Having problems with your Electrolux Dishwashers ?

Not disolving powder thru cycle

\015 Dishlex global 300\015\012 dishwasher model dx3001wwc not disolving powder thru cycle\015

Answers :

This may be a problem with the powder that you are using. It may also be a problem with the temperature of the water that is coming into your machine (not hot enough).

You may want to try a gel type detergent.

If you need more help, post a comment.



Repair Help & Product Troubleshooting for Electrolux Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Not disolving powder thru cycle

This may be a problem with the powder that you are using. It may also be a problem with the temperature of the water that is coming into your machine (not hot enough).You may want to try a gel type detergent.If you need more ... Electrolux Dishwashers

Kitchen aid dishwasher kudk031twho gets water, drains, soap will not disolve, runs thru all cycles, once the clean lite flashed 7 times, after reseting code never happened again.

... KitchenAid Dishwashers

Hi our Touchdry model dishwasher isn't disolving the soap powder, we use the recommended brand Finish, worked fine up to a couple of weeks ago, now there's still a large lump left in the dispenser every morning - I always use the econo cycle, and the machine is always full up with dishes. Used a Finish cleaner yesterday but still no improvement. What's happening?

Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. First of all please check the\015\012Water temperature by using a thermometer inside the dishwasher to measure ... Westinghouse Dishwashers

My Whirlpool Modulogic APD951 Dishwasher is wetting the powder in its compartment and ends up a clump instead of disolving during the cycle. I have removed the rubber seal, cleaned and reinserted it but I still have the problem. This has just started happening , I would appreciate any help, thanks

... Whirlpool Dishwashers

Powder detergent does not dispense into the dishwasher during wash cycle. The powder gets wet and stay in the dispenser and then when the drying cycle comes on it dries the powder and it becomes hard in the dispenser. The dishes are not getting clean

Hi,\012There are three common problems that cause the Soap Dispenser or Cup not toopen. I have a tip that will explain these problems in detail....Dishwasher Repair Problem ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

GE Dishwasher detergent dispenser has hardened soap in it when cycle is done We, too, have the same problem. Ours is a GE Profile MAX - GSD6610K01CC. The basket is obviously not allowing the door to open fully, so I think it is intended to work this way. The question remains, though, why is there solidified powder remaining in the dishwasher after the complete dishwasher cycle has finished? Tabs work well, as the tab falls out, but all the powder doesn't seem to. Electrosol powder is less expen

... Dishwashers

No matter which cycle selection in pushed, the dishwasher only starts up in the "normal" 93 min cycle. If I try other cycle options, and persist, I get an ER message and the cycle stops prior to the soap powder door opening and never completes the cycle. Only with turning off power for several minutes and receiving the PF message, and resetting ONE TIME that message can I then select any cycle, at which time the machine "defaults" to the "normal" full cycle. If I do not disturb that cycle, it wi

Looks like you are having a good deal of problems with the dishwasher.\015\012\015\012It will be helpful if you provide the make and model no. of the dishwasher.\015\012\015\012At this stage I can speculate the controller (ass ... Dishwashers

I have a Neff built in dishwasher - I think it is the S4443N6. I've tried all the cycles- quick wash/intensive/eco/etc but none seem to wash although the machine appears to go through the motions. The powder draw does not empty properly and the powder is hard after the cycle finishes. Water does not seem to be coming through with enougn pressure although I have checked for blockages in the pipes and cleaned filters.

... Neff 24 in. S4443N6 Built-in Dishwasher

When my dishwasher completes its cycle, there is powdered detergent left in the dispenser and the dishes aren't as clean as they use to be. This started happening after I ran a HI TEMP WASH with a SANI RINSE cycle. I'm thinking that either the detergent dispenser door is opening late or the water is not getting hot enough. To check the dispenser door, I left the door open and just poured powder into the dispenser compartment. This did not improve the cleaning.

Hi\015\012 \015\012Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doesn't allo ... Kenmore 16372 / 16374 / 16379 Built-in Dishwasher

I have a conia cdw0305s dishwasher.when we put it on wash cycle and put the powder in the door ,after the full cycle the powder is still in the door.the little flap is not opening.

Sounds like the dispensor is faulty or the control board is faulty.do u have an electrical test meter to test 4 the fault? please reply if u need more help. if you are in australia conia have gone bust but if u reply i can give u the name of a place ... Dishwashers

Hi I have a Whirlpool dishwasher Model #DU912PFG01 Or DU912PF001 or DU912PFGG1 cannot tell the last 3. Serial # FK194309. My son noticed the dishes didn't look clean, he added DISHSOAP which then produce a huge amount of suds. Anyway hav run the cycle thru with vinegar and it doesn't seem like water is moving throughout the diswasher, just on the bottom. DO you have any ideas, it runs thru all the cycles.

Slog builds up in the drain pipe right before the garbage disposer. I had to replace mine when I replaced my old dishwasher. If you put vinegar in the dishwasher to unplug the pipe, the vinegar could have loosen all the slog and clog the drain ... Zanussi 24 in. DE6965 Built-in Dishwasher

My kleenmaid dishwasher super silent model system DW5 doesnt appear to be heating the water on any cycle so it is not washing properly and leaving the powder etc on the glasses up the top particularly and also it does not go completely to the end of the cycle by itself(any cycle).Or completing the drying cycle. I have to switch to 0 cycle to make it complete the clicking to start again. What is the gauge on the inside of the dishwasher on the left that can be adjusted from 1-5 is this a heat

Http://frigidaireservicetips.com/pdfs/486_5.pdf\015\012\015\012\015\012\015\012Service manual, generic, use this to troubleshoot and repair.\015\012\015\012 ... Dishwashers

My frigidaire dishwasher is stuck on the clean cycle. If I unplug and start it again it will run thru the cycle. When the cycle ends it will not reset itself, and will stay only on the clean cycle. Any ideas of what it could be.

BAD TIMER ... Dishwashers

I have a Maytag Quiet Series 300 dishwasher model number MDBH955AWW. When I press the wash cycle button it starts and then automatically jumps to the rinse cycle. After going thru the rinse cycle for a couple of minutes, it shuts off. After that,I can push the wash cycle agin and it works. Any idea what could be wrong?

HI. This will be a basic logic chip fault. It could possibly be solved by simply preforming a hard reset. You can do this by shutting down the power to the unit for five minutes. This shutdown will force the logic sector of your electronic control bo ... Maytag 24 in. MDB9750AW Dishwasher

I have a Maytag portable dishwasher. Lately it has been sounding like the top sprayer is working only sporadically. The cycle begins & it sounds like it doesnt begin spraying until halfway thru the cycle. I open it & check it & see it's not turning. I've cleaned out the holes the best I can. It does this with the rinse cycle also. THANKS FOR YOUR HELP.

I will need the full model number of the dishwasher before I can start diagnosing the likely problem. Is it possible to find this please? ... Maytag Dishwashers

Own a KitchenAid dishwasher, model KDC-21AD. Unit stopped shortly after startup cycle began. When cycling thru the various wash cycles, I hear a slight hum when selector switch is at the "pots/pan" selection. About 2" of water is standing in base of dishwasher and it will not start. Checked the KitchenAid site and they do not list my dishwatcher. Would like to be able to repair myself or have it done at reasonable price.

... KitchenAid Dishwashers

My KDS 19 Kichenaid dishwasher goes thru the wash cycle, but at the end there is about 1/2" water still in the bottom. The punp work OK druing the wash and rinse cycles, but at the end of the drying cycle there still is watere in the bottom.

Would you have the model number at all? It should be on the left edge of the dishwasher's door. Thanks. ... Dishwashers

Kenmore Model Ultra Wash Model 665- 45955 Problem: Dish washer leaks at bottom intitially during sudding cycle only...first 5-10 min... then no leaks/drips thereafter thru balance of clean/rise cycle. Whats up....Thought possible seak around washer door is bad but no leaks at bottom or elsewhere after the sudding cycle is completed. Please provide complete resolution reply if possible Tx

Hi\015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If you have water leaks around the base of your dishwasher,\015\012you may be using a detergent that is causing too much suds. Cut ... Kenmore Dishwashers

I own a Bosch dishwasher that has operated perfectly for about ten years. The model is: SHU9915UC. Now it wont complete the cycle. The undissolved detergent is all over the dishes. After running 4 more complete cycles without any detergent the same undissolved powder detergent remains on the dishes. I have also executed a cancel/drain cycle. The filters are not clogged. I am great at repairing many tools and automotive "stuff" and don't want to call a repair facility. Please help.

Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I just read your previous post and I wouldn`t replace that timer/control just yet. There is a way to visually inspect the control.\015\012\015\012 ... Bosch 24 in. SHU53 Built-in Dishwasher

The dishwasher is not washing. There is grainy residue on everything...even the wine glasses which had no food residue when they were put in the dishwasher, but are filthy at the end of the cycle. There is a bit of soap powder left in the soap powder container. I use Cascade powder detergent and Jet Dry . Thanks for your help.

Either it is not filling up enough or the wash pump is not working. ... Dishwashers

501ht goes thru wash cycle but cam stops just before rinse cycle clicks in - stays in wash cycle - turned thermostat to booster down in temp -cam then keeps going properly but with no hot water from booster - replaced thermosat still same result - apparently a safety ? no booster water no rinse?

Did you get a solution for this? I am having the same issue. Please email me at [email protected] Thanks -Eric ... Moyer Diebel 24 in. 501HT Built-in Dishwasher

Dishwasher problem It is a "classique" dishwasher , about 8 years old, but used only about 50 times max. The dishes are not getting out clean - the washing powder is smeared over them. Most of the dish washing powder (or tablet, tried it both) is not comming out of the powder compartment, despite the fact that we find the compartment open when the washing cycle is done. Sure it is just a "smal quick fix thing" but have not idea what it could be. Pleaseee help!

... Dishwashers

Undissolved powder Asko Dishwasher - At the end of the full washing cycle there is still undissolved detergent powder in the powder receptacle. Any suggestions?

... Dishwashers

When dishwasher is turned on to the cycle mode - it fills with water - heater heats water to the proper temp - pump starts - washer goes through it's complete cycle - even pumping out the wash water and the drying cycle,then shuts down. the problem is that it does not circulate the wash water thru. the spray heads-even though the circ,pump is running.Even though the unit is 8 yrs.old and hasn't run for 6 yrs,my wife&i do our dishes by hand. our unit is a GU1200XTKB0 Serial# FL4617501

The impeller on the wash pump is worn out or the disposer screen is obstructed. Disassemble as needed to investigate the cause. ... Whirlpool 24 in. GU1200XT Built-in Dishwasher

Dishwasher will not go thru wash cycles

If the water is not draining at all in any of the cycle it is probably the discharged line at the bottom of the pump has become blocked. there is an access panel at the bottom of the dishwasher which will allow you access the line. take the line off ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0683 seconds