Having problems with your Viking DFUD042 Built-in Dishwasher ?

My Viking DFUD042 dishwasher soap dispenser release is broken. The soap dispenser does not close. Can I replace only the latch or do I have to replace the entire soap dispenser? Where can I get the parts? Thanks, Robbie


Answers :

You will need to replace the entire soap disp. You can find it at marcone.com w/ your model #
Repair Help & Product Troubleshooting for Viking DFUD042 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Viking DFUD042 dishwasher soap dispenser release is broken. The soap dispenser does not close. Can I replace only the latch or do I have to replace the entire soap dispenser? Where can I get the parts? Thanks, Robbie


You will need to replace the entire soap disp. You can find it at marcone.com w/ your model # ... Viking DFUD042 Built-in Dishwasher

Asko 1805 dishwasher. Soap dispenser latch is constantly powered and therefore, can not latch the soap dispenser door. Replaced the soap dispenser but have the same problem. Suggestions?


... Asko 24 in. 1805 Built-in Dishwasher

Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!


... Whirlpool GU2400XTP Built-in Dishwasher

Maytag MDB 4000 AWB. Not cleaning. not getting water now. pressure was low when i was getting water. . Soap dispenser would not open as well. I replaced the motor on the soap door. cleaned the float switch. Tested continuity and cleaned out water inlet valve. Still not getting any water


... Maytag Dishwashers

The soap dispenser cover for the main wash section has broken. I think that is why the dishes are not getting clean because the soap is washing away with the first rinse. I cannot find where to get a replacement part.


... KitchenAid 24 in. KUDK02CRBS Stainless Steel Built-in Dishwasher

I am trying to replace the soap dispenser but cannot seem to separate the out side and inside panel to get to the dispenser, any suggestions?


Sometimes there is a piece of foam that is stuck in the insulation. it is there to make the dishwasher more quiet, you may have to pull on the outer panel and stick a long screwdriver between the panels to seperate them if you break the foam dont wor ... KitchenAid 24 in. KUDP01DL Built-in Dishwasher

The soap dispenser on my ASKO Model 1805 Dishwasher broke, we got a replacement part from ASKO but can't figure out how to get the old one off to replace it?


Hello,\015\012\015\012Remove the outer door panel, the screws around the edge hold it on. The soap cup will depending on serial break be held down with metal flanges or small screws. Bend the flange or remove the screws and push the soap dispe ... Dishwashers

The cover latch for the soap dispenser has broken. Can i get a relacement latch and can i install it my self? Thank you


Probably, you can, provided the manufacturer makes just the cover available. ... GE 24 in. Profile PDW7800 Built-in Dishwasher

When I first contacted you, I couldn't get the soap door to close in my dishwasher. As suggested I got the part. I now have the door apart. When I work the soap latch I can't see what closes the door. The part I was going to replace seems to be working correctly. over


Well IF the piece, the latch, seems to be working OK, then the only other thing it can be, is the Electronic "Drive" from the controller board, or a disconnection between the Controller and the Latch, Sometimes it can be a "Sensor" not allowing the ... Dishwashers

Leaking dishwasher I have replaced the rubber grommet around the soap dispenser latch and have double checked it for leaks.It is not leaking and I suspect that was never my problem.The water is coming from the lower right hinge area.I do not qualify for the maytag recall.I have never used the rinse aid dispenser but find it peculiar that there is no rubber washer in sight.Could I have a bad door seal? Maytag Model #DWU7402AAB


Hi there, dishwasher leaking might be due to either of these causes, check these:Main tub sealNote… If the main motor of your dishwasher is mounted vertically, beneath the center bottom of the dishwasher, the foll ... Maytag 24 in. DWU7402 Built-in Dishwasher

Soap gets stuck inside the soap dispenser, so that at the end of the cycle, there is a clump of soap still in the dispenser. We have also noticed that the rubber seals at the back of the dishwasher (the ones that the spin arms plug in to) are getting worn. Will get new gaskets this week, but wondered if the soap dispenser isn't another problem.


... Maytag 24 in. MDB8600AW Jetclean II Built-in Dishwasher

KITCHEN AID STAINLESS DISHWASHER MODEL #kuds02frssWe just replaced both springs in the door and the latch mechanism and the soap dispenser that still does not work. Our door will not stay shut. MY HUSBAND NEEDS HELP.. PLEASE HELP. HE IS VERY GOOD AT REPAIRS AND IS STUMPED!!


Hi.Your husband must check wiring harness from electronic control to door lock solenoid.The solenoid should also be tested reading Ohms with a multimeter.Here parts and diagrams: ... KitchenAid 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

I have a Kitchenaid Model KUD1021R and the door to the soap dispenser won't latch. It doesn't click when you push on it. Is there a way to fix this or replace it?


... Dishwashers

I have a whirlpool dishwasher model adp 5550 condenser. The dishes do not get clean. I have had a repair man out twice and he replaced the soap dispenser on Friday but it still doesn't work. I went to the store today and bought every cleaning things I could find for dishwashers and also started to investigate online myself. I took the arms off and cleaned them, I took the filter out and cleaned it, and then I noticed that the plastic bar that runs from the top, along the back and into the bottom


... Dishwashers

I am trying to replace the soap dispenser on my Kitchen Aid dishwasher. I have removed the toe plate and 10 screws on the inside and cannot get the cover off. HELP!!


As I look at the pictoral, it seems there are twelve screws that hold the inner door to the outer door. Youmust remove these and then separate the door parts. Then you will see the screws that hold the dispenser in place from inside the door. ... KitchenAid 24 in. KUDP01DLBS Free-standing Dishwasher

The dishes aren't getting clean and the majority, if not all of the soap is still in the dispenser cup. The cup door is still in the closed position after running a cycle. If it needs to be cleaned or replaced, how do I do that?


Put it on an empty cleaning cycle after double checking that you cleaned out all the filters etc and the hoes in the arms ... Dishwashers

I have a Whirlpool Model GU2700xtsq dishwasher. The soap dispenser latch and catch broke off. Now it just stays open and won't close. What is the replacement part#?


Dispenser, Assembly (DISPENSER)\015\012 Part Number: PS2363019 ... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

The soap dispenser won't lock closed--where can I get a replacement? do I need a repairman or is it something I can fix myself?


You can get a new disp from american appl in denver . they have a web sight . / replace the complete disp . they do not repair very well./ can you do it yourself ?? probably can its about 1/2 hr job and fairly easy . do not ... Bosch SHU3305 Dishwasher

My Kitchenaid dishwasher (model KUDS02SRSS0) keeps burning out my dispenser. First I replaced the dispenser, then I replaced the control board and dispenser, it worked for two weeks and now I have a melted solenoid again in my dispenser. I've measured voltage to the solenoid and it is getting 110V through the entire diagnostic cycle. This is wrong. It should only get power at some point during the cycle to open the dispenser. It appears the control board has failed again and in the same wa


HI. The relay that controls the voltage and timed release command, via logic chip, is indeed damaged(stuck on). This is a common theme with this particular design. The original control board was recently replaced with a substitution model ... KitchenAid 24 in. KUDP01DLBS Free-standing Dishwasher

The soap dispenser on our Kenmore Elite dishwasher (SEARS part number 8558128) will not stay closed. The little latch mechanism appears to be working, but the spring on the lid's base keeps the lid wide open at all times. I have examined the pop-up dispenser lid to see if some sort of plastic tip held by the latch after soap is added is broken off- this may be the case but I cannot see any damage where such a lip may have broken off. Does the latch catch the lid by snapping onto a plastic lip? I


Yes its probably the little latch that holds the door closed thats worn out. ... Kenmore 15762 Dishwasher

Maytag dishwater WU504 - Problem: the soap dispenser cover does not move. The soap dispenser is two sided with a cover which moves from one side to the other as the machine cycles to release the soap from both sides. The cover no longer moves, and I don't know what is wrong. I would replace the whole soap dispenser, but I am wondering if it is the dispenser or whatever triggers it to move. Any information would be helpful. Thanks


... Maytag Dishwashers

I have a Miele G868 dishwasher. It is 15 yrs old. 8 months ago the soap dispenser wouldn't close, so I got another dispenser from Miele and replaced it myself. Everything worked fine until 3 months later, when the soap dispenser did not open. After 3 restarts, it began to function as it should. Now 5 months later, the soap dispenser is not opening at all. Here are my observations: 1. Economy wash cycle should run 35 minutes but only runs 13 now. 2. Water in machine is not hot, even though I run


... Miele Dishwashers

Kenmore Dishwasher... Soap dispenser door hard to latch


... Kenmore Dishwashers

Dishes and the dishwasher look dirty after they run, like it redistributed dirty water. The door is very dirty/filmy except right under the soap dispenser, like someone squirted dirty water on it but wiped right under the soap dispenser. If I run it a second time with vinegar it gets clean, but that is crazy, esp since it takes 2 1/2 hours a load. I have 2 of them and both are doing it. I have changed soaps, added more soap, used less soap, pre-rinsed dishes, put them in filthy, used jet-dry, no


Hi Mike_wend604,\015\012\015\012I am looking for a used Asko #1504, if you would like to sell yours please e-mail me at [email protected] and put "Asko" in the ... Dishwashers

We need to replace the little rubber latch that keeps the dispenser door closed on our Kitchenaid dishwasher. Do we need to replace the whole detergent dispencing unit or just the latch. And if we do have to replace the whole thing, do you know how it attaches and have advice for that repair? Type is Kitchenaid KUDS01IJ


Check here ... KitchenAid Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1343 seconds