Having problems with your GE 24 in. GLD6300L Built-in Dishwasher ?

Will not pump out all the water, I hear it click, but I don't hear the 'whirr' just a 'hmmmm'. is there a solenoid gone bad, or the pump motor?


Answers :

Pumpkin seeds blocked the drain line, so $180 to the lucky plumber as he drove off in his Mercedes back to the country club!
Repair Help & Product Troubleshooting for GE 24 in. GLD6300L Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Will not pump out all the water, I hear it click, but I don't hear the 'whirr' just a 'hmmmm'. is there a solenoid gone bad, or the pump motor?


Pumpkin seeds blocked the drain line, so $180 to the lucky plumber as he drove off in his Mercedes back to the country club! ... GE 24 in. GLD6300L Built-in Dishwasher

The eco light is flashing constantly on my Dishlex Global 300 dishwasher, it is making a noise like a pump is running continously, but the unit will not operate. Can you give me some possible faults and solutions. Regards Dave I have the same problem. The Eco light flashes and there is some sort of noise, not sure if it is a pump or a solenoid, but thats as far as it goes. A friend gave me the machine after aservice tech told him the main washer motor was gone. i have fitted a new motor, but


Its an overflow of water into the base of the machine.There is a float switch in the base of the machine in a small plastic dish.There is a metal cover with 2 small bolts that have to be removed to get to it.get the overflow c ... Dishwashers

Shu9925uc/14 bosch dishwasher leaves standing water in the bottom of the pump. The pump seems to be bad because it wont drain out the back hose. I have run the diswasher full cycle and put the drain hose into the sink to test. It wont drain at all now and I dont hear the pump. Perhaps unrelated: Pump seemed to stop working after the back hose disconnected itself from the back of the unit spilling water all over the floor. When I reconnected the unit to the wall the pump now seems to be disfunct


Hi Dishwasher not draining issue occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remove then turn off the dish ... Bosch SHU9925UC Built-in Dishwasher

Hi, I've got a SN25M830UK. It starts the programme, then I can hear some noise like a motor is spinning (it happens 2-3 times) and then I get an error E21. I checked the filter and pump cover, there's nothing blocking. Is is a bad pump? How can I access it? Many thanks.


... Siemens Dishwashers

Dishwasher is not cleaning well, dirty film all over everything, like its not rinsing. In rinse cycle only, some water comes out of lower left port inside but nothing else. Hear a low buzz underneath unit like a motor or pump is energized but no water getting to the top.During normal wash cycle, buzz from underneath seems to cycle on and off, say every minute or so like its cycling on an overload. Do I have a bad pump and if so how do I get to it?


Hi. This may well be a pump issue, or an obstructed hose assembly, as well. Your symptoms are indicating that the impeller may be damaged. In order to pull the necessary schematics, I will need the entire model number. This ID tag will allow me to pu ... KitchenAid Architect? II S SERIES KUDS03FT Stainless Steel Built-in Dishwasher

Dishwasher turns on water trickles in but spray arm doesn't spin. I hear humming in the wash cycle like it's trying to work but no spray, and little water. Is the motor gone or pump or? frigidaire DW model # fdb510lcso


Hi,\012Here is a tip that will help you to find out why water will not come into the dishwasher... Dishwasher Tr ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

My Siemens SL84A305UC/26 dishwasher will not drain. I've checked the drain and it is clear. I can hear the motor hum during the drain cycle. It will fill and wash OK, but not drain. Does this machine have a solenoid for draining and if so how do I check it? How do I check the pump to ensure it is functioning correctly? I've tried to remove the plastic bottom of the machine to see what is inside and to troubleshoot the components, but it seems almost impossible to remove. What is the trick? What


... Siemens 24 in. SL84A305UC Built-in Dishwasher

My Siemens SL84A305UC/21 dishwasher will not drain. I've checked the drain and it is clear. I can hear the motor hum during the drain cycle. It will fill and wash OK, but not drain. Does this machine have a solenoid for draining and if so how do I check it? How do I check the pump to ensure it is functioning correctly? I've tried to remove the plastic bottom of the machine to see what is inside and to troubleshoot the components, but it seems almost impossible to remove. What is the trick? What


... Siemens 24 in. SL84A305UC Built-in Dishwasher

Our Asko D1716 dishwasher functions to fill and empty but the pump which causes the sprayers to rotate and distribute the water does not function. The local appliance repairman diagnosed the problem as a bad pump (he called it a motor). Since the pump is a $400 part plus labor, is it possible that the problem is something else like a bad motor capacitor or relay? When the cycle calls for the pump to come on, there is no sound except for a very soft hum.


Hi ! \015\012\015\012Got a D1706 ( in 2002 ) paid $1000 and as os April 2010...same problem as yours, I will trow it away ( dishwasher ) and will never buy at such cost. I'll get a GE or LG. \015\012\015\012Stupid Sweden dish ... Asko D1716 Built-in Dishwasher

I have a Kenmore diswasher model 587 1525. I can hear the water filling and rinsing, but during the wash cycle I do not hear the motor. At the end of the wash cycle and when I open the door I see the detergent tablet is sitting on the floor. The dishes are not cleaned. Does this mean that the motor has failed or is it the control card. I can hear some clicking noise while the motor should be running. Maybe solenoids cycling.


... Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

GE Mod # GSD22360Z04WW will not drain water. I manually pushed the solenoid down and the pump and motor seemed to run. No water pumped out of the hose that was disconnected from the garbage disposer. I have discovered that the plug for the disposer was not taken out where the dishwasher hose attached. The dish washer stopped working after a new disposer was installed. I rotated the control knob and at no time did the solenoid for the pump operate. It went back to normal position after control kn


... Dishwashers

Kenmore (Whirlpool) 655 1589910 Dishwasher. Fills with water, motor makes horrible noise (buzzing / loud hum). Dishes do not wash and there is no evidence that any water pumped up to the spray arms. Spray arms are not clogged. We have a fully functioning water softener so it is not a hard water issue. Unit does drain normally. Either filter is badly clogged or pump is bad. How do I get to these parts to check them out?


You need to clean/ check the chopper. sounds like you have a bad motor. about 2-300 dollars for the part ... Kenmore 15899 Built-in Dishwasher

E3 error I have a Fisher and Paykel DW60cdx2 dishwasher which was tripping the safety switch as the drain hose was leaking and was shorting the wash pump motor out which I replaced and now on start up I I did notice the wash pump motor had a solenoid on the side where my original did not otherwise all else is identical.


... Fisher and Paykel Dishwashers

Makes rumbling noise during wash cycle. I've pulled the pump and found no debris. It's been making this noise for about a year now. No problems with our dishes getting washed. Do you think the bearings inside the motor may be bad? If so, would I need to replace the motor and pump assembly?


... GE 24 in. GLD5560LSS Stainless Steel Built-in Dishwasher

On our electric pressure washer. Nolonger works. Disconnected the pump from motor. Motor spins freely. My guess is pump is bad?mike


Good guess. You can find parts at: www.pressure-washer-parts.com\015\012They handle comet pumps. See if you can find the number on the pump. Not a bad brand of ... Comet GXD2527G Pressure Washer Pump

I have a Jenn-Air JDB9910AWB dishwasher. The problem I am having is everything seems to work fine until the drain cycle. It sounds like the pump is frozen. After selecting the drain button you can hear a click in the control panel followed by a 1-2 second growl in the pump but it doesn't turn or pump. I am assuming the pump runs in reverse for draining? Is it safe to assume the pump is bad?


... Jenn-Air JDB9910 Dishwasher

Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk


... Dishwashers

KUDK01ILBS5), SN: FR2702809. Have used this machine 6 years and just recently experienced noise that I eventually traced down to a bad recirculation pump bearing that failed due to a small leak in the shaft seal. Installed a new pump on Friday, 4/21/10 and that particular noise is now quieted. While the bearing noise was gone, there remains a pumped water noise that is quieted by manually adding about 1/2 gallon of water within the machine. So I now believe the water level is low, possib


The water level in the machine should be slightly under the heat element. The float you refer to is only for overfill and should not be activated if the machine is filling properly (the water level should be lower than the float switch activation poi ... Dishwashers

My Bosch SHX46A06UC/42 stopped working today. I can hear the drain pump constantly pulsing about once every second. I checked the control board and found a relay contacted burned. I re-soldered the relay so it now has a good connection, however the drain pump still just pulses. How do I verify if the drain pump is bad or if the relay failed, or yet another problem?


... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

Magic Chef DU4K is not draining all the water. There's at least a gallon of water standing in the bottom. I have cleaned the air gap assembly and drain line completely. They were even sanitized in hot water. I do not hear the water draining like it use to. When it worked properly you could always hear water draining into the GD. Now I can hear any draining. Again, there is no clogging anywhere in the drain line assembly. Is it a bad pump. I don't know where to go next with this.


... Magic Chef Dishwashers

No water pressure.. bad pump or motor?


Try filling water from the front manually. Check whether every thing works normal.If works OK, check your water inlet for free flow.Try the inlet hose externally by flushing water through the hose. Check whether any air lock. ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

Motor problem?? The dishwasher takes in water then the water just sits in the bottom of the unit until the end of the cycle, there is no water going through the jets so the dishes are not getting cleaned. You can hear the motor but nothing is actually happening until the end of the cycle when it just pumps the water back out again


Have you checked the pump / motor belt? ... Tecnik TDW2677 Built-in Dishwasher

My coleman powermate 2750 pressure washer locks the engine up when the trigger is pulled. after a few seconds you can restart it.it comes up to good pressure but kills the motor. Some have told me they thought it was teh pump, but the sprays a little. I would think if the pump was bad it wouldn't spray at all? Comments?


All i can say is its not a good mechine I owen and repair washers and pumps and use them in line of business thats all i can tell you sorry ... Coleman Pressure Washer PW0881800

My GE dishwasher, model # gsd2230f00ww won't drain. The spray arm is working and i hear the motor. Checked both ends of drain hoses, very clean. took sum cover off, clean. checked float, fine. What could be the problem? solenoid? I turn the dial on the washer and the solenoid does nothing, should it make a noise to actuate the drainage? please help! Thank you


... GE Nautilus 24" Built-in Dishwasher

Maytag MDBTT79AWW dishwasher fills and nothing else. Once filled you hear a click, followed by a humming sound for 3-5 seconds, then silence. This will happen two or three more times, and then unit will shut off. Motor doesn't start. Repairman says he thinks control board is bad, but he sounds like he is guessing. I performed a field service test , which indicated a fault in the high current motor circuit. Unit is seven years old. Don't know whether to attempt repair, or replace.


That sounds like the motor trying to start but being jammed it is shutting off via an internal breaker. Check for something in the bootom of dishwasher that might have gotten down there that could do this. You might have to take the sprayer off and s ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0677 seconds