Having problems with your Pressure Washers ?

Landa 3000 pressure washers surging - Pressure Washers


Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Landa 3000 pressure washers surging - Pressure Washers


... Pressure Washers

I have an older Landa Pressure Washer. The burner is not working. Once I get the machine running and water flowing to the pressure washer, with the wand pressed, I flip the burner on switch....and nothing...I have no idea how to work on a pressure washer burner. I have been told it could be the igniter, but I don't know how to fix it if it is. Any help is appreciated.


Check for 12V at the igniter connector with the unit running. If you have 12V and no igniter it may be stuck or bad. Thrun the unit off and read continuity across the DISCONNECTED igniter plug / terminals to the igniter. No resistance = open ignit ... Pressure Washers

Low pressure in pressure washer - Honda Landa PG 3500 PSI Pressure Washer


... Honda Landa PG 3500 PSI Pressure Washer

I have a karcher pressure washer 1800 psi i bought from walmart it was running good until i had a power surge with the plug in. what can i do can i change the fuse in the plug or do i have to open the pressure washer up and replace a fuse.... thanks


You will have to take the cover off & look for melted wires or a fuse.\015\012if there is no fuse the capacitor may have been cooked.\015\012it should be a white cylinder.if it has been damaged it will have burn marks and may be swollen. ... Karcher PSI Electric Pressure Washer

Pressure washer surges - Generac 2700 PSI 2.3 GPM Gas Pressure Washer Non CA


This could be your unloader valve taking in account the engine isn't surging. Does the engine run smooth? Do you have at least 50 psi water pressure feeding the pump? Inlet screen clogged? ALL tips act same way or no change? ... Generac 2700 PSI 2.3 GPM Gas Pressure Washer Non CA

I have had 3 Karcher pressure washers all experience the same problem and so have two of my neighbors. Our area has very hard water and it causes problems with the washer not bringing up the pressure when the trigger is pulled (or surges up and down) and the nozzles clogging, etc. The service repair facilities cannot tell me how to prevent this. Many attempts to contact Karcher for advice have been ignored. I have been thinking that perhaps running the engine for a few seconds with no hoses a


If your water is that hard (and it appears it is) WD40 will NOT solve the problem. You should look into a water softener. However, chances are that a small, inexpensive model will not have the flow capacity required for a pressure washer. You'll like ... Karcher K2.26 Electric Power Washer

Honda pressure washer model # exhp3640-1 3600psi 0=13hp has low water pressure out of triggers motor does not engage for higher pressure


... Pressure Washers

I have a G2500VH pressure washer that has started to pulse when the trigger is squeezed. This happens if I use the 0,25, and 40 degree nozzles BUT if I use the one for low pressure(detergent use) it will hold pressure fine. I have changed the unloader valve, checked all the valves and seals ad they seem to be fine. What could be the problem?


Do you mean pressure on and off with the hp tips and smooth and steady with chemical tip? ... Pressure Washers

11 hp honda motor on landa cold water pressure washer runs good except when trying to pressure wash the motor & pressure go up & down pulsating bbruummmmmbbbbrrruummmmbbbrruuummmmwhats the problem and how to fix it?


... Honda Landa PG 3500 PSI Pressure Washer

Electric Karcher pressure washer surging when turned on


Dear firenutt681,\015\012One simple thing you can do, is to check for leaks. Check if hose at machine is leaking. Check gun if it is leaking. You can also check if water still comes out of lance nozzel. These leaks however so small, will cau ... Karcher K2.26 Electric Power Washer

Landa pressure washer manuals


Send them an email at [email protected] or contact them directly at 800-526-3248 for more info specific to your model which was not listed above. hope this helps you ... Heavy Duty Pressure Washers

Landa pressure washer LT 4035-4000 psi. Why is it losing pressure and continually pulsating?


If the pump is pulsating rapidly most likely valves are leaking or debris under valve keeping one or more from closing. If the pump pulsates slowly, comes up to pressure then low pressure then repeats, problem is pressure regulator /bypass. Or you ... Pressure Washers

I have a Karcher G2600 OR Pressure Washer, 2600 psi, 2.5 gpm. PN 1.194 506 0. gas engine works fine and water flows fine but pump is not adding pressure to stream. Checked and cleaned inlet water filter.


... Pressure Washers

Landa 3500 wont run. backfires. - Honda Landa PG 3500 PSI Pressure Washer


... Honda Landa PG 3500 PSI Pressure Washer

Can you adjust the water pressure on a 13hp. landa pressure washer


... Honda Landa PG 3500 PSI Pressure Washer

I have used the McCulloch (FH180A) three times over the course of two years. On my fourth use the pressure washer just surged on and off and I would get a tiny spray from the gun each time it surged. In other words it would do nothing. Please help... very frustrated. Thanks


Sounds like the problem could be low input water flow or pressure. There could be crud on the intake where you hook up the garden hose, there could be some other sort of blockage. Try hooking it up to the hose and pull the trigger (with the po ... McCulloch FH180A Electric Pressure Washer

Pressure surges up and down? - Karcher G 2600 VH Gas Pressure Washer


You need to expel all of the air that has ran through the supply hose and into the pump. Do this without the machine running. Squeeze the trigger and let the water run through the machine for 30 seconds or until all the air has bled through. You can ... Karcher G 2600 VH Gas Pressure Washer

Vng 3-1100 manual for Landa pressure washer


... Pressure Washers

Landa pressure washer


... Pressure Washers

Karcher Power Washer that surges up and down with water pressure.


Before you start it up:\015\012\015\0121. Disconnect the high pressure hose\015\0122. Connect the water supply and turn on\015\0123. Make sure water is flowing through the pump\015\012\015\012Start the motor, run for about 10 seconds and ... Karcher 2500 PSI Pressure Washer

Pressure washer surging


... Karcher G 3050 OH

Landa high pressure washer pump modle # lg3030g


... Honda Landa PG 3500 PSI Pressure Washer

Landa high pressure washer model LG3030G


... Honda Landa PG 3500 PSI Pressure Washer

The power washer is surging cuting in and out when i turn da nozzele to get stronger water pressure?


When I use my machine I hook up the water to the pump, hook up the high pressure line and gun, then turn on the water full and squeeze the triger to make sure all air is out before starting the pressure washer(mine is gasoline powered). Then I insta ... Pressure Washers

I have a karcher K3.98 pressure washer. The unit surges when I put the wand on and then it stops working. I tried cleaning the wand (didn't make any difference) I then tried another wand from my son's unit (still didn't work)I am wondering if the unit is worn out or can you suggest what is wrong? Thanks [email protected]


Dear davedulmage,\015\012To see if the unit is OK....first you must switch it on without water and without high pressure hose and gun. If machinr works smoothly, try by attaching a water supply. Now run the pump with water coming out of the o ... Karcher Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0571 seconds