Having problems with your Dishwashers ?

Cycle sticks

The cycle sticks midway thru the cycle. Control knob stops turning but dishwasher continues to run

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Fisher & Paykel single SS Dishdrawer. Cycle's stuck. Normally sticks at 137mins and 33 mins, has stuck on other times too but it's always on those times. Have tried pausing and opeiong the drawer int he hope to kick it back into working but doesn't help. A normal cycle of 151mins is taking 4 hours.rnI normally have to let the cycle run till it sticks on 33 mins then I trun it off letting the dishdrawer empty and kick into dry mode. I hate to see my next electricity bill, its been a month n


My dd603 takes 3 hrs to do a 55 minute cycle-who can help me ... Fisher and Paykel 23 in. DS603H W Built-in Dishwasher

Frigidaire dishwasher won't end cycle - will run on and on for hours. Sometimes it cycles through, usually it just endlessly washes and rinses. I have to CANCEL the cycle, which causes the dishwasher to empty and run a few RINSE ONLY cycles (which are consistent, cycle time wise) to rinse the soap off of the dishes. Also, the door for the soap seems to stick - how long into the cycle before the soap door should open? Also, does opening the washer during it's cycle (to add more dishes) change or


I would say the resettable thermostat has failed. There is a thermostat which senses the water temperature, and when it fails, it causes the dishwasher to run constant. Replace the thermostat underneath the dishwasher and that should cure problem. P ... Frigidaire 24 in. FDBB540 Built-in Dishwasher

Bendix dishwasher dh090. my dishwasher keep sticking on the 3rd mark. what ever programme i put it on once it gets to the wash part it sticks and stoppes working until i start turning the dial till it gets past the wash cycle and then it finishes of the cycle


... Tricity Bendix 18 in. DH090 Free-standing Dishwasher

Smeg Dishwasher DWD 63.1 SS, not heating; I have Smeg dishwasher that is sticking in its cycle (wash phase), water was cold, so I assumed the element had failed (or tank termostat), so I have replaced both element and tank thermostat in turn. No change, water still cold and dishwasher sticks in the wash cycle. Any ideas? (Note, no diagnostic leds on this model)


... Dishwashers

Bosch dishwasher Does not heat up in the washing cycle and does not drain down at the end of the cycle. End of cycle the display sticks at 1 and the drain pump operates until the machine is switched off or reset. Followed the suggestion in another thread to look for a burnt solder joint on the control board. Unfortunately my machine is a later model than the board shown and has no poor joints on the board. It would seem from previous answers that the problem is either the controller, the heating


1) The water must be preheating by heating elements and thermostat see how to do it.\015\0122) Timer , test for defective,clean the contact, repair wires for loose, broken, or burn.\015\012\015\012God bless you.\015\012 ... Dishwashers

My Bosch SMU2000 series dishwasher will not complete the wash cycle. Advancing the dial completes the cycle but it sticks again before completing the rinse cycle. I replaced the timer assembly and the symptoms are the same


Hi,It seems to me a Faulty Control Board. You need to pull up the control board and check the resistors on it. If found burned or swelled, needs to replace those.Note - It's better to replace control board than to repair as yo ... Dishwashers

Powdered soap residue (cascade) sticks in the dispenser after dishwasher has completed wash cycle. I have tried the new gel pacs and they also seem to stick to the dispenser even after the the dispenser door has opened. What needs to be done?


The best solution is to use the compressed powder cubes, the will fall to the bottom of the dishwasher as soon as the soap cup opens. New dishwashers use so little water that they dont do a good job of getting all the phosphate free detergent out of ... GE Dishwashers

MODEL GSD3460--TIMER STICKS HALF WAY THRU CYCLE AND WILL RUN FOR HOURS. IF YOU MOVE THE TIMER JUST A HAIR THE CYCLE WILL FINISH IN A TIMELY FASHION


... GE Dishwashers

Kenmore dishwasher 587.15162400 wants to stick at start of rinse cycle what can I do. I tried replacing switch it still sticks at that point.


... Kenmore 24 in. 16032 Built-in Dishwasher

Hi I have a Heller DWH16 dishwasher and the timer is playing up it keeps stopping during it's cycle and if I click it one notch past it's sticking point the dishwasher will start working again. It sticks at 1 Oclock and 5 Oclock.


Hi,This model has a heating unit that increases the water temperatures. It sounds like it is either not heating or the thermostat to tell it to move past the heating cycle is not working.A couple of things you can try before c ... Dishwashers

I have a Miele G 892 Dishwasher and recently the vent for the Turbotronic drying fan has been sticking in open position at the ned of the cycle. Teh result is the next cycle the vent fills with dirty water that extresses onto the floor whn you next open the door.


You have the Miele problem.This happens \012every year or two. Take off the outside front panel to access the hose \012that runs from the bottom of the fan down to the dispenser, and lets the\012 water drain out through it to the in ... Miele G880 Dishwasher

I have a Kenmore Quietguard Standard that I purchased around 2005. It will begin the cycle, but 'sticks' and makes a loud screeching sound... like it sticks when it's to begin washing. Help! I'm lost without my dishwasher and know nothing about repair but I think I might be able to if I knew what was causing this and what to do.y


... Kenmore 24 in. 15142 Built-in Dishwasher

My ge nautilus dishwasher motor sticks. i spun the fan and the dishwasher finished it's cycle but if i open the dishwasher door, the motor sticks again. i have to restart the fan motor with a screwdriver. the dishwasher is only used 4 months out of the year.


... GE Nautilus 24" Built-in Dishwasher

My Bosch Dishwasher door sticks shut at the end of the cycle. I can open and close it with ease during the cycle, but once it finishes I have to pull really hard to open it.


See all this steps and fix it. God bless youDoor or Lid Latch AssemblyIf the door won't latch, the latch assembly might be defective. Inspect the latch assembly to see if it is cracked or worn out. The latch assembly is norma ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

ASKO ASEA 1652 dial sticks in the cycle between "Light" and "Two Rinses" and needs to be manually nudged forward along its cycle. After a slight nudge, the dial moves on its own to "Dry".


... Asko Dishwashers

Frigidaire dishwasher dirty & sticks in cycle


First, check the holes on the upper spray arm. They should be clear of food and debris.\015\012Next, There's a check valve (ball) built into the motor unit. Either it's stuck, or the motor isn't pausing at the appropriate time to switch from bo ... Dishwashers

Cycle Sticks unless I manually move it along


Ya, the mechanical timer/dial is the problem. The heating element just got stuck on as the timer stalled in that dry cycle. ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Candy DW160 - Cycle sticks and does not finish


... Dishwashers

STICKS on cycle, wash, etc. If manually moved


Do you mean the timer or control dial sticks. If so then it may be the timer mechanism itself.\015\012\015\012Make sure that when you are skipping a turn on the timer that the machine is actually performing that particular task of the cyc ... Frigidaire Dishwashers

My dishwasher is sticks in between washing cycles


... Siemens 24 in. SE64A630GB Built-In Dishwasher

Electronic Timer sticks on Wash Cycle


Hi\015\012Because the timer controls many operations, a faulty timer can cause many problems. The timer is a complex component, so you shouldn't attempt a do-it-yourself repair. Test the timer with a VOM set to the RX1 scale. To gain acce ... Bosch 23 in. SHU33A Built-In Dishwasher

Loud buzzing noise throu8ghout cycle. Sometimes washer sticks in wash mode


It appears your timer/main controller/CCU has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites bec ... Kenmore 24 in. 16352 / 16354 / 16359 Built-in Dishwasher

Loud buzzing noise throu8ghout cycle. Sometimes washer sticks in wash mode


This is most likely not a problem with the motor since you have changed it with a new one. This is most likely a problem with either the power supply board or the main board that is controlling the motor. You will need to get those checked to see if ... Kenmore 24 in. 16352 / 16354 / 16359 Built-in Dishwasher

Loud buzzing noise throu8ghout cycle. Sometimes washer sticks in wash mode


First thing i would check is to make sure your copper water line is not touching the motor this will give you this noise. just take off lower kick plate and start d/w you will be able to tell where the noise is coming from. ... Whirlpool 24 in. DU1055XTPS Stainless Steel Built-in Dishwasher

Dishwasher sticking to one cycle


HI, this will occur when the timer module is malfunctioning. the timer module will need to be replaced asap, if possible. the mechanism has failed.This applies to the newer model with control boards as well. the timer module and, control ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0999 seconds