Having problems with your Hotpoint 23 in. BFI62 Built-in Dishwasher ?

Dishwasher trips the fusebox.

\015 I have a Hotpoint Aquarious BF12 dishwasher, it is about 10 years old. When I put it on now it trips the fuse, any ideas as to why?\015

Answers :

You have a obvious short circuit.
Remove the lower panel and inspect the drain valve solenoid attached to the pump beside the motor.
These GE solenoids will stick and melt causing a short circuit.
If not that, open the front panel and inspect all wires for a break.
Repair Help & Product Troubleshooting for Hotpoint 23 in. BFI62 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

ASKO D1706 This dishwasher was working well then it tripped out the fusebox and keeps on doing so. The on light is on when connected but when you shut the door it trips the fuse box on the house. The wiring looks ok, there is no water leaks in it. Any ideas

I agree with marine0612, It depends on when it blows the fuse box. ... Asko D1706 Built-in Dishwasher

Dishwasher trips the fusebox.

You have a obvious short circuit.Remove the lower panel and inspect the drain valve solenoid attached to the pump beside the motor.These GE solenoids will stick and melt causing a short circuit.If not that, open the front panel and ... Hotpoint 23 in. BFI62 Built-in Dishwasher

Hi there My Bosch Exxcel Dishwasher is tripping out the fusebox RCD and I think there is an earthing problem. It will run for 3 or 4 minutes and then the house alarm goes off and the cooker clock needs resetting! I have tried to look in the back but don't know how to remove the panels. I've tried tipping it to 45 degrees to see if there is any water in the innards but non water came out. I have no idea what to look for - and no manual to help me get inside the beast! Thanks in advance.

It will probably be the water heater element is failing and shorting out.\015\012\015\012Be careful as you do not want to electrocute yourself ! ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

I have a Bosch she44c dishwasher that I used just this morning. This afternoon I went to turn it on and a fuse in the panel box tripped. Is there something in the dishwasher that could go bad that quickly or is it most likely something else? Every time I reset the fuse and turned on the dishwasher, it tripped again. Leaving the dishwasher off, it doesn't trip.

Hi,\015\012\015\012In some cases, the heat element lining wears out and the element shorts out to the chasis of the dishwahser, thus tripping your fuse.\015\012\015\012In other cases, the dishwaser leaks water, and shorts out ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

IDL750 - Fuse trips when turned on. HELP! We had some electricians here to install a new electrical socket for a new fridge. They put the new socket in the same wiring as for my existing dishwasher!! The first time I tried to start the dishwasher cycle with the new fridge plugged in, the circuit box fuse tripped. Now, even with the fridge turned off, the dishwasher makes the fuse trip when turned on. Is there a fuse inside the dishwasher that has blown and needs to be replaced? or a ground brea

Hi.The first step is understanding if the problem is the socket or the appliance. Find an extension long enough to reach a different socket. Move the appliance to reach the power cord, and connect the dishwasher to a different power sock ... Indesit 24 in. IDL700 Built-In Dishwasher

Dishwasher I have had above integrated dishwasher which is intermittently tripping the mains fuse. Power is getting to dishwasher and the washing cycles work until a certain point (not the same time) where a loud bang can be heard and the main fuse is tripped. Reset the main fuse and power still gets to the dishwasher and it works again. It has just started to trip the fuse when its not running any cycle (just when power is getting to it). I've checked the fuse on the spur and it looks ok. I hav

Its quite common for the interferance filter to fail on these models its situated in the base of the dishwasher connected to the mains block usually when they fail you can see black dust around it, ... Neff 24 in. S5456 Built-in Dishwasher

My Beko D3422 FS was washing normally and the residual current device tripped approximately half way through the cycle. I have unplugged the dishwasher and checked the plug socket with various other appliances. None have tripped the RCD. I have stripped the Dishwasher to look for any disconnected terminals or shorted wires and cannot find anything obviously burnt or any signs of shorting. The 13amp fuse in the dishwasher plug is fine. Are there any components I can test or replace which wouldgi

... Dishwashers

My Hotpoint FDL50 dishwasher is tripping the fuse box circuit during the 1st stage wash cycle. I cancelled the wash cycle and switched off the dishwasher on the on/off button & the dishwasher still tripped the circuit.

... Hotpoint 24 in. FDW60 Free-standing Dishwasher

DI 67 Diswasher trips RCD fusebox

Either the element is faulty or poss the electrical filter. ... Indesit 24 in. DI67 Free-standing Dishwasher

Dishwasher Normally, after the dishwasher cleans the load, it displays green light next to clean. Once the door is opened, the light goes off an dishwasher is ready for next load. But from few days, after opening the dishwasher door, the clean light does not go off, it remains lit. Dishwasher doe snot reset for next cycle. So, I have to go in the basement and trip the main power to dishwasher. That resets the dishwasher. This needs to be done before each cycle. Not sure how to resolve the issue.

Make sure that you do not open the door during the wash cycle. Wait until all the cycles \015\012are complete before opening the door. Especially don't open the door \015\012during the drying cycle. ... Dishwashers

The dishwasher starts and initially rinses the dishes without heated water. In the next part of the cycle, the water is supposed to heat to a certain temperature.Beginning this morning, in this second part of the cycle,the dishwasher trips the circuit breaker. If you reset the breaker and turn the sihwasher back on, the breaker trips again. What is wrong and how do I fix it?

Hi\015\012\015\012The issue is with the heating element of your dishwasher, it is withdrawing very large amount of power and thus, the circuit gets overloaded and circuit breaker trips. You'll need to check for any short circuits around t ... Dishwashers

I have a aeg 43070 vi dishwasher It keeps tripping the circit breaker on the house fuse box . I have reset the leak cutout by dipping the dishwasher back and stopped the warning sound,but went for about a minute and then trip the electrics again . any ideas whats wrong ?

I assume you are refering to the earth leakage circuit breaker. This trips when a earth leak fault has occured. The normal cause for this could be\015\012A) Water leaking via a pipe at the bottom comming in contact with one of the electric moto ... AEG 23 in. Favorit 44070Vi Built-in Dishwasher

Hi In the middle of a wash cycle, my dishwasher tripped the circuit breaker on the wall. I diagnosed this by unpluggin dishwasher, plugging in a different appliance and switching circuit breaker back on. new appliance worked OK. When dishwasher had cooled, I tried it again on same circuit (which I knew was working properly). The lights came on for about three seconds, and then the circuit breaker cut back in again, so I knew it was the dishwasher that was causing the problem. Is there anyt

Ck the connections where the cord hooks to the wiring harness. look for hot or shorted wiring . also ck the contro panel for the same . generaly if you have a power draw like you are saying then you can see t ... Dishwashers

Maytag MDBH965AWQ I have a Maytag dishwasher model number MDBH965AWQ. A few weeks ago the clean and sanitized lights would not go off after the door had been left open for over 30 seconds. Then last week, the diswasher would shut off in mid cycle and all lights would turn off with water still in the dishwasher. Today, I noticed that I am able to open the dishwasher door while the dishwasher is running and it will continue to run like the door was never opened. Now it is starting to trip the brea

2 items in need of testing are the door switch - and the main controller board/timer unit.CLIC ... Maytag 24 in. MDBH965AW Built-in Dishwasher

Re; Smeg DWD612CSS dishwasher. Please help. On setting our dishwasher to operate overnight, we were awoken by a loud bang only to find a strong rubber burning smell and the trip had blown. After investigating we found that the part no DWF 409 interface filter required replacing which we have done. Now however the dishwasher runs to the middle of its cycle and stops. The troubleshooting page of the manual tells us code E3 applies i.e.first 2 phase lights are lit and states "The appliance is not

I would first look for anything that may be stuck anywhere in the machine that may be causing it to come up with an error. Possibly something that was in the dishwasher is making it think it can pump out the water even though it is draining.\01 ... Dishwashers

Got a Indesit Di620 Dishwasher that trips RCD after power up & immediateley as you shut door.Fault is definately related to pressure switch, disconnected pipe to switch and then able to start cycle, without tripping, small amount of water out of pipe,but cycle only lasts for a few minutes, then stops. ( blowing into pressure switch trips rcd )How can i test switch, or is it a water level problem ??Any help would be good, thanks S.C

... Dishwashers

Hobart AM14/1 free standing dishwasher with booster. Booster will not heat up beyond 41C. All three heating elements check ok with Ohm meter. High limit not tripped. Temperature screw up at maximum, when you turn the screw, you can hear thermostat click at lower temperature on and off. When turning on main power for dishwasher, heater in dishwasher works fine, but no relays click in the booster tank area. Have not checked for power at booster, have checked all fuses with meter and are ok. Ple

... Hobart AM14-253 Free-standing Dishwasher

My Hotpoit FDL570g dishwasher (that is less than 2 years old) is tripping the circuit breaker originally during a wash and now when the unit is switched off and and door is closed. I thought it may be a door lock / microswitch problem and replaced the microswitch. The dishwasher was good for four seperate washes but now the problem has come back when crockery is loaded when the machine is switched off. I'm going to check for bare / rubbed leads but not expecting to find this with a dishwasher of

Hi,\015\012\015\012If your washer is tripping the breaker when it is switched off, this is often a sign that water has leaked - or is leaking - into the bottom of the washer under the washing compartment where there are lots of exposed el ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Leaking FDW60 I have a Hotpoint FDW60 dishwasher. yesterday it tripped our house electrics and then we had water flooding out of the dishwasher. Through a process of elimination I have now discovered that water is leaking from the drainage sump in the centre of the babse down onto the motor or other electrics. I have looked for loose hoses and there are none visible from the base of the dishwasher, can you give some ideas where the water might be coming from?

Had a similar problem when I removed the lower spray arm for replacement (see http://www.fixya.com/support/t234402-fdw60_dishwasher ) and didn't put the centre retai ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

My KitchenAid dishwasher model # kudp01ilbl2 won't start. It is the first time we're trying to start it since we had our water heater replaced (three, maybe four days ago). Not sure how much that may matter. I tried turning off electricity to the dishwasher at the fusebox (overnight), but that did nothing. Normally, you just need to hit the start button and the washing begins. Now, nothing happens. The dishwasher is about six years old.

... KitchenAid Dishwashers

Trip switch My Dishwasher keeps tripping my trip switch in the electric box everytime i turn it on

Is the dishwasher on its own circut breaker if so whats the size ... Hotpoint 23 in. BFI62 Built-in Dishwasher

Faulty Diplomat Dishwasher - tripping mains fuse

Hello, \015\012\015\012My dishwasher a diplomat 12 program (hja8640) was doing exactly the same where every now and again when turned on at the plug it would trip. After engineers coming out several times and failing to fix it, they cond ... Dishwashers

Hotpoint FDW80P dishwasher trips fuse box when the door closes and before this when it was on the dry cycle

... Hotpoint Dishwashers

My dishwasher keeps tripping the circuit.

It seems more of an electrical problem but at the same time it's associated with the operation of the Dishwasher controls too. So even if you can just call an electrician he may not be having the know-how of the Dishwasher, whereas any Dishwasher rep ... Bosch Dishwashers

Dishwasher tripped our main circuit breaker.

It may be that your water pump is leaking on to the motor... ... KitchenAid KUDR01TJ Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1153 seconds