Having problems with your Bwd 129 hotpoint ?

When closes door it fuses the mains

Full of water door closes then fuses

Answers :

Repair Help & Product Troubleshooting for Bwd 129 hotpoint

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hotpoint FDW80P dishwasher trips fuse box when the door closes and before this when it was on the dry cycle


... Hotpoint Dishwashers

My Ariston LI 62 Dishwasher keep tripping the main fuse board when door is closed


... Ariston Technologies Dishwashers

HI THERE MY HOTPOINT FDL570G HAS A BIT OF A PROBLEM IN THAT WHEN I CLOSE THE DOOR IT TRIPS OUT THE RCD SWITCH ON THE MAINS BOARD. HOWEVER IF THE DOOR IS CLOSED AND I SWITCH THE TRIP SWITCH ON THE MAINS BOARD BACK ON THE DISHWASHER WORKS FINE!!!


... Dishwashers

I have a frigidaire FDB1050REC0 dishwasher that is working fine most of the time. Sometimes about 40 percent of the time, when we open the main door after it is finished with a normal cycle, we find a big clump of detergent left in the main detergent compartment and the detergent door is open. It is like the detergent is getting wet with the detergent door closed and then when it is supposed to open, the detergent is wet and clumps. We switched to liquid detergent and the same thing is happening


... Frigidaire Dishwashers

Kitchen circut was accidently turned off. Now whirlpool gold disher will not work(unit was not running and the door was not closed all the way when circuit was turned off, All circuit breakers are on) There are no lights on display when door is closed completely, and it appears to have no power. Worked fine prior, what could it be? The unit has not been removed from under the counter yet. Is there a fuse or circuit breaker on the unit? If so where is it located? Other troubleshooting ideas


Hello- Turn power off. Remove kick panel and cover for power wires. Check connections. If these are ok, most likely suspect is a fuse at the control. This is a little harder to get to. Remove inside door panel screws. Unplug wires and remove panel. F ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Maytag model mdbtt70aww. After the end cycle. open the door and found detergent tab on the bottom and the main wash cover is opened. Maytag diswasher model MDBTT70AWW. Put dishes and so forth in the dishwasher. Put detergent tab and jet-dry rinse agent in the pre-wash section. and close the cover. Start wash cycle after done over door and found the detergent tab on the bottom new the heater. The cover to the main wash is opened. Dishes are are clean. Wish someone would tell me


... Dishwashers

We have a 6 year old Jenn Air dishwasher model JDB2150AWP We had a cracked door close unit which we replaced but got a short while restoring connections I am wondering if there is an internal circuit breaker, relay or fuse on these machines that we need to check and possibly replace since we cannot get it to run at all. No power or lights at all. I believe all connections are secure and we replaced the door close unit with new parts.


... Jenn-Air 24 in. JDB2150AWP Built-in Dishwasher

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

The door will not close. It appears that the lock is in the closed position and will not allow the catch to close fully and engage. The m/c is mid cycle so I have switched off at the main socket


Check for obstructions, Check the door \015\012latch the latch may have moved into its housing,use a screw and position the door latch properly free from any obstruction,then try closing the door again..if not then you may need to ... Neff Dishwashers

My wife opened door during cycle. When she closed door it would no longer run. Looking at problems and recomendations on similar models, I replaced the board. Did not fix the problem. I have checked the fuse and the door switches for continuity and all seem ok. The only lights on the panel that come on are: under cycle- Pots & Pans, Light. Under Options - Heated dry. No other lights work and the dishwasher does not operate.


Hi,\015\012\015\012First off, sorry to hear that you replaced the control board for nothing..in hindsight. So if I understand what you're saying is this, You cannot select any cycles and the unit won't start...because the start button is ... Dishwashers

The detergent dispenser [Main Wash] door doesn't stay closed. It seems like there is something wrong with the latch, but we can't what. We've cleaned it, but don't know what else to try. There don't seem to be pieces missing or broken. But no matter what, when we put in the detergent [we use the cubes] the door always just pops open and the detergent ends up falling to the bottom on the dishwasher. The dishes are still getting relatively clean, but we want to solve the problem with the door


... Frigidaire FDB1200RG 24 in. Built-in Dishwasher

When on/off button de-selected large flash from top of door. Main consumer unit tripped and fuse in plug found ruptured. Fuse replaced cb reset but dishwasher has no power. Fuse rechecked found to be good.


Dishwasher stripped down and found MAIN WIRING HARNESS chaffed agains door during opening and closing. New loom in region of £100 so repared old loom. ... Dishwashers

Pump starts as soon as main switch is turned on, even with door open. Also does not even try to fill. Does count down if you close the door and let it run but no water so no effect. I am guessing control board or anti-flood? Thanks


Is your door switch defective,that will cause same symptoms ... Bosch 24 in. SGV57T03GB Built-In Dishwasher

Model KUDI24SEWH2 - the dishwasher was operating, I opened the door to add another dish. When I closed the door, there was a small click and nothing happened. The lights indicated to me there was rinsing and drying going on, but in reality, nothing happened.rn We were told it might be the thermal fuse, but have just check that and it is fine. It will fill, just not pump or drain. Any help?


... KitchenAid Dishwashers

Electrolux ESL 63010 dishwasher. This worked fine until the door catch broke. I replaced the catch but could not remember which way round the two electrical leads went (red and black). I tried both ways with the same result. The lights come on the control panel and I can change the programme, but on closing the door the house fuses blow. I have checked the earth cable is fine. Any ideas?


Red - is active powerblack - ground or neutral ... Electrolux Dishwashers

I have an Indesit DV62WHUK dishwasher and the last night the door made a banging sound when it was opened and now it won't close and will fall back under it's own weight. I suspect either a spring, spring cable or a hinge has broken. How do I check this? Is the spring mechanism in the door or main unit?


There is a plastic unit behind the door handle which houses a spring under tension. This latches the door closed and makes the electrical connection to allow the machine to work properly. You need to buy a new unit (\302\24315) which is a bit fiddly ... Indesit 23 in. DV62 IX Built-in Dishwasher

I have a whirlpool portable dishwasher model # dp940pwpq2. I think it stopped working in middle of cycle has standing water in bottom no power to front control unit door seems to close and latch properly, not sure if it's door switch or control s thermal fuse doesn't look bad any ideas?


... Whirlpool DP940PWSQ Free-Standing Dishwasher

AEG Diswasher Model / Favorit 44080IM PNC 911925601/01 (located in UK) Wash cycle finish light flashes 5 times in sequence then starts again - please advise the meaning of this error signal ? History Machine started running immediately door was closed before any programme selected filled with water and main was motor runs and circulates water Water is not heated and detergent door has not opened Machine will continue to circuluate water until turned off If reset used then


1 blink is machine is having major power supply problem.the power supply board needs replacement.\015\012-----------\015\0122 blink is CCU error.that control board problem.\015\012-----------------\015\0123 blink is the CT error.that is ... Dishwashers

IGNIS ADL 347 DISHWASHER I interupted a washing cycle by opening the door when I closed the door a repeating high pitched warning alarm started and the start light is flashing I have tried switching the machine off at the mains but no joy


Hi.The Ignis dishwasher does not need reset code. It will normally restart working after tripping the circuit breaker.If the machine is beeping, that means that the dishwasher is in fault mode because some fault condition is detected. Amo ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Hi, The machine will not complete a cycle. I think it may have started when the power was turned off at the mains during a cycle. Symptoms are : - You can turn machine on, select a program, press start button, close door, machine appears to begin cycle as normal, water seems to load, then 2 minutes later drains, and 1 minute or so after that the machine beeps 3 times to indicate cycle is finished. Dishwasher tablet door never opens, dishes not cleaned. Have tried : - cleaning filters; - turn


It is likely the dishwasher is locked in some diagnostic program.\015\012If you provide the dishwasher model no. then I can try to find out the keys you need to press to get it out from it. ... Whirlpool Dishwashers

Dishwasher - Bosche - SHV43A03GB - When the main power switch is ON, even with the door open the pump/motor continues to run (ie. Stop-cycle does not operate). However, the wash-program itself does not run, even with the door closed (ie. No water entering the dishwasher, even though water supply is on and feed lines are clear - not kinked). It is like the program is 'stuck' and I cannot seem to get it to reset.


Your door switch is likely faulty and should be replaced. You can get them at partselect.com ... Dishwashers

My kenmore dishwasher model #665.1359 just stopped working mid cycle. checked fuses in house door is closed all the way and still no power to the door. what do i do?


... Kenmore Dishwashers

I have an old ariston K LS 61 S - yesterday at the end of a cycle i could not get the door open! Tried doing another cycle and even turning off at the mains and back on again Door is firmly closed at the centre where the locking mechanism is


... Ariston Technologies Dishwashers

My Bosch dishwasher SGS45E02G BG GAS will not power on. I have checked fuses and the lcb has not tripped. Normally you close door and press button and red led comes on and program starts, but nothing. Can you help


... Bosch Dishwashers

No power on the main switch inside the door, checked the fuse in the plug changed with new and no success, we had 2 poss 3 power cuts yesterday but the dishwasher was not working at the time? christmas time help. not sure on the actual type as it was in the integrated kitchen when we moved in 2 years ago an no manuals.


Make sure there is power coming from the house panel by checking the breaker for the dishwasher. ... AEG 23 in. Favorit 50750Vi Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0547 seconds