Having problems with your Kenmore Dishwashers ?

My Kenmore under counter ultra wash dishwasher leaks.

\015 My Kenmore under counter ultra wash dishwasher model 665.15825691 has started leaking at the lower corners of the door. The leaks seem to occur during the final rinse while the water is being heated. I have tried cleaning out the door bottom and the tub edge where the door and tub interlock. There is no gasket in this area. What might be causing this problem?\015

Answers :

Repair Help & Product Troubleshooting for Kenmore Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Kenmore under counter ultra wash dishwasher leaks.


... Kenmore Dishwashers

My Kenmore under counter ultra wash dishwasher model 665.15825691 has started leaking at the lower corners of the door. The leaks seem to occur during the final rinse while the water is being heated. I have tried cleaning out the door bottom and the tub edge where the door and tub interlock. There is no gasket in this area.


Happened on my dish washer too. Remove lower rack, remove lower spray arm by removing the center plastic nut, check screws (torx) on outside edge of pump. Tighten these as necessary, mine were loose causing water to spray forward against the tub c ... Kenmore Dishwashers

Kenmore Elite Ultra Wash Dishwasher 665 1343 leaks intermittently from bottom of control panel


... Dishwashers

Help - the screws holding the dishwasher under the counter came loose & fell down the drain... how do I disassemble the interior to retrieve them? Kenmore Elite Ultra Wash Dishwasher, model 665.16269402


Yes remove the baskets and the spray arms and the flowplate assy get the screws and reassmble. good luck ... Kenmore Dishwashers

I have the kenmore elite ultra wash dishwasher. The model is 665.1375. It seems that when I add the liquid for the jet dry finish we have a leak from under the unit to the kitchen floor after the wash. Hmmmm....


... Kenmore Dishwashers

10 year old Kenmore Ultra is leaking early in the washing cycle. Wondering if this is worth fixing or need to bite the wallet and buying a new one. I am worried about affecting the new cabinets even though the dishes seemed to be clean on the two occasions that the dishwasher has leaked. Only need a somewhat simple machine- I'd appreciate any suggestions as to what brands I should research if buy is the conclusion. Thanks.


At 10 years old I wouldn't put much if any money into it. Do check the water connections as it may be something simple that just needs to be tightened or a washer replacement. Replacing the valve is a simple and inexpensive fix but don't bother going ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Kenmore ultra wash dishwasher leaks


... Dishwashers

Kenmore ultra wash dishwasher leaks from the bottom of the door edge


You electic water valve is sticking open, they get sand etc in there, and can not close, and will not shut the water input off. Do you have city water, or your own well water? Very common problem with well water, sand will clog the return of the wa ... Kenmore Dishwashers

Kenmore Elite Ultra Wash Dishwasher Model665.1379 leaks out of the front door.


... Kenmore Dishwashers

Kenmore ULTRA WASH Portable Dishwasher Model 665.1784 leaks


I have had my dishwasher for 10 years never a single problem , i connected it turned it on , it filled with water then it just shut down down won;t do a thing. any ideas? ... Dishwashers

Kenmore ultra wash dishwasher 665-15791791 leaks on last cycle


... Amana Dishwashers

I have a kenmore Ultra wash portable dishwasher that leaks water through the faucet connection. I tried to push the red button to loosen or clean the connection ams stop the water from dribbling out.


... Kenmore Dishwashers

Has anyone else had the Kenmore elite ultra wash melt the rubber gasket running along the bottom of the dishwasher frame in the front? It is not leaking yet.


... Kenmore Dishwashers

Kenmore ultra wash leaking - Dishwashers


... Dishwashers

Kenmore ultra wash dishwasher leaks at faucet


... Kenmore 24" Portable Dishwasher - White

Small Burn spots on interior tub below heating element. These spots have small cracks in center of them, and leak right through the bottom of the tub, dripping water all over under the dishwasher. Nothing has falling into the bottom of the tub, and nothing has touched the heating element. What in the world could be causing this to happen? Kenmore Ultra Wash Quiet Guard 4 Mod.# 665.1603* Purchased new from Sears 2006


Hi,\015\012\015\012The heat from the element when the dishwasher is in the "drying" mode has caused the bottom to stress crack and become open so it leaks...\015\012Ultimately this will cause you to have to replace the dishwasher... ... Kenmore Dishwashers

Kenmore Ultra Wash III Dishwasher will not drain properly


From the sound of things, your dishwasher drains faster than your sink drain ( via the garbage disposal) can drain it off.. You may have a problem with the way your sink drain/trap is vented and there is too much back pressure to drain down quickly.. ... Dishwashers

Kenmore Ultra Wash III Dishwasher will not drain properly


Fixerfailure, is the knock-out plug still inside if the garbage disposal inlet?\015\012\015\012Stick a screwdriver in there to make sure.\015\012\015\012spazmo1969, could be the rubber flapper is broken off in the pump dischar ... Kenmore 24 in. 15932 Built-in Dishwasher

I have a Kenmore Ultra Wash Dishwasher (Model Number 665.15634) that will not fill up properly. When I try to run a cycle (any cycle), the first thing the dishwasher should do is fill up with hot water. But in my case, my dishwasher fills for about 10 seconds, then stops. Then tries to fill again for about 7 seconds, then abruptly stops again. And this process goes on and on and on. The dishwasher never fully fills up nor starts the wash sequence properly. Once the dishwasher fills up, it


... Dishwashers

Dishwasher hums I have a 2003 Kenmore Elite Ultra Wash Dishwasher model #665.17469300. I started the wash today. The water came in the unit and started washing then I heard it stop and it just started making a humming noise. I was afraid it was going to overheat or something so I cancelled the washed and it drained out. I started the unit up on a different cycle and the water came in the unit but did not wash it just hummed so I cancelled and drained it again. I did that on all cycles and the sa


... Kenmore Dishwashers

Kenmore Ultra Wash leaking from door


... Kenmore Dishwashers

Kenmore Ultra Wash Dishwasher LIghts are blinking....


I suspect for either of these units that the timer control boards are bad. ... Dishwashers

My dishwasher so my dishwasher seemed to have quitworking during a cycle. like breaker triped or something. i checked the breaker and thats fine. it seams like its hard wired in though. Would that be right? and is there a fuse or something that could/would blow during a wash? I dont know what model it is or anything it was in the house when i got it. The dishwasher is built in and it seems decently old its a kenmore ultra wash and it has like 10 buttons for the differend cycles on the left and a


Sounds like the fuse on the control blew. you can replace the fuse for\015\012around $20 or you can cut and splice the wires for free. If that doesnt\015\012work then you may have a loose conection in your junction box under the\015\012dishwasher. ... Kenmore 24 in. 15932 Built-in Dishwasher

We have a Kenmore Ultra wash dishwasher Model # 665.13733K601 and serial # FW18136133. came home from work yesterday and the pots and pan button and the normal wash buttons were flashing alternately. When I pushed the cancel button it started to flash, then I pressed the smart wash button and now its flashing. I turned of the breaker for awhile and then back on and the lights weren't on right away but later started flashing again, and I can't get the dishwasher to do anything. Any help on my pro


Hi,\015\012That unit took a power surge and the control is now bad....those controls can all of a sudden go wacky and the usual cause is power problems...\015\012The only way to fix it will be to replace the control...\015\012 ... Dishwashers

Dishwasher malfunction I have a Kenmore Ultra Wash Quiet Guard 3 dishwasher. One day, I found it with a blinking green ?clean? light. I went online to search for the manual, almost impossible to locate. Found a website where another using said to hit a 4 button sequence of ?heated dry? ?normal wash? ?heated dry? and normal wash. After this sequence, all lights went on and something that looked almost like a ?demo? sequence began (not sure now what that was). I hit ?cancel/drain? and it proceeded


Hi,The flashing light indicates that the control did not sense a 3 degree temperature rise with an 8 minute test. There are many reasons this could happen with a working heater. I put together a page that shows the reasons and you might b ... Kenmore 24 in. 15689 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1598 seconds