Having problems with your LG 24 in. LDF7810 Built-in Dishwasher ?

LE error my new ( 2.5 years old )dishwasher just broke it is LG model LDF 7810ST I got the LE error dont know what this mean and what can be worong with it ....it starts for few minuts and stop any idea please help


Answers :

The first thing to check with an LE error on an LG LDFxxxx dishwasher is the drain hose. Start at the point where the drain hose connects to the drain pipe or garbage disposal. Make certain that the hose rises as high as it can. That will form a high point that will prevent the natural siphon effect from draining the water before it should.

Please report back here with what you find. OK?

Good Luck!
I got the same problem.
Ordered the replacement part ($$$$) and installed it. No joy.
Then based on other internet posts, I opened the front panel.I discovered that almost half the wires in the front panel had been pulled tight, and had seperated the wires, and on some others the insulation.
This is a HUGE flaw in these dishwashers. It will probably take someone being electrocuted or a series of house fires before some consumer products safety division forces a recall of this very flawed product.
In my case, I went to Radio Shack. Purchased some wire that was beefy enough for the application. Sat with a soldering iron and some heat sink tubing, and extended with wiring harness in the door.
The problem was solved (for a year). Today, I now get a tE error when turning on my dishwasher.
I am beginning to wish I had never purchased this dishwasher. I will NEVER buy another LG appliance again.
Repair Help & Product Troubleshooting for LG 24 in. LDF7810 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

LE error my new ( 2.5 years old )dishwasher just broke it is LG model LDF 7810ST I got the LE error dont know what this mean and what can be worong with it ....it starts for few minuts and stop any idea please help


The first thing to check with an LE error on an LG LDFxxxx dishwasher is the drain hose. Start at the point where the drain hose connects to the drain pipe or garbage disposal. Make certain that the hose rises as high as it can. That will form a h ... LG 24 in. LDF7810 Built-in Dishwasher

I start the dishwasher & after about 2 minutes 9E code comes up which manual says it means low water level error - we shut off circuit breaker & then turned back on & didn't help - HELP PLEASE


... Samsung DMR78AHS Builtin Dishwasher

I have a prima lpr600 fully integrated appliance. it appears to start - emptying machine to begin with, then starting to pump in water - but then starts to beep continuously! the display light flashes 11 times before a pause, but i cannot seem to find what this error code means. please help!


... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Kitchenaid kuds01dj model. washer fills with water then stops and then the motor hums and does not seem to engage. after a couple of minutes water drains out and the fill process starts again. as before motor hums gets really hot but doesnot engage. does this mean i need a new motor, capacitor? please help


... KitchenAid KUDS01DJ - Multiple Color Dishwasher

Hoover dt999 hi i am andy and my dishwasher starts a cycle gets a few minutes in flashes up E4 stops cycle and beeps,, no manual so no idea please HELP!!!! cheers andy


E4 Error on other machines (eg. Baumatic) means that the bottom catch tray (condensate trap) below the machine has too much water in it. This condensate is supposed to evaporate away, but too much will mean it builds up over a period of time. There i ... Hoover 24 in. DT999 Free-Standing Dishwasher

Error Code I just put my dishwasher for a cycle. It started making some weird noises during the rinse cycle and now it came up with a code LE. What does this mean??? Please help.


LE stands for a locked motor. If the motor has gone it has to be replaced. In some case though, depending on the age of your unit, it could be a broken wire in the door. If you remove your front panel (6 screws) you can have a look, but turn off t ... LG 24 in. LDS 5811 Built-in Dishwasher

I have a Kenwood Dishwasher KDW12ST3A. P1 cycle stops after about 40 minutes and shows on the screen an error code of 'E3', Not sure what this means as I have mislaid manual. Can you help please?


... Kenmore 15762 Dishwasher

My aeg favorit integral dishwasher is flashing 20, and there is water still in the bottom that will not drain away please help. and every time i put the dishwasher on it starts but after a couple of minutes it stops beeps intermittently and says code 20! please help thanks


... AEG 24 in. Favorit 60830 Free-standing Dishwasher

Indesit IDL 705 dishwasher, when i start my machine it starts properly, but after 3 to 5 minutes pre wash and rinse bottom starts blinking repidly, i cleaned filter but its the same, please help me


Same issue here, also on a 705, gnerally accompanied by what looks like a short tripping the fusebox. ... Dishwashers

Hi. I have a Dishlex global 300 series and it starts going through the cycle ok but after about 5 minutes it starts to fill up again and the eco light starts to flash and it won't stop filling up and draining. can you please help me.


The operating manual says under problem solver thatin such a situation it has an incorrect fill level or fill time and recommends then the need for a service agent.\015\012\015\012Try holding the start and programme buttons down at the sa ... Dishwashers

IDW450 dishwasher starts working then after about 7 minutes stops - beeps about 6 times and stops completely - the dishes are wet but the dish washer tablet door is not open . - can anyone help - then on the odd occasion it works perfectly without stopping but this is getting less frequent . Can anyone help please .


There is probably a leak under the tub., Water drips into a catch pan and sets off the beeping. Take the kick panel off the bottom front and see if there is any water in the pan. If there is you can drain it or blot it. BUT this is an indication of a ... Dishwashers

I bought a new kelvinator diswasher kd12mm1 - will not start, and shows E1 error. No water? but the connections are all done properly and the water is open. My previous machine had no problem with water pressure. I do not have salt yet... can that be the cause for the machine not starting? Please help


... Kelvinator Dishwashers

AEG Diswasher Model / Favorit 44080IM PNC 911925601/01 (located in UK) Wash cycle finish light flashes 5 times in sequence then starts again - please advise the meaning of this error signal ? History Machine started running immediately door was closed before any programme selected filled with water and main was motor runs and circulates water Water is not heated and detergent door has not opened Machine will continue to circuluate water until turned off If reset used then


1 blink is machine is having major power supply problem.the power supply board needs replacement.\015\012-----------\015\0122 blink is CCU error.that control board problem.\015\012-----------------\015\0123 blink is the CT error.that is ... Dishwashers

Our dishlex global 310 will start to fill with water and then will get to the pre wash stage, then will completley stop and start flashing rinse? I have no idea whats going on please help!


This is an error code and means the wash motor has failed & needs to be replaced. ... Dishwashers

MY GHDA485N10CS GE DSHWSR STOPS SHORTLY AFTER I SELECT THE TYPE OF WASH THAT I WANT, PRESS START AND I CAN HEAR THE MACHINE STARTING TO FILL UP. IN ABOUT A MINUTE EVERYTHING STOPS. PLEASE HELP


... General Electric GHDA485NCS Built-in Dishwasher

Just installed bosch SHE68E15UC dishwasher today and during first cycle E15 error came up and unit will not go into another cycle or allow me to program anything else - sanitize and rinse aid lights are blinking - water went into the machine and it started filling the bottom and wasnt draining - i then adjusted the filter and the water drained - but e15 error persists - what should i do - is it install issue or machine issue - please help- thank you so much


... Dishwashers

Error 4 when i turn my hoover whisper, it runs for a couple of minutes then it starts beepinng and the light flashing E4, i no longer have the manual therfor i don't know what Error 4 means.


Check out the following link... i think it will be useful for u...\015\012\015\012\015\012http://www.fixya.com/support/t1213494-di ... Hoover 24 in. HD98E Built-in Dishwasher

Hi I have a Whirlpool ADP60001X, 4 years old. Problem - Error 4 showed so I fixed that then started another cycle and it shows up error 1 now - what does that mean & how to fix - help would be appreciated thank you


... Whirlpool 24 in. ADP6940 Dishwasher

LG LD-12AW2 HI, MY DISHWASHER IS STARTING IT'S CYCLE THEN COMING UP WITH THE OE CODE A FEW MINUTES IN. bEFORE IT STARTED DOING THIS IT WAS LEAKING AND THEN DISPLAYING THE OE CODE. WE LIVE REMOTE AND HAVE NO TECHNICIANS FOR 800KM, PLEASE HELP


This unit has an anti flood device. if it leaks it lifts a piece of plastic in the base and hits the microswitch. try leaning the unit to one side and i would put towels down. if water comes out then try a program. hope this helps. ... LG 24 in. LD-12BS6 Stainless Steel Free-standing Dishwasher

My 450 pro Viking dishwasher (only a couple of months in use!)has both lights of normal wash and light china on, as well as the power light on. I cannot cancel program or start. It goes nowhere. Can someone please help me? I have 5 young kids at home and this is my idea of a nightmare! HELP!!!! Thank you VERY much Alma


\015\012Ok so your dishwasher won't do anything... it justs sits there and "Hums" you can't make it respond to any controls, and the ONLY way to Stop it. is to unplug the unit, replugging back in it simply "Hums" again and will do nothing. ... Viking Dishwashers

Hi there, we have had our dishlex 300 dishwasher switched off for a while and today I turned it on. I started a cycle and it stopped after a few minutes and then the Eco button started flashing. I opened the dishwasher to find it full of water and leaking out of the button. Please help! Regards, Pania


Hi just read your posting.Now the reason these dishwashers flash ECO is because there is either water in the bottom tray or your drain pump is open circuit.Is the machine making a pumping noise when it is flashing the ECO light,or is it completely si ... Dishwashers

Smeg DF612S All starts well but after 40 minutes stops with a beep and will not progress to the main wash cycle. Instead all programme lights come on (located on the left), along with the first 2 phase lights (the first two of the lights on the right hand panel). This indicates error code 3 (cannot pump out water), but water is entering and draining perfectly. Please advise.


Check to make sure there r no kinks’ in the drain line or\015\012that it is not clogged it sounds like the sensor is tripping because there is\015\012too much strain on the pump just like a breaker. ... Smeg 24 in. DWI612 Built-in Dishwasher

Ikea/whirlpool dishwasher built in 851108915000 will not start the program rinse light flashes and the pot 70 deg light stays on i believe this error means float switch activated but the base is clear. any ideas?


... Dishwashers

My top dishdrawer stopped working half fill of water. I put it on rinse cycle and it drained the water. I found a bit of sand in the bottom of drawer. I wiped the sand out and then put onto a cycle. After a couple of minutes the dishwasher started flashing a tap symbol with a slash through it and stopped working. Any help please:) Jacki


... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

Hi my Candy dishwasher model CDI 1012/2 is filling with water then after a few minutes if bleeps and the error code meaning according to the manual is "Longer inlet time. possible cause Faucets is not open" The tap is fully open and the dishwasher is now full of dirty water. Could you please suggest an alternative cause?


... Candy Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1495 seconds