Having problems with your Kenmore 24 in. 15782 / 15784 / 15789 Built-in Dishwasher ?

My dishwasher 15789 kenmore built in seems to have shorted out it was clicking on and off... i secured the latch better and restarted - it stopped right after filling... no it won't respond. there is power going to it


Answers :

Repair Help & Product Troubleshooting for Kenmore 24 in. 15782 / 15784 / 15789 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dishwasher 15789 kenmore built in seems to have shorted out it was clicking on and off... i secured the latch better and restarted - it stopped right after filling... no it won't respond. there is power going to it


... Kenmore 24 in. 15782 / 15784 / 15789 Built-in Dishwasher

I have an LG dishwasher, model LDS 5811ww. The machine fills with water, then stops filling when the error code IE comes on. I have cleaned the inlet filter and the whole inside of the tub, by taking apart the sump filter. There is good water pressure filling the tank. When I turn off the power and restart any cycle, the pump will empty the tank, then begin filling the tank again...until it is stopped by the error code IE again coming on. The other thing I notice is the water level in the tub.


Sounds like you either have a dirty or faulty water level sensor or water temp sensor. Most likely a dirty or faulty water level sensor ... Dishwashers

Dishwasher wont fill with water. just before it stopped filling i was turning the dial (a lot) between the wash cycles back and forth to attempt to get it to fill and drain (I didn't let it go through a cycle). We also removed the hose from the machine as it had split and replaced it and we had the machine tilted on it's side. the dial still clicks round but it sounds like the pump is going and it doesn't seem to be filling with water. Help


Hi. I suspect that the timer mechanism will be the culprit here, but i recommended to inspect and test the water inlet valve, before replacing the timer. The valve is a known problem area, as well. Follow the valve inspection procedure below, careful ... Fisher DS603W / DS603B / DS603I Dishwasher

I have a zanussi ZSF2440 dishwasher, when it turned on by the power button on the front you can choose a cycle and start it, Once the cycle is started it fills up with water but doesn't stop until it over flows setting off the flood protection, which cuts the power, so all the lights on the display go off and stops the water flow and drains the dishwasher and keeps draining the dish washer while the flood protection is on. It seems as if the dishwasher doesn't know when its reached its correct


... Zanussi Dishwashers

My dishwasher stop working in the middle of washing cycle. The water has not drained out completely. I attempted to restart the dishwasher but it appears there is no power. I checked the power auto swithch/fuze on the master fuze board. There is still no power going through the dishwasher.


... Dishwashers

Haier dishwasher CDW300SS beeping 10 times and 4 lights flashing,,, help The dishwasher will work, it fills, it washes and it empties, BUT will not start now, and the 10 beeps and the four lights flashing,, so wont restart and go throught the program... Is there some way of resetting the dishwasher to restart. help thanks. glenn


... Haier Dishwashers

Continuous alarm after a power failure an alarm started going off in the door of the dishwasher. the push button panel is not functioning. I opened the door panel and found an electronic control circuit board. It is this board that is making the noise. I unplugged the black and white pair of wires on the lower right side of the board and the noise stopped. this must supply power to board. Anyone know what this problem is?


I posted this under "Ben's" problem as well, but I had the exact same problem. I know which black and white wires you're talking about. I don't know what causes this, but getting new parts did fix it. The black box that all those wires go into on ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

The dishwasher fills, heats and starts washing... The washing cycle lasts for about 5 seconds then stops,, then restarts,, this occurs about 4 times then the unit shuts down and all lights go off..


... Amana 24 in. ADB3500AW Built-in Dishwasher

Kenmore elite 1393 worked fine for a week or two then began to stop in mid cycle,we could drain the water and try again but would shut off almost immediately. sometimes trying to restart it there would be NO power to any buttons, after waiting for awhile the buttons/lights would work again but the washer would not run a full cycle.blue light would light then go out within a minute or so.


... Dishwashers

Whirlpool dishwasher model DUB700XB has quit cycling. Fills with water but will not start wash cycle. Making intermittent humming noise unless the door is open to disengage the switch, even when on stop. No LEDs lighting when rotating the dial through the various cycles. Unit is old and wondering if it's better to buy a new one rather than fix this and have something else go wrong in the not to distant future. Thanks in advance


... Dishwashers

I have a new ice maker im34 and I put in. I have power going to it. When i turn on the water it keep over fill the I make rand want stop runing water


... Frigidaire IM34 Complete Icemaker Kit

My dishwasher just quit during the cycle but it still has power going to it none of the lights on the door will work now and it wont restart


There is a thermal fuse located in the control panel that is probably blown out.Open the control panel by removing the 6 screws around the top inside of the door. The thermal fuse is located on the top right side. Remove the wires from the fuse ... Maytag MDB4621AW Built-in Dishwasher

Just got a used F&P Smart Drive 5.5 MW059. First few times I used it wouldn't always start on certain settings but once it did start it ran through just fine. On the fourth use, it was very difficult to get it to start and it just stopped after it filled up. Pausing and restarting, shutting of machine and retrying did not help. Was able to advance to rinse mode and got machine to drain water; however, instead of going into spin mode it just attempted to drain continously. I let it do its th


Did not realise this is a washing machine and not a dishwasher.\015\012\015\012Looks like some consultant has already been dealing with you on this problem.\015\012\015\012Hard to say if it is a simple as an inlet solenoid val ... Dishwashers

My dishwasher stopped in the middle of a cycle and is full of water. Breaker is good and power is at dishwasher but will not restart and no lights will go on when buttons pressed? Any ideas?


I replaced a thermal fuse located under the control panel. A power surge likely the cause due to a storm passing thru town. ... Kenmore Dishwashers

Was running fine till ran out of gas ........fill tank up ...try to restart it .......wont start replaced plug ........still no go .


Recurring issues with honda engine no start. Engine was thought to be out of gas however engine was actually shut down by oil alert. Check/change oil to reset, or unplug wire from oil alert and check engine. Vacuum in fuel system due to faulty fuel c ... Honda Pressure Washer PSI 3000

I have a Bosch SHU66C02. I opened the door to stop it from running temporarily, while it was sitting not running, it leaked all of the water out of the bottom right corner of the door, and when I went to start it later it just hummed but the timer didn't go down for over an hour. I tried to put more water in but as soon as I started I could hear the water added to drain. I turned the breaker in the fuze box off to it and let it sit for over an hour, but when I restarted, the timer was still at


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Our Maytag MJD3005 dishwasher got a couple of minutes into a cycle then displayed E4, stopped and beeped. I cleaned the filter basket out (which needed doing), powered down and up and restarted. Then a couple of minutes into the cycle E2 appeared as (I think) it doesn't enter the wash phase (fills OK). Repeated on different programs with the same outcome. Any clues?


... Maytag Dishwasher

Dishwasher issues hotpoint dishwasher model HDA1200 used for a year and put into storage for a year. reinstalled this weekend. dishwasher was fussy about the door latch for a minute...door latch did not want to engage all the way...but went into its cycle. we stopped it and added a few dishes for a test run it started right up and ran about 8 minutes and shut itself down. it will not restart. the power supply is ok. no leakage about the door once latch engaged. what can we do?


It can be the 10A fuse located in the back of the machine. but.... storage is kind of a problem with determining what is wrong with it.\015\012Mouse can have chewed the wires, moisture can have rusted or corroded some components.\015\012C ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Have a whirlpool ADP 951 and no manual for it. Is was working fine and now the red light in the left hand corner is on and machine wont fill. When I start it by holding the button on the right hand side in, it will drain for about 30 seconds and then stop and green start light flashes. Can anyone offer a solution?


Some mod have codes / could be suds lock or slow drain . i would ( if front loader ) clean out pump . hope this helps . **** ... Dishwashers

Kenmore dishwasher has loud noise during fill. If you let it go, the washer fills. Once filled, noise stops and wash cycle continues. Sounds like plumbing does when there is air in the pipes. Not a grinding sound. Very deep pitch. Stops when the washer fills with water.


This isn't a solution but rather a comment, if the problem is happening only during the fill, then it could be the water inlet valve. Perhaps there is a soliniod going in the valve, watch to see if the fill cycle starts to dimminish over time. Does t ... Kenmore Dishwashers

KitchenAid KUDL03IVWHO Machine seems to stop after the initial water fill. There is power to the machine, the door latch circuity is working, all the buttons on the control pad light up. After selecting any of the wash cycles and pressing start, the washing light illuminates and the machine fills normally to the point where the fill valve stops the inflow of water. At this point the machine stalls, it does not start the cleaning process. I can press cancel and the machine drains normally. I e


Hi,\015\012\015\012You have got to the correct resolution. This is a circuit or most commonly called the board problem. Please find the bellow mentioned link which will help you to get one compatible for your washer.\015\012\0 ... Dishwashers

Wont go through cycles or drain the 3inches of water.Is getting power


Turn on the dishwasher then go to your circuit breaker and, switch off\015\012the power to your dishwasher next: reach in to your dishwasher and\015\012remove the cover on your pump then remove any broken glass etc. that\015\012has fallen into the pu ... Hotpoint 24 in. HDA2000Z Built-in Dishwasher

Miele dishwasher pump wont stop wont fill with water


... Miele Dishwashers

My aeg favorit 35085 dishwasher starts it program fill with water then stops if i drain the water out and restart the program it starts again fills with water then stops any ideas


... AEG 23 in. Favorit 50750Vi Built-in Dishwasher

My Dishwasher starts, then stops after 30secs and won't continue draining. Everytime I turn it back on it comes up on the steam cycle and won't go to any other cycle, drains for 30secs and stops again. Power light is flashing. Have tried holding power button down for 10secs with no effect. Filter is clean, pipes are straight-no kinks. How do I get it to start working again? It is a whirlpool dishwasher, ADP5550.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1066 seconds