Having problems with your Fisher and Paykel Dishwashers ?

F&P dishwasher DW60CDX1 (5yrs old) which will drain then fill but will not start the wash cycle. No error codes just a humming sound, possibly faint electrical burning smell (turned off quickly in

\015 Recently had to reset the overflow sensor by tilting and draining. This removed the e2 code.\015

Answers :

Repair Help & Product Troubleshooting for Fisher and Paykel Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

F&P dishwasher DW60CDX1 (5yrs old) which will drain then fill but will not start the wash cycle. No error codes just a humming sound, possibly faint electrical burning smell (turned off quickly in


... Fisher and Paykel Dishwashers

My Whirlpool wdf530payw dishwasher is not draining. I ran the service diagnostics using the control panel, and the code that came back was Function code 8, and Error code 2 "Drain Motor Electrical Problem". The possible causes listed are: a. Loose Connection in drain motor circuit, and/or open drain motor winding. b. Open Fuse on control to drain motor c. Faulty drain motor drive circuit on the control When I hit the "Cancel/Drain" button there's an faint buzzing sound for about 2 minut


... Whirlpool Dishwasher. Front Control Dishwasher in White WDF530PAYW

The dishwasher makes a humming sound when turned on. No matter what cycle it is turned to, it continues the humming sound and does nothing else. I thought I could reset it by unplugging it, but as soon as it is turned on again, it continues the humming sound.


... Miele G848I Dishwasher

My Bosch diswasher is hanging up in the cycle (at 102 mins. in normal cycle and 38 mins in quick cycle). I hear what sounds like a one second pumping of water into the sink area, a pause, and then another one second pumping of water, on and on, but there's no progression beyond this point. One possible cause: a few weeks ago someone turned off the hot water at the heater and another person tried to run the dishwasher. The dishwasher did not function because it could not get hot water. Perhaps


Hi\015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. To start with check the water inlet valve which is located\015\012behind the lower access panel on the left or right side of the Di ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I ran a load of laundry in whirlpoo[ duet ht, model ghw9400pl4, error code p-09 was indicated. water was overflowing from door, and water was continuing to fill the tub. I turned off the faucets, unplugged & restarted in drain mode it hummed but would not drain. I turned the faucets back on and retried to drain but it would only hum. I manually removed the water by losening pump filter. There was no debree in filter except for a little bit of hair. The pump & vain was free & clean, and I co


It is your mixer value that is malfunctioning. ... Whirlpool Dishwashers

We have a classique dishwasher (cl 6 s-2 made in italy) has been not use for a while. when we want try how is working condition , turn program swith at half way and push on in 3 minits , have a electric shorting sound. after chack found 1, forget turn on water 2, at electric wire in the boteem one small cylinder part have burn. the main supply circuit breaker in the house when the short occured.


... Dishwashers

Dishwasher just hums, faintly, when I turn it on.


Motor is locked up.. if you let it hum faintly for a couple min it will cut out most likely.. thats the thermal trip built into the motor.. the motor assm needs to be replaced.. ... Neff 24 in. S5443X2 Built-in Dishwasher

Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk


... Dishwashers

I have a GE gds500p .When turning the rotary dial to start, there is a humming sound but no water sound or sound of motor that used to be heard when it worked


Sounds like you drain pump as blocked. first remove the water from inside by hand, then remove the front kick plate should be just 2 screws then remove the inner panel to access the drain pump. It either has 1 screw and then twists out or has 3 ... GE 24 in. GSD500X Built-in Dishwasher

AFTER A BRIEF POWER OUTAGE DUE TO ELECTRICAL STORM THE F1 CODE FLASHES AND PUMP RUNS CONTINUOUSLY. TURNING POWER OFF ONLY STOPS IT FOR SEVERAL SECONDS. TURNING OFF POWER TO DW AND BACK ON DOES NOT RESET. I HAVE REMOVED THE BOTTOM DRAWER AND CHECKED FOR WATER, BUT UNIT IS DRY. IS THERE ANOTHER WAY TO RESET THE SWITCH?


Hi there,The f1 fault is cased by a leak on the dishwasher.It is activated when water gets to a dangerous level in the base of the appliance near to the PCB.The main reason this happens is putting cups on the drop down s ... Dishwashers

I have a GE potscrubber portable dishwasher and when i connect the hose to the facet and plug in to the outlet and turn the dial to start the dishwasher up all i hear is a low humming sound. I tried truning the knob around a few times and still the same low himming sound.


I have this same problem with the same dishwasher. Did you ever find what was wrong with it? ... GE Dishwashers

Dishlex global 460 fault.. Always stays on and makes a pumping sound while 'of' is displayed. Only way to turn it off is at the power point. Have tried turning it off at the power point for some time and re setting by pushing start & program at same time with no luck. According to the manual the code says "incorrect fill levet or time " and contact service for help. Any ideas?


... Dishwashers

Hi, I've got a dw 681es wh nemo dishwasher. I turn it on, it starts working but it sounds funny....and nothing happens. after a while the start/reset button flashes and then it doesnt continue. Any clues? I start it on the quick wash cycle but it quickly flicks to the rinse cycle when this problem occurs. I used to just reset and it worked again but now it just wont work.


... Fisher and Paykel Dishwashers

Bosch Exxcel Dishwasher model SGS56E02GB/47 When you switch it on no water is coming through - what sounds like the pump/motor sounds a lot rougher than normal and there's a very very faint electrical burning smell. The timer counts down, but it never appears to do anything and continues doing so after the counter has zeroed.


... Bosch Dishwashers

When i turn my Viking dishwasher on the motor starts to run but no water comes out. It was humming along for several hours before i realized that nothing was really happening. I turned it of and then tried again but the same thing happened. It sound like a motor and/or pump working but no water enters the chamber. Thanks, Jonathan


It sounds like the Water Supply Solenoid is bad. I would change that and let all of us know what happens. ... Dishwashers

Maytag dish washer makes loud humming sound, I removed kick plate and can feel motor shaft turning. tapped motor with hammer no sound change. no loose or binding parts


Itcould be something caught in the impeller or filter area ... Maytag MDB9600A Jetclean II Built-in Dishwasher

I have a Kenmore Elite dishwasher (model 630.17303406) and it just stopped working. Doesn't drain what's left in the bottom and just makes a humming sound when turned on. Power is good, sounds like the motor is working. Doesn't seem like it is drawing water in. I want to check the pump and motor, anybody have any advice?


If nothing obvious like blocked / obstructed outlet pipe\015\012You need to check if the outlet pump motor in line with the outlet hose is spinning when in the outlet mode. First check if it is spinning by looking at it and see if the small fan ... Dishwashers

I have a Bosch shu43 dishwasher that just hums when turned on.The timer counts down but I can't hear water running through it. At different times in the cycle it will hum but no other sounds, it won't clean.


... Bosch 24 in. SHU43 Built-in Dishwasher

Gianni dishwasher, turns on, but dial control doesn't cycle thru, just has humming sound


... Dishwashers

Karcher electric press. wash. Hums when turned on then trips bre


Dear K_mccurdy,\015\012I am assuming that your washer is single phase. A comon reason for humming is a faulty capacitor. This must be changed by a new one.\015\012Now one must see why the capacitor got damaged. This could happen, when ... Karcher PSI Electric Pressure Washer

I have a dishwasher that hasn't been overly used ...and if ... only use the quick wash. Now when I turn it on it gives the sound (normal) as if draining but never stops and starts filling with wa


Sounds like your timer control is bad or not working properly, you might be able to get that part pretty cheap depending on the model. Hope that helps you. ... Dishwashers

Maytag mdb9150 dishwasher stopped at some point last night--found it this morning with flashing lights--I think "clean" and "heated dry", not sure.  I used "drain/off" to make sure there was mechanical noise--there was, so I don't think the machine is dead.  Purchased on 2001 with 5 year warranty, so out of luck there.  I tried turning off the electricity to the unit for a few hours; nothing improved.  When you start it (or think you have!) it makes noises for about a minute that sound promising


Check pump and solonoids click/work, if no mechanical noise, could be the circuit board, but they can be expensive. :(\015\012if the solenoids click, and allows water in, then the pump might be jammed, with grit, clean and reinstall... good luc ... Maytag 24 in. MDB9150A Built-in Dishwasher

FRIGIDAIRE DISHWASHER HI! MY NAME IS MARK AND I AM HAVING PROBLEMS WITH MY FRIGIDAIRE MODEL # FDB710LCB0/SERIAL # TH51153536 DISHWAHER. THE PROBLEM: IT DOES NOT COME ON AT ALL LIKE THERE IS NO POWER TO IT. I HAVE CHECKED THE BREAKER AND THE ELECTRICAL CONNECTION AND THERE ARE NO PROBLEMS AT THOSE POINTS. ALTHOUGH FOR A BRIEF MOMENT LAST NIGHT IT DID COME ON AND THERE WAS A "HUMMING NOISE AT THE DRAIN PUMP LOCATION (IT SOUNDED REALLY BAD) THEN IT SHUT DOWN AGAIN AND NOW IT WON,T COME ON AT ALL. A


Check your door switches behind console, next i would ck the circuit board for power in/out. there a tech sheet behind front panel for further diag test points ... Dishwashers

Zanussi DA6141. Dishwasher will not progress from turning on at wash code c1. Test 1: No kinked hoses Test 2: Put water in by hand and it empties it. Lift out the central sieve/filter and it all appears very clean. Test 3:Inlet water filter clean. No actions except low buzz (?solenoid?) after emptying. (Possible Hint: Previously this washer sometimes stalled with knob rotated 15 degrees clockwise from C1 position and would continue to wash dishes indefinitely, if unattended. This was


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. If the\015\012cycle doesn't complete, check these:\015\012\ ... Zanussi Dishwashers

I have a miele model G2470 SCVI under cabinet dishwasher it worked great until i ran out of cascade and starting using a liquid brand (Sun Light Oxi Action) we dont use the system on a regular basis so when i turned the unit on and attempted to use it , it started up filling and then sounded like it was running, the alarm tone came on with all the lights blinking a code F14 was flashing on the left side display.


... Miele Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1222 seconds