Having problems with your Electrolux Dishwashers ?

Electrolux dishwasher lights flashing drain valve it's 18 degree outside ... do you think the line is frozen?


Answers :

Repair Help & Product Troubleshooting for Electrolux Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Electrolux dishwasher lights flashing drain valve it's 18 degree outside ... do you think the line is frozen?


... Electrolux Dishwashers

Dishwasher Fault Hi, My dishwasher is a Diplomat ADP8322 (which i think is a rebadged whirlpool unit) & has been playing up recently. When you start a cycle it is fine for a minute or so then it starts beeping, the rinse light comes on & the light next to the start button flashes 11 times, pauses then repeats. I have read online that this flashing relates to what the fault is, but i cannot find out what fault the 11 flashes relate to. The first time this happened i cleaned out all of the filters


... Dishwashers

My kitchen aid dishwasher will not start I replaced the interface control board thinking that was the obvious problem. When you go to set the dishwasher to start some of the settings don't always light up then when you push the start button the lights will flash then start but it's not flashing and won't start. I get lucky once in a while and get it to flash then start. I don't know where else to look. I don't want to start replacing parts one at a time till I get lucky. My model # is KUDIO1F


Check all cables especially the ribbon cables from the user interface to the electronic control assembly as steam from dishwashings will create small amounts of corrosion and inhibit signals to and from these 2 components,unplug each,inspect,and reco ... KitchenAid Dishwashers

I have a Kenmore Elite Dishwasher Model 665.172824000. We think it stopped part way throught the dry cycle. The green "Clean" light has been flashing since in 7 flash cycles non stop. I tried pushing the Cancel button, it starts the drain pump then stops and we are back to where we started. I tried to start a new wash cycle but when I close the door and push the start button it just give 3 quick red flashes and then nothing but the green clean light flashing again. I shut the breaker off fo


So sorry but the partsdirect site for sears locked down my computer. Check where the drain hose connects to your pump and see if there is a small device the hose connects to that has 2 wires going to it. If it does unplug the wires, turn power off, w ... Dishwashers

Whirlpool GU2400XTPT Dishwasher is on island of Utila, Honduras. Upon return after several months absence, light was flashing but dishwasher would not turn on, light would not turn off, no other buttons would light up. I am thinking a power surge might have hit it and maybe knocked something out. Problem is, I need a part from here to take down there and hope someone there can install it. Help! Thanks! Barbara Chaney


I had a svc. tech come and he said I need a new "panel". Darn.It's $133 plus labor. He said the "normal" button had shorted out,especially since that's the wash I use all the time. It's only two years old, and I didn't buy an extended w ... Whirlpool GU2400XTP Built-in Dishwasher

Quick Rinse light was flashing at end of cycle. Opened and closed door and pushed Start. Quick Rinse and Cancel/Drain light are now flashing and machine won't start. Turned off power supply (30 seconds) / turned on power supply and then tried again to start the dishwasher, but same problem. Control panel seems to be frozen at the Quick Rinse/Drain mode and will not cancel. Help! Thank you


Ok try this, open the door and then hit these buttons in the following combination. HI TEMP - DRY - HI TEMP - DRY...then close door and press cancel...then wait for the pump to shut down. you should be able to run a cycle after this...If this fails ... Dishwashers

Asko d3100 I have an asko d3100 dishwasher. Its just out of warranty and now the cup saucer light flashes and the water pump is continuing to pump even though there is no water. The dish washer wont start. What is the problem. I think the flashing cup saucer light is reporting a fault. If I know what the fault is for example faulty relay or pump then I can replace it. Can you help me with this one? Is there a service manual I prbably can get my hands on.


Remove the lower panel at the back of the machine. If there is water on the bottom pan, wipe it up with a towel or so, and the machine schould be like new again ;-)\015\012\015\012Good luck ... Dishwashers

Jenn air jdb3200aws Sanitize light is flashing and the dishwasher is frozen


... Jenn-Air JDB3200AWS Dishwasher

Just bought and had installed on 9/25/10, Kenmore Elite dishwasher model #665.13929K010. Start light on the front panel flashes, then runs through all lights and ends on the complete light which contnues to blink. It will not actually start the wash process at all. Before I call Sears to come out, what is the reset sequence for this model? Any other solutions you can think of?


... Dishwashers

My kenmore dishwasher, model 665.16473300 has stopped working. Now the lights just flash at the Smart Wash, Normal Wash, and Cancel. I've reset the power and it just comes back. I've taken the drain area apart and made sure there are no obstructions. The buttons seem to respond, as after I reset the unit (breaker), only the Smartwash button is flashing. I push cancel and then it starts flashing. So I think the buttons work, but it's locked up.


IS THE WATER TURNED ON TO THE DISHWASHER ... Dishwashers

Maytag mdb9150 dishwasher stopped at some point last night--found it this morning with flashing lights--I think "clean" and "heated dry", not sure.  I used "drain/off" to make sure there was mechanical noise--there was, so I don't think the machine is dead.  Purchased on 2001 with 5 year warranty, so out of luck there.  I tried turning off the electricity to the unit for a few hours; nothing improved.  When you start it (or think you have!) it makes noises for about a minute that sound promising


Check pump and solonoids click/work, if no mechanical noise, could be the circuit board, but they can be expensive. :(\015\012if the solenoids click, and allows water in, then the pump might be jammed, with grit, clean and reinstall... good luc ... Maytag 24 in. MDB9150A Built-in Dishwasher

I have a whirlpool adp6600 dishwasher. the green light just keeps flashing (i think it's 7 times in a row each sequence) and the cycle won't start. have tried turning it off at the wall, clean


Dishwasher is in fault mode hold start/pause button for a few seconds this will reset the unit run your cycle again if dishwasher faults again call you local service man.good luck ... Whirlpool Dishwashers

My CDA CW497 has developed problem. When i select a program say 70 degrees and press the start button and close the door the dishwasher starts in the the normal way bit after about 15 seconds the dishwasher stops making any noise and beeps once. When I open the door the green on/off light intermittently flashes. Any thoughts what the problem is please?


... Dishwashers

I'm not able to reset my dishwasher Whirlpool ADG795, i mean, my 4-year old son was playing with buttons and, i think, the dishwasher went, but not exactly properly, into test, all the lights are flashing, i was trying to start the test properly (by pushing power button for 30 sec, hen 3 sec release and press once more) but unfortunately nothing has happened, argh... any idea?


Sounds like you are in the testing/diagnostic mode. You can exit the program by holding the buttons, or simply unplug the unit for an hour, in meantime of being unplugged, press and hold the function or power button for 5 seconds, then wait 1/2 hour ... Ariston Technologies Dishwashers

My dishwasher light keeps flashing 7 times then pauses, and does it all over again. I think I have tried every sequence of pressing certain buttons on the panel with no luck. I always turn the hot water from my kitchen tap on before I turn on the dishwasher. Any other suggestions?


... Kenmore 24 in. 16032 Built-in Dishwasher

Start button flashes 2hr, but will not start the dishwasher, when touched. Also, lights on top of the door are not always functioning. I phoned Maytag and customer service had me turn off the circuit breaker for 5 minutes. This did not change the dishwasher. I think that the door latch is not snapping into position, when I open the door.


... Maytag 24 in. MDB7601A Free-Standing Dishwasher

I have a Whirlpool ADP6515. It's been working fine for about 2 years now but recently cycles are not completing properly, it can run for 30-40 minutes depending upon cycle. The start light is flashing a 4 times repeatedly, I think this happens when it moves from a wash to a pump cycle but not sure. We have to hold down the start button to force it to go to the end of the cycle and the the lights stop. If we do that we can then use the dishwasher the next time, but only after we force it to go to


While replacing the console board, the replacement should be of same version. The boards are using programmable IC. Hence matching the software version is a must. Only the manufacturer or his authorized provider can help regarding t ... Whirlpool Gold 24 in BuiltIn Dishwasher w Adaptive Wash Cycle 24 in Builtin Dishwasher

My westinghouse 915 dishwasher has frozen mid program and the prewash in the middle is flashing i can cancel but when i try to start the lights for prewash on the left and the normal button stay on for 5mins the the pre wash flashes again i,ve turned of at power supply to thx


... Westinghouse MDB631 RF Dishwasher

Dishlex dishwasher global 300. Dishwasher continues to drain with ECO light flashing. Service manual says it is due to an incorrect fill level or fill line.


Some diswashers have a sump in the bottom with a float switch. If the water level overflows the float will activate the switch which will kill the machine and run the drain pump continuously. ... Dishwashers

Troubleshooting Miele 18 in. G611SC Plus Slim-Line Free-Standing Dishwasher, Support & Service: Salt PC Light is red and constantly on and the inlet and drain light is flashing red.


... Miele 18 in. G611SC Plus Slim-Line Free-Standing Dishwasher

My Zanussi DE6744 dishwasher won't run it's cycle since I ran a dishwasher cleaner through it. It powers up then stops and flashes 2 green lights alongside a symbol that looks like a bowl with steam rising from it and an arrow with an upright line to it's right. There is also some standing water in the base of the machine. What do these mean.


The first thing I would do is check the float to be sure it is not stuck in the over filled position. Then I would check the drain to be sure that there is nothing clogged in the drain line. Then I would check to make sure the fill valve is working a ... Zanussi 24 in. DE6744 Free-Standing Dishwasher

My dishwasher controls are frozen the light is froze on clean. The only way to use it is to pop the breaker and then the lights blink and I can start it. We replaced the breaker thinking it was the breaker but it wasn't that.


May be faulty control board. Moisture gets in and damages the electronics. Will likely fail completely soon. Is it a Frigidaire? ... Dishwashers

I have a GE dishwasher with front control panel and at first the wash and dry lights stayed on and it was beeping every 30 sec. when I turned the breaker off for the required 30 sec. the lights started flashing and it is still beeping. The control panel seems to be frozen as it is not working and wont do anything.. everything was working fine before this. I bought it at Home Depot on 3/14/07 and had it installed by a licened electricion. Help


Call ge @ 800-386-1215 for service ... Dishwashers

What is wrong with my Zanussi DX-6453 dishwasher - the 65 degree light and the end light are flashing. What does this mean?


... Zanussi Dishwashers

Asko dishwasher D5122XXL I've got the F2 light flashing. How do I reset it? Or do I have to get service people to do it? I think there's nothing wrong with the pump or drain, since I actually poured a jug of hot water in to the dishwasher. ( it's hooked up to cold water pipe)


... Asko D5122XXLS 24 in Builtin Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1890 seconds