Having problems with your GE Dishwashers ?

Stays in wash cycle

\015 GE GSD3230Z01WW dishwasher remains in 'WASH' cycle from 'START' all the way thru 'RINSE'. There is no water-fill, no pump-out. Timer rotates. Timer contacts & sequence seem perfect (I disassembled timer). Wire-discontinuity in door panel or motor-pump compartment?\015

Answers :

Solution found in a defective SPDT 'Heater ON' switch which had burnt out, thereby causing an 'open' to pump solenoid, fill valve, and heater. Temporarily bypassing the switch confirms the solution. Buy either the whole switch panel (3 switches) from parts dealer or find a source for CW Industries part GRS2012-13.
Repair Help & Product Troubleshooting for GE Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Not going through cycle it stays on wash it just stays on the wash cycle

Sorry to say but it sounds like it needs a new timer assembly, hit up your local appliance parts store. ... Haier Dishwashers

The machine fills ,drains and washes as normal. However when it fills the wash temp is 60 as normal but the rinse temp wont go higher than 76 deg C . when the wash cycle is on , the cycle stays on wash not progressing thru drain and rinse What is the cause?

Hello. Let me assist you. There are only two reasons for your problem - if you can isolate your problem based upon these descriptors you will know which part to replace:\015\012\015\012\015\012\015\012\015\012\015\012\015\012Water-he ... Dishwashers

Bosch dishwasher, Model SMU 7056, UC 09, FD 7309. My older unit has operated flawlessly for years. Two days ago it started to "stall" in one cycle and not progress to the next, e.g., stayed in the wash cycle and would not move on to rinse. In addition the heat generated in the machine was way below normal. A repairman told me that if the water doesn't get hot enough, the unit will not move on to the next cycle. I always use the "Regular Wash" option, but tried other options such as 'Economy

... Bosch Dishwashers

My Kenmore Dishwasher Model # 665.13832K601, wont change from wash cycle to dry cycle. It stays on wash until you stop the cycle and drain the water

... Dishwashers

De3861fw Hi, the machine stays on the same cycle time(cycle wash 5-84min; cycle wash 6-93min) The machine is on and sounds like it is running, but no water is entering, have checked the obviuos of water being turned on and also draining properly, but to no availe. Please help! Cheers

... Beko Dishwashers

I have a Kenmore Ultra 15895 or 15891. It fills with water then doesn't run. It will continue through it's cycles, but stays full of water. If I hit cancel before it completes the cycle, the number 2 shows in the display and nothing happens. If I let it complete the wash cycle, it will sometimes start and wash properly.

HI. The culprit will be the main control sector. This control fault may possibly be corrected by initiating a hard reset. the logic chips are scrambled, and this damage may be correctable by simply unplugging, or shutting off the appropriate circuit ... Dishwashers

501ht goes thru wash cycle but cam stops just before rinse cycle clicks in - stays in wash cycle - turned thermostat to booster down in temp -cam then keeps going properly but with no hot water from booster - replaced thermosat still same result - apparently a safety ? no booster water no rinse?

Did you get a solution for this? I am having the same issue. Please email me at [email protected] Thanks -Eric ... Moyer Diebel 24 in. 501HT Built-in Dishwasher

I have a Kenmore Ultra wash Quiet Guard 3 dishwasher and the green flashing light that states its clean stays on and stays flashing. I can not even get it to start a wash cycle. please help. What is the button sequence that everyone is talking about that clears this? Thank you.

Hi\015\012\015\012\015\012Thanks for using FixYa. To resolve this you will have to reset the console. Do this by closing\015\012the door and press these buttons in sequence...\015\012\015 ... Kenmore 24 in. 15689 Built-in Dishwasher

Our Whirlpool ADP5966 is not washing properly: the dishes do not come out clean and the soap mainly stays in the dispenser although it opens normally. The quick wash cycle is hopeless now and the longer ones still not good. We have cleaned filters, soap dispenser etc but still the soap stays in dispenser often turning into a concrete like block. Thanks

Hi, \015\012\015\012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms online ... Whirlpool 24 in. ADP5966 Free-standing Dishwasher

My Whirlpool is only a couple of years old too and it does the same thing. It stays on the wash cycle and the timer stays at 79 minutes. I have to cancel the wash to get it to stop and drain. Anyone know what is wrong with it?

If the timer does not advance. It is most likely a timer motor. ... Whirlpool 24 in. DU1050SS Built-in Dishwasher

I have a new FDB520RHS2A Frigidaire dishwasher which remains in the wash cycle after I've started it. It sounds as if it is changing cycles but the wash light stays lit and never switches to rinse. The machine continues to run for hours if I don't stop it. We've checked the drain to the garbage disposal and it is clear. the water temp seems to be hot enough but how do I check that? Any ideas on what we should check before we bring it back to the store? Your help is much appreciated. Thanks!

... Dishwashers

My dishwasher is seeming to stay on the wash cycle. How long is a normal wash cycle?

Dishwashers today use a lot less water and energy to do this they filter the water like crazy this makes the wash times go way up, the motor used today uses only a little power so a long cycle does not cost much. They average wash time fo ... Kenmore Dishwashers

I have a Bosch SHE44C05UC/43 dishwasher about 2.5 years old. It just started recently to stay in the wash cycle forever. The number on the LED panel decreases in the normal fashion, but the dishwasher never changes from the wash cycle to the drain and then rinse. I have verified the incoming water temperature is adequate

You must change the module. that will solve your problem. let me know how you made out.:) ... Bosch 24 in. SHU5305UC Built-in Dishwasher

Dishwasher stays in the wash cycle and doesn't continue though the rest of the cycles and doesn't drain unless the cancel/drain button is pressed.

Check this link for tips : Cleaning ... Dishwashers

Anyone have experience with a Fisher Paykel double draw dishwasher (model DD24) getting stuck in wash mode? Once it hits exactly 48 minutes it stays there. Only several hours later it cycles through OR you have to turn it off put it in rinse mode to complete. Already tried all the basics (unplugging, no fault codes, cycled through the diagnostics everything good and working). Did the quick diagnostic cycle of 14 minutes and everything cycled through fine. Next step will be to put the bottom cont

... Fisher and Paykel Dishwashers

I have a maytag dishwasher and the light wash light stays on even after a wash cycle. Tried to press normal wash and goes back to light wash. What could be wrong?

I have had numerous problems with the conyrol panel on this particular unit. Runs about $95 ... Maytag 24 in. MDBH950AWS Built-in Dishwasher

Just purchased bosch ascenta dishwaster. When the wash cycle is finished the clean and half load lights stay on. Is this normal? When do you know that the drying cycle is complete?

... Bosch Dishwashers

Long cycles My dishwasher (approx 7 years old) will run in the wash cycle for hours...until I physically turn the nob to "rinse"; then it will stay in that cycle until I advance the knob to the final (expel water) stage. I checked the filter and the blades - no obstructions. Also, when completed, the dishes are hot, so I know the heating element is working.

Http://www.thisoldappliance.com/library/bosch_dw_guide.pdf\012\012\012 ... Bosch 24 in. SHU43 Built-in Dishwasher

Hi. After completing the wash and rinse cycles, my Frigidare FDB750RC dial stays stuck just before begining the drain and drying cycle. If I turn it one click, then it drains and finshes drying cycle fine.

... Frigidaire 24 in. FDB750RC Slim-Line Built-In Dishwasher

Stays in wash cycle Whirlpool Dishwasher Du1050SS

My repairman contacted whirlpool about my washing machine staying onwash.. to his surprise.. and mine.. and his co=workers.. this is the answer,it worked.. and we have never heard this before.In your original istallation bookl ... Whirlpool 24 in. DU1050SS Built-in Dishwasher

Stays stuck in the wash cycle

... Whirlpool GU2300XTV Dishwasher

Whirlpool dishwasher stays on the rinse cycle and won't wash

... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

On any of the normal wash cycles, the digital timer only goes down to 42 and then stays there. The cycle just keeps on running until you manually shut it off.

My disewashar work 20 or 30 minits and then displeyd error F3 this is the problam. ... Kenmore Dishwashers

Kitchenaide dishwasher latch will not stay closed. It pops open during washing cycle and the machine stops and does not complete the cycle

The dishwasher was not properly leveled on installation. I used a carpenter's level\015\012and trued up the problem. The door now stays closed.\015\012\015\012However, the latch design is faulty in that it does not ever feel secur ... KitchenAid Dishwashers

GE Nautilus power scrubber model #gsc4008f00ww dishwasher. the cycle light stays on and the machine continues to beep when the door is locked. the wash cycle is done. i have tryed to reset it but the same thing keeps happening.

... GE Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0799 seconds