Having problems with your McCulloch FHH18A Electric Pressure Washer ?

New machine. Will not mix fluid from tank #1 w/water. Tank remains full.

\015 McCulloch fhh18a Electric pressure washer - New machine, 1st time used. Will not mix fluid from tank #1 w/water. Ran for 2 hrs, tank still full. Yes the selector switch is set to #1. Sprayer and garden hose connected correctly. I found this little white plastic perforated cone on the ground, seemed to fit perfectly into the hose connector. And yes, I don't have the manual. I am having the same problem with my 1800Psi power washer. Was only able to use tank #2 last year tank #1 have never been able to get to work. Went to use it today and now cannot get nothing from either tank.Have it turned to detergent, hose connected properly, both tanks full after running for 15 minutes.\015

Answers :

Repair Help & Product Troubleshooting for McCulloch FHH18A Electric Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

New machine. Will not mix fluid from tank #1 w/water. Tank remains full.

... McCulloch FHH18A Electric Pressure Washer

New machine. Will not mix fluid from tank #1 w/water. Tank remains full.

... McCulloch FHH18A Electric Pressure Washer

Dishwashing machine not fully draining (2 inches of water remain). I have an open problem concerning this problem. I have a new pump. dishwashing machine not fully draining (2 inches of water remain) For this machine.

Following a cycle, a small pool of clean water inside the tub is\015\012typical. Excessive water means the pump isn't pumping water out\015\012properly, the drain hose isn't carrying it to the drain pipe, or the\015\012house's drain lines are backed ... GE 24 in. GLD5860LSS Stainless Still Built-in Dishwasher

What makes swing on bobcat 337 slow?filters news oil new and full has good breakout power but everything seems to be slower that other machines i have run or owed my case cx 50 would eat this machine alive the bobcat isnt mine but run for a township i work for. very disappointing machine. has 2500 hrs on it any ideas bad pump or valves it

... Pressure Washers

I have a craftsman Pressure washer Model 580-725400 the unit has ran great until today. I last used the unit 1 week ago with no problems but now I have to run the machine almost full choke to get it it rev up and run smooth. The engine oil is clean and filled to the proper point. The spark plug is new and gapped proper. The air filter is new also. And the gas is 97 Oct and fresh. When it choke it to crank the engione I move the choen to run and the engine struggles to run. When I move the choke

... Craftsman Pressure Washers

I accidentally placed Jet-Dry...DISHWASHER CLEANER...in my brand new Whirlpool dispenser. I took off the cap and ran two cycles of water through the dishwasher. The dispenser is 3/4 full of the CLEANER fluid. How do I extract the fluid from the dispenser....:-O

Let me understand you correctly. Jet dry in your soap dispenser or soap in your rinse solution dispenser. The only dispenser that holds solution is your Jet dry drying solution. But if you put soap in the drying dispenser then the only way to extr ... Whirlpool Dishwashers

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W

... Ariston Technologies Dishwashers

DWI612C wash cycle runs on and on and on. Believing to be a problem with water heating I tried putting a couple large pan fulls of boiling water into machine during wash cycle and this did move it on from wash to rinse. How do I replace the heating element I cant see it it is not in the dish washing compartment? I dont want to call out a repair agent as one can probably buy a new machine for what that will cost. Thank you.

... Smeg 24 in. DWI612 Built-in Dishwasher

KUDK01ILBS5), SN: FR2702809. Have used this machine 6 years and just recently experienced noise that I eventually traced down to a bad recirculation pump bearing that failed due to a small leak in the shaft seal. Installed a new pump on Friday, 4/21/10 and that particular noise is now quieted. While the bearing noise was gone, there remains a pumped water noise that is quieted by manually adding about 1/2 gallon of water within the machine. So I now believe the water level is low, possib

The water level in the machine should be slightly under the heat element. The float you refer to is only for overfill and should not be activated if the machine is filling properly (the water level should be lower than the float switch activation poi ... Dishwashers

I have an Asko 1606 dishwasher. I had a new hot water tank installed in my house, it seems that with the water being turned back on that the black hose from the outlet side of the solenoid has come adrift (not from the solenoid but the other end), it seems that it has to be reconnected to an opaque coloured tank on the side of the machine, is that correct? re Wayne

Yes. ... Dishwashers

My De Dietrich dishwasher turns on but then turns off after a couple of minutes with no water entering dishwasher. I found some instructions and turned on and off 5 times (and unplugged). This worked once and full cycle ran but not the second time. Not sure if it is worth paying 165 call out charge or getting new machine as 7 years old

... De Dietrich 23 in. DVF110J Built-in Dishwasher

Honda 2700 psi GC160 pressure washer will start with starter fluid in carburetor but wont stay running? Changed sparkplug cleaned carburetor, Added fuel cleaner then let set and drained all fuelandadded new. Seems as if their is no fuel going from the tank to the carburetor?

... Pressure Washers

Lately the soap remains in the dispenser, dried and caked in (I have to dig it out with a sharp object, as it becomes a solid piece). I have also tried gel soaps, but find them in the bottom of the dishwasher, partially intact. The mistery is this does not happen all the time, but most of the time! I've checked the water pressure and the water temperature: both seem to be fine. The dishwasher does run a full cycle. Is it time to buy a new one? Would you also be able to tell me what year this mod

... Frigidaire 24 in. GLD3450RD Built-in Dishwasher

I have a Miele G 863 SC VI. Among the other problems I have had since installing - many of which seem very common - I have recently noticed that the rinse aid does not seem to be dispensing. When I try to top up it appears to be full and starts to overflow. I have mixed results with washes - seems I need a new fill valve.

... Dishwashers

Bought unit new last summer. Used it once last summer and once this year. It started fine both times. Today, it will not crank. I have replaced the spark plug, checked the air filter (it is clean), gas tank is full and added oil. Why won't it crank?????

Unable to crank? Do you mean unable to start?If you leave gasoline inside tank over long period of time, that will 'gum-up' and ruin carburetor.To prevent problem, put additive in gasoline or empty gas from tank:: under gas tank sho ... Craftsman Pressure Washers

I have a Baldor 6000W generator with a gx340 11hp engine. I have drained the tank and carb and put new gas and sea foam in it. Also I have replaced the spark plug and fuel filter. The engine will start/run as long a I spray starting fluid in the carb. But it will not continue to run without it. Also I just checked the oil level and that is good. Please help!!!

It sounds like the engine is not getting enough fuel for it to run. First check that you have the fuel tap in the on position. If the fuel tap is on then the carby might be blocked or the needle & seat are not working properly. Turn the ... Honda 8 HP Engine

Using my new pressure washer, after on one tank full of gas, spark plug is black

Hi try changing the sparkplug regards savumihai71 ... Honda Pressure Washers

Hi I have a brand new Honda Power washer GC 160,2600 psi 2.3 GPM my husband taught me how to use it last night and I think I have followed all of steps: 1. hose free of kinks 2. connected to machine 3. purged pw handle of air and made sure water from house coming through 4. pulled out choke 5. turned red button to "ON" position 5. pulled T handle enging starter and it sounds like it will start but doesnt what am I doing wrong??? yes it does have gas in the fuel tank.

... Karcher 2500 PSI Pressure Washer

I have a older simpson 3000 power washer, 11 hp honda,been a great machine, owned since new, seems like the pressure is building up to a point where it has blown 2 hoses, i turned the throttle down and started to wash, engine quit after about 15 min. it restarted and quit again, tried starting fluid , nothing, what might be the issue

... Honda Pressure Washer PSI 3000

Spain, very hard water. New dishwasher dif 14 Indesit leaves plates and glasses very calc'd. We use all containers full of products, have additional aids, clean the machine every use, pre-wash; water pressure is high; have tried all programmes. Supplier does not want to know. Before going directly to manufacturers, please advise!

... Indesit DF125 24 in. Built-in Dishwasher

GE Harmony top load washer: The soap tray when filled with liquid soap will not properly dispense the soap when the water is filling the machine and the soap tray remains full of water and soap at the end of the cycle?

Hi\015\012Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doesn't allow the door to open. The stri ... Dishwashers

My Aquatak 150 pro x wont draw detergent from the two small detergent tanks at any pressure or lance setting.The machine is new. I have tried priming the pickup tubes.

... Pressure Washers

My JDB3600 hasn't fully drained after it's first wash. I started a cycle to check the machine was filling and then shut it off. We then ran a full load and water is remaining in the tub. Help!

... Jenn-Air Dishwashers

I have a new FDB520RHS2A Frigidaire dishwasher which remains in the wash cycle after I've started it. It sounds as if it is changing cycles but the wash light stays lit and never switches to rinse. The machine continues to run for hours if I don't stop it. We've checked the drain to the garbage disposal and it is clear. the water temp seems to be hot enough but how do I check that? Any ideas on what we should check before we bring it back to the store? Your help is much appreciated. Thanks!

... Dishwashers

I purchased a NEW Whirlpool dishwasher from Appliance Direct in Daytona Beach FL. The dishwasher was delivered broken. It needs a new motor pump. I asked for a new machine and they said it's their policy to fix a machine that's been delivered. I think I have a lemon. It's been a month now since delivery and they haven't even repaired the machine. Do you have any advise on how I should proceed? Glenda

You must go with the fact and hold the company accountable. 1 call speakto manager get his name and direct #. give him 3days to resolve the problem. ask him will it be repaired monday or teusday because both of those days are convinent for you.then f ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1174 seconds