance of clean/rise cycle. Whats up....Thought possible seak around washer door is bad but no leaks at bottom or elsewhere after the sudding cycle is completed. Please provide complete resolution reply if possible Tx


Hi\015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If you have water leaks around the base of your dishwasher,\015\012you may be using a detergent that is causing too much suds. Cut ... Kenmore Dishwashers

Indesit DI620 1 Switched on and programe 1 set but nothing happens. Water supply OK 2 Have taken the door panel off and there is a black and black/purple thin cable connected to the control panel in the bottom right hand corner with the other hand hanging loose. Don't know where it connects to. Any suggestions please


... Dishwashers

I have a Kenmore Quiet Guard Ultra Wash and the lights on control panel are blinking green. It's the Smart Wash, Normal Wash and Light Wash lights that are blinking green. Dishwasher won't sta


... Dishwashers

Leaking dishwasher leaks intermittently. I removed the side panels and there is no sign of water in the base of machine. Door seal seams to be intact. What else can I check. Seal that needs replacing? Machine is 18 months old. seams to leak on the right side of the machine. Please advise. many thanks. My dishwasher showed the error code either OE or E1, I think it was more OE. I stuck my hand in the filter in the bottom of the machine and then it was okay but the next time it was used it leake


What sort of soap powder do you use\015\012some soap powders foam a lot in machine causing dishwasher to leak through seals\015\012also check that the machine is square that is the door is closing parallel with cabinet\015\012do no ... Dishwashers

Reset control panel on Kenmore ultra wash dishwasher 665.17822


... Kenmore Dishwashers

Kenmore elite ultra wash quiet control error 8-1


... Kenmore Dishwashers

I have a ge dishwasher model GSD5211 purchased in may 2006. Water appears to be dripping from under the front ss panel to the bottom of thepanel. I cannot open it to check the source of the leak. Alo found that the leak occurs midway of the washing complete cycle. It also seems that the leak during a particular cycle. Not sure which as just two indicator lights stay on thepots and pans and heated dry. Please help


You may want to inspect the seal around the door to make sure it's not worn out or has some foreign material stuck to it causing it to not make a watertight seal during operation. If you don't see any problems there, then you should pull the machine ... Dishwashers

Dishwasher leaking Our dishwasher all of a sudden started leaking. I've taken the front panel off the door and can see exactly where. It's not a hole or anything...it's at the front, left edge of the basin, the bottom left corner at the front. It seems that right after it fills with water, it starts to leak once water is moving around inside and washing cycle starts. It is as if big waves are being pushed to the front left corner and over the lip of the basin. I don't think the water level is to


Just an idea...if i'm understanding you correctly,could the door seal be creased there or folded over by use and age to permit this to happen? cause you said nothing is missing ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Kenmore dishwasher ultra was quiet guard 3 model 56516012403 control panel will not activate red lights blinking on normal wash and cancel drain. did the hold the heat dry button then the normal wash button, it stopped the blinking but the dishwasher will not engage when you push any button


That would be model # 66516012403 correct??you may have inadvertently set the lock on function.. check this out from your manual...Lock OnUse the Lock On to prevent unintended use of the dishwasherbetween cycles. Y ... Kenmore 15912 Built-in Dishwasher

My Kenmore under counter ultra wash dishwasher model 665.15825691 has started leaking at the lower corners of the door. The leaks seem to occur during the final rinse while the water is being heated. I have tried cleaning out the door bottom and the tub edge where the door and tub interlock. There is no gasket in this area.


Happened on my dish washer too. Remove lower rack, remove lower spray arm by removing the center plastic nut, check screws (torx) on outside edge of pump. Tighten these as necessary, mine were loose causing water to spray forward against the tub c ... Kenmore Dishwashers

I have the kenmore elite ultra wash dishwasher. The model is 665.1375. It seems that when I add the liquid for the jet dry finish we have a leak from under the unit to the kitchen floor after the wash. Hmmmm....


... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1306 seconds