Having problems with your GE Nautilus 24" Built-in Dishwasher ?

No water comes into the machine, tapping the flood float doesn't help. GE nautilus

Answers :

Here is a tip that I wrote about that....


Repair Help & Product Troubleshooting for GE Nautilus 24" Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No water comes into the machine, tapping the flood float doesn't help. GE nautilus

Hi,Here is a tip that I wrote about that....http://www.fixya.com/support/r4021363-dishwasher_trouble_no_water_entering ... GE Nautilus 24" Built-in Dishwasher

Hi can you help me please I have a Zanussi DX6453 dishwasher which has stopped working. Having used the diagnostic facility it has come up with anti flood device, I have done the usual rocking the machine back and forth no sign of water. I have taken the machine apart and looked at the anti flood switch and this is bone dry and by lifting the float you can hear the switch clicking on and off. When I reassemble the fault is still there I'm begining to think the switch is faulty but not sure, do

... Zanussi 23 in. ZDT6255 Built-In Dishwasher

Dishwasher sounds as if it starts cycle, then stops, bleeps, and Fat and prewash lights come on. Manual says to turn off machine, turn off tap, wait 30 seconds and turn it all back on, but it doesn't make any difference. Manual says 'If the above does not solve the problem, check that the water feed pipe is not blocked' however, it doesn't say where this is, or how to do it. Please help!

Hi.You need to check the water inlet hose, that is the hose connected to house water faucet at the back of the dishwasher.Checck for blockage in the hose and ensure that the inlet hose is not blocked or kinked.If t ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a Bosch Exxcel dishwasher which runs the drain pump constantly even with the door open and despite there being now water in the machine at the cycle wont start. I have checked the warer amtrix and the ffed hose to the sump for blockages. The float switch operates OK but when the water drains down the float drops and the water is pumped in, then the float rises and water leaks out and the drain pump kicks in again and no more ater will come in unless you push the float down. Inside the bas

I am not sure about this model but most models run a drain cycle for a set period at the start of a wash cycle and then move on to normal filling and cycle of machine provided the various switches are at the low level it will carry on to its set cycl ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

Turn the machine on it makes all the right noises but there doesn't seem to be any water going into the machine. the hose that fills it is ok and water is coming through it . i just dont know where its going once its supposed to come out of the wash bars as they seem to remain dry please help

It sounds as if your inlet water valve or it's solenoid has failed.Please reply with the make & model # of the dishwasher.Thanks!!nc ... Dishwashers

Turn the machine on it makes all the right noises but there doesn't seem to be any water going into the machine. the hose that fills it is ok and water is coming through it . i just dont know where its going once its supposed to come out of the wash bars as they seem to remain dry please help

Your inlet valve has a screen on it.This is probaly clogged, it does happen. At the bottom of your dishwasher ther will be 2 - 4 screws holding the front panels on. UNPLUG FIRST! Remove the panel/s. TURN OFF WATER TO DISHWASHER! you Will have a cop ... Jenn-Air JDB6510 Built-in Dishwasher

Turn the machine on it makes all the right noises but there doesn't seem to be any water going into the machine. the hose that fills it is ok and water is coming through it . i just dont know where its going once its supposed to come out of the wash bars as they seem to remain dry please help Jenn Air Quiet Series

Hi\015\012\015\012 \015\012\015\012Thanks for using\015\012FixYa. It means that the water inlet valve has gone bad and needs to be\015\012replaced. Please do\015\012accept the solution if the issue is resol ... Jenn-Air JDB6510 Built-in Dishwasher

Water coming into bosch classixx dishwasher. It comes in through a tiny hole on the left side of the base between the salt cap and float. The water does not flow to the arms or the top arm. The pump to extract the water is working. Please help, thank you.

... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

My siemens dishwasher has the water tap indicator light on when washing starts. i have cleaned the water filter and the spray arm but the light doesnt go off and the washing doesnt take place. Instead i can just see water coming into the drain in intervals. what do i do?

... Siemens Dishwashers

The machine does not seem to rinse properly. We have checked the water fill level, water temperature, spray arms are not clogged, have determined it is not a hard water problem and have tried Glass Magic and CLR to verify the lattter. What else can we check to stop getting a film on everything in the machine? Plastics come out terrible, glasses and dishes foggy and sometimes still greasy. The model # is GU2700XTSY0 from the Whirlpool line of Quiet Partner 4. Any suggestions would help. Thanks!

Too much detergent; not rinsing well; hard water... There is an acid wash to revamp glasses/ you'd need to google it... ... Whirlpool GU2700XTSS / GU2700XTSY Built-in Dishwasher

My karcher hds 745 is running but just won't build up pressure, this occurred after a really cold few weeks this winter and I hadn't put anti-freeze through the machine to winterize it. There's no water coming from the bottom of the machine when it's running as i've read that if the pump seals are faulty water will escape from the pump etc. The machine motor runs ok but no pressure is acheived on the gauge whatsoever. Any help would be appreciated. Thanks in advance Paul.

... Karcher Pressure Washers

I have a Miele Dishwasher G1023U , after pressing on/off button the control panel light comes on in the drying cycle not the Wash/Rinse . Water does not come into the machine , can not turn it off at stop/start button only at Main on/off power button. Only had Dishwasher 2 weeks, was working fine. The water tap is on, no kinks in hose.

... Dishwashers

Jackson jp-24b purchased this machine used, cant figure out how to work it. I flip the auto cycle on, and then the power switch. The fill light turns green and i assume water is filling up in the machine. In the meantime there are two small red external hoses that hot water comes and i currently just have those hanging in the sink. At the same time, nothing is happening during the wash cycle, the wash gauge doesnt even move only the rinse gauge. Also when i try to drain it nothing happends (begi

It needs a new drain relay box 120 volt the drain is stuck open the jp 24 were not very good machines the red lines are drain lines if you plug up the drian lines at fillup the machine will wash but now it will never drain a new drain box is not c ... Jackson JP-24B Built-in Dishwasher

Had new kitchen so just re connected my dishwasher. Warning light to check water has come on. hoses and water going into machine seems ok but machine seems to be slow at filling. looked at filters in case of blockage with no result. Any ideas would be helpful please Merry Christmas Janice

I would remove the water line going to the dishwasher and let it run into a bucket. Sometimes on older shut off valves when you shut them off and try to turn them back on they get gunked up or dont open all the way. If you have good water pressure to ... Bosch Dishwashers

Something was stuck in the latch, which made the machine not start. I removed item, however, the lights come on, the heat comes on, bot no water or the rest of the cycle begins...help.. I have held down start/cancel and the heat dry buttons. I have unplugged the power for three minutes... I have taken the front covers off, looked through the latch mechanism but found no other issues. There is a little water left in the basin, so I checked to see if there was a clog, by blowing air into th

Hi,Sorry for the delayed response. Your problem dated 30th Sep 2009 was reposted today on FixYa. I am sure by now some other expert must have responded to your question and solved your problem.If this is not the ca ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Sometimes in my GE nautilus dishwasher I hear the water only dripping like from tap and not the spray and I don't hear the revolver moving its just like for the whole cycle water keeps on dripping like a tap has been opened onto the utensils there is no cleaning or rinsing action happening and the utensils don't come out clean. All during this time there is no leakage

Do you now anything abouth chip instaletion in to IAT? ... GE 24-7/8" Convertible Portable Dishwasher - White-on-White

Hi there My dishwasher (Miele G975 PLUS) drain light keeps coming on and the water won't drain. I can manually drain the water and the machine will then start again but as soon as it gets to the drain/rinse part of the cycle, the problem recurs. I have removed the non-return valve and it was clear of blockages so I am now out of options. The machine is only 4.5 years old. Any help would be appreciated. Thanks

... Dishwashers

Kenmore 17369 When cycle starts... it sounds terrible (crackly sounding).... doesn't sound like the water is coming into the dishwasher. If I add water to the machine during a rinse cycle...it will wash and drain on its own.... Then I hit cancel. Please help.. I can't locate the owners manual.. Do you know where I can get one.. I understand that you can open the bottom up and see if there is anything lodged in the bottom of the dishwasher. Please help! thanks Cheryl

The problem is your water inlet valve. If you remove the panel at the bottom of the dishwasher you will see\015\012either a copper hard pipe, or a flexible steel hose leading into the\015\012water inlet valve.BE SURE TO CUT OF ... Kenmore 24 in. 17362 / 17364 / 17369 Built-in Dishwasher

My dishwasher AEG favorit 525 worked perfectly but has been out of action for over a year. yesterday when I tried to use it, the on button is on continuously and no water is pumped into the machine. yes the water is on. the program button is also rotating as the programs change but no water comes in and I am not sure whether it will pump water out as I have not yet got there. please help.

Hi\015\012\015\012The issue seems to with the pressure switch that is bad and\015\012so won't allow the water to flow inside the unit. You can take it apart to\015\012check this. Hope this helps...please post back for further assistance. ... Dishwashers

Doesnt clean dishes, seems to be no water coming into machine

There should be about 2 inches of water in the bottom of the DW.  If it is filling but not washing the pump may be bad.  That might explain the loud noise (motor bearing).  I assume that the detergent cover is opening but no water is b ... Dishwashers

My Kenmore Elite Dishwasher (665.16499300) will not fill with water on the Normal Wash. It sounds like it's going through the cycle, but there's no water. I always run the hot water through the tap first. Oddly, the machine operates just fine in the Antibacterial Wash setting. Help would be greatly appreciated.

This machine is known to have a problem with the control panel. You need to get another one and replace the bad one that is in your machine. You should be able to contact sears and see about a replacement. You might even be able to get it done for y ... Dishwashers

My ge nautilus dishwasher is not having water run thru the cycles, i ran the machine 3 times and the dishes were still not washed and the tablet not dissolved. My husband sprayed water and cleaned the inside, he removed the filter basket and now the water he sprayed inside will not drain out!!! Please help!!!

... GE 24 in. GSD2220Z Built-in Dishwasher

Hi. I have a Siemens SE65E331GB Built in Dishwasher with an aquastop system. The problem is that it seems to be stuck at the end of a cycle. The pump is constantly running when stitched on. I won't top after a reset and it continues to run even if you open the door. The water supply light also comes on indicating that there is no water getting to the machine. I have tried resetting the aquastop as per the advice in other threads. This has helped in that the water supply light now stays

... Siemens Dishwashers

I have an ADP6000IX Whirlpool dishwasher which is comming up with a Fault code Err4. The manual indicates overfilled and possible cause "too much inlet water", however there is no water sitting in base of machine, and have unloaded all dishes and Err4 still comes up. I have switched unit on and off at wall but has not re-set. I have disconnected water pipe from tap and reconnected.Is there anything further I can do?

Hi, \015\012\015\012You can solve this by cleaning and de-greasing the filter frame, basket and sensor Also there might be a low threshold for oils/greases/debris of any kind, so you have to rinse and load. By removing outflow tube ... Whirlpool Dishwashers

No water comes into the dishwasher. I turn it on, the machine is running but no water. The water valve is open. Any assistance will be helpful

... Magic Chef CDB3100 - Multiple Color Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1444 seconds