Having problems with your Honda Maxus Prosumer MX5223 Pressure Washer ?

Timing belt broken - Honda Maxus Prosumer MX5223 Pressure Washer


Answers :

Repair Help & Product Troubleshooting for Honda Maxus Prosumer MX5223 Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Timing belt broken - Honda Maxus Prosumer MX5223 Pressure Washer


... Honda Maxus Prosumer MX5223 Pressure Washer

GX 340 Honda motor has no visible spark. - Honda Maxus Prosumer MX5223 Pressure Washer


... Honda Maxus Prosumer MX5223 Pressure Washer

Describe your Honda Maxus Prosumer 2750 PSI Pressure Washer w/ GX & CAT Pump - MX5223 Problem keeps dying


If it has a bowl on the bottom of the carb you float might be stuck, and check if the air cleaner is dirty ... Honda Maxus Prosumer MX5223 Pressure Washer

5.5 hp Honda pressure washer keeps throwing the timing belt off.


... Pressure Washers

Start problems The 1st time I tried to start my Honda 2400 pressure washer the pull cord came all the way out with no resistance and it wouldn't recoil. I took it to a repair shop and they said atyhe engine was shot due to a broken piston. How could this have happened and is a new engine the only fix?


... Honda Pressure Washers

The last time I used the pressure washer was running fine. A few minutes later I tried to start it up and could barely turn it over. I removed the recoil and could turn it a little easier backwards. The motor is a Honda GC190 on a karcher pressure washer and has 20 -30 hours of running time. Thanks Clint


... Karcher 2500 PSI Pressure Washer

Shark pressure washer with honda 5.0hp motor when in use spraying with good pressure it the pressure shuts off and motor sounds like its about to shove a rod through the cases shut it off restart it andd the same thing occurs all fluid levels good pump and motor. water pressure from hose bib good. may b low water pres. for short time due to possible kink in hose reel not sure


What type pump oil to usefor karcher 2400 psi ... Honda Pressure Washers

Dear Sir?madam, I bought a CV-240 4 MBC HONDA PRESSURE WASHER , 2400 PSI , 5.5HP, It is 4 stoke overhead, cam single cylinder , October, 2010 from NATIONAL HARDWARE SUPER CENTRE – GUYANA. I used this equipment sparingly during this year. I have 2 – 450 gallons plastic water tanks to supply the pressure with water. Recently, water is not coming out through the pressure hose. I talked to a technician, and he opened the water pump and there is some white plastic valve, one was broken and he repl


... Karcher 2500 PSI Pressure Washer

I HAVE A BRAND NEW TROY-BUILT 2600PSI pressure washer. I have used it twice for about 1/2 hour each time. It worked perfectly. I tried to use it today with everything hooked up perfectly. The Honda engine started perfectly; how ever when I squeezed the wand trigger, the engine instantley died. I let the engine warm up and slowley pushed the choke in. I let it warm up for plenty of time; but everry time I squeezed the trigger it instantly quit- it even backfired once before dying. I changed the g


Sounds like the governor is stuck. My pressure washer speeds up when it has to pump. Don't know if yours uses vacuum to trigger governor or direct linkage. Good Luck. ... Psi Blue Max 2200 High Pressure Gas Power Washer

I have a Northstar pressure washer powered by a honda GC160 engine. The last time i used it, water leaks from the bottom of the unit, whether it is running or not. When running, the pressure is fine. I have felt underneath and it appears that the water is coming from the second opening from the rear. Is there a pressure relief valve there. I have a manual but cannot find any descriptors for underneath the motor.


This is a piston seal issue. You can get a kit to rebuild the pump. ... Comet AXD 3020 G Pressure Washer Pump

Pull cord won't pull out on my power washer - Honda Maxus Pressure Washer MX5222


... Honda Maxus Pressure Washer MX5222

Timing marks honda 5.5hp gx160 - Honda Pressure Washers


... Honda Pressure Washers

Broken Belt Yes my name is Darrin & I am in fla & I have a Coleman Powermate Pressure washer Model # PW0751310 Serial # 9603 00653NU 120 VOLT, 14.5 Amp 60 Hz , 1300 Psi & I need a belt & some screws to repair it, Can you help me . Thanks Mr. Hardee


... Pressure Washers

Home Depot has a lawn mower with the Honda GCV160 Electric start version engine. They also have a pressure washer with the Honda GCV160 engine. I have a disability that makes it difficult to pull the starter rope. I would like to get the electric start on the pressure washer. My local Honda bike shop service center said they use different blocks. Can I get a pressure washer pump mounted to the Honda GCV160 Electric start version engine? If necessary, are there adapter plates that can be purchase


... Karcher 2500 PSI Pressure Washer

I am looking for the replacement procedure for the stator drive belt for a Mi-T-M HSP-2403-3MGH pressure washer. I am at the point of separating/removing the housing that covers the crank pulley, and I'm having a hard time separating and don't want to pry or tweek things a bit too hard.


... Mi T M WP-3000-4MHB Pressure Washer

I have used my Honda Pressure washer 3 times over a period of 1-2 years. I could not get it to start today. I did not drain the old gas but added some new gas (which was probably a few months old). I have never had problems with a lawn mower sitting for a few months; but my guess is, this is the problem? How can I repair this?


Check the oil level in the crankcase if it just spills out the oil fill hole it fine\015\012\015\012drain tank and drain float bowl and clean fuel tap make sure the carb is not green and blocked if so give it a good clean out ... Honda Pressure Washer PSI 3000

I have a Troy Built 2500 PSI pressure washer with Honda 160 CVG motor. It won't start. I've replaced the gas and spark plug. Every time I pull the spark plug out it's soaked. Not sure


... Pressure Washers

John deere unloader valve fix - Honda Maxus Pressure Washer MX5222


... Honda Maxus Pressure Washer MX5222

Broken pull cord - Honda Pressure Washers


Pull cords can be purchased from your local hardware stores. If the handle just broke off, and the cord is fine, the handle itself can be replaced. If you are uncomfortable performing the work, just look for 'small engine repair' places in yo ... Honda Pressure Washers

OUR KARCHER 2600 PSI PRESSURE WASHER W/ HONDA ENGINE WON'T START. WE BOUGHT IT A SAM'S CLUB LAST YEAR AND PROBABLY HAS ONLY BEEN USED ABOUT 4 TIMES. PLEASE ADVISE.


Hello:Have you tried changing the gas, Especially, if it has been in the machine of a while. Also some Honda engines will not start if the oil is low. Also try removing the high pressure hose before you start it? Do not run it very long wit ... Karcher Pressure Washers

Gx160 pull cord rope broken - Honda Pressure Washers


1. Buy a starter repair kit or get five feet of nylon rope similar to what was in the starter from a Lowe's, The Home Depot or the like.2. Remove the three bolts holding the starter on the motor and remove any remaining rope on the pulley.3. ... Honda Pressure Washers

I have a Lutian 168F pressure washer and the pull chrod mechanism is broken. One of the two small metal plates on springs has been lost and the other now slips out of its housing each time I use it. Any ideas please where I can get spares for it, I live in the UK. Thanks, Steve


... Pressure Washers

My honda 4000 psi pressure washer will not release water to the sprayer, and some times the pull cord can be difficult to pull. Is there something i can do to solve this issue?


... Honda Karcher G4000RH Pressure Washer

I have a Honda 5.5 hp pressure washer and it wont keep running I bought it off craigs list they said the last time it ran was almost a year ago I took off the carb and sprayed carb cleaner threwout but didn make a difference I cant seem to see any jets juist the float needle and that was clean if I pour gas in the carb it will run for a for about 5 seconds and but wont stay even if I choike it. does anyone have a answer


Try soaking the carb for 15 minutes in gasoline. If you have a plugged port just sparying may not be enough to clean it ... Honda 2500 PSI Gas Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0979 seconds