Having problems with your Viking Dishwashers ?

Eaton Viking Model DC361X117 Service# SH600025A Will not drain, and unsure how to check the hose


Answers :

Repair Help & Product Troubleshooting for Viking Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Eaton Viking Model DC361X117 Service# SH600025A Will not drain, and unsure how to check the hose


... Viking Dishwashers

Unit won't pump out, checked the lower impeller and it was very loose, is there a drain valve on this unit? Model 587.14249991 The upper impeller is a fixed unit right to the motor but it appears the lower impeller is a push fit over a rubber sleeve. I only saewa check valve in the drain hose, is there any thing else I should check? hose is clear and the switch for the float is working ok.


At the bottom of the unit where the hose goes is a check valve. check to see if clogged. ... Dishwashers

GE Dishwasher model PDW8200J03BB stopped draining. Removed the drain pump, checked with Voltmeter and there is resistance on ohms X10 of about 3. The flap is in place so water isn't shooting back into the sump inlet. Replaced the sump inlet about 6 months ago because it was deteriorated due to hard water. Pump worked fine after that. Checked drain hoses and air gap. Was able to blow water through. Pump only trickles water out at air gap. Does the pump need replaced?


Clear the line from the air gap to the drain,, if the rest is clear the only thing it can be is the propellers on the pump, i which case you will need to change the pump ... GE 25 in. Profile PDW8200J Built-in Dishwasher

Bosch SHU992SUC Dishwasher does not drain. It's not clogged in the external hose, the filters are not dirty. I moved the Dishwasher outside and ran it with the input attached to the garden hose and the output drain hose laying on the ground so there is absolutely no chance of restriction due to the way it's plumbed in. This model does not even show up on Bosch web site. I guess I have to start taking apart the machine blind with no service manual. Ideas? It's less than 10 years old I think. M


PUT THE MACHINE IN DRAIN MODE IF YOU DONT HEAR A HUMMING NOISE THEN THE DRAIN PUMP IS BAD. CHANGE YOUR DRAIN PUMP. ... Bosch SHU9925UC Built-in Dishwasher

Kitchen Aid dishwasher Model# KUDP01FLSS. 2 problems #1 Won't run unless you press in on the door and hold it for a few minutes then it runs through cycle normally. Problem #2 It won't drain water out at the end of the cycle when I open the door there is water laying in the bottom of the tub. I have checked the drain hose for clogging and it appears normal. I am able to remove the hose from the disposal and suck the water out of the tub using a shop vac this indicates to me that the drain is ope


... Dishwashers

My GE dishwasher, model # gsd2230f00ww won't drain. The spray arm is working and i hear the motor. Checked both ends of drain hoses, very clean. took sum cover off, clean. checked float, fine. What could be the problem? solenoid? I turn the dial on the washer and the solenoid does nothing, should it make a noise to actuate the drainage? please help! Thank you


... GE Nautilus 24" Built-in Dishwasher

I have a Bosch dish washer model SHX 43 M 0 ZUC / 48 FD 8709 00169 The dish washer is about 1 1/4 years old and was installed by a plumber as part of a Home Depot kitchen remodel. The problem is draining. The quick wash does not drain at the end of the wash. The regular wash sometimes drain and sometimes does not. The auto wash does drain. The lack of draining does not cause problems with the regular wash cycle. I checked the drain hose re the instruction manual and it is correctly installed.


Usually a brush with a flexible shaft will do the trick...\015\012\015\012Like this venturi tube cleaner (available where gas grills are sold)\015\012\015\012 ... Bosch Dishwashers

There is water in the bottom of dish washer after finishing. If I start another cycle, everything drains, so it's not a problem with the hose. I hear water draining. I think it is the drain time. When the machine was under warranty, the service guy came and changed the drain time to longer. He told me how to do it, via the buttons, but have now forgotten where I put such great information. I have a 1996 built in model.


We have come up on this many many times. It is not drain time. There is a flapper in the drain hose located where the hose attaches to the pump with towels remove the hose and stick you finger in. It is and angled piece of rubber so it will be dif ... Whirlpool GU2400XTP Built-in Dishwasher

Water not draining after wash cycle. Pressed cancel button to start draining per manual, but nothing happens, although sounds like motor is humming. Drain hole in sink appears clear, but haven't checked the hose. What's my next step? Mine is model kudko2cr


Hi,Checkout this tip that I wrote about that problem...http://www.fixya.com/support/r4225828-dishwasher_repair_problem_detergen ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Not draining Hey I have a whirlpool(model # DUB50DWGB1) and Ive hooked it up and it wont drain. Ive taken the filter off and checked the bottom hose and it drains. I think that it is the pump is not pumping up to the gargbage disposal. If the gargbag disposal is not hooked up, would that be my problem? Thanks for any help taht you can give


Hi and welcome to Fixya, \015\012 \015\012I'd suggest you are correct in your suspicsion of the disposer being a likely problem. \015\012 \015\012Start by checking the drain spout of the dispose ... Whirlpool Dishwashers

The ge profile dishwasher model PDW8280J10SS was purchased about 2 yrs ago. It was working fine up until Jan. 2009. It ran fine but the water stopped draining. I read were you should run the garbage disposal prior to running the dishwasher. I drained the water and did this. It worked fine for a while then the problem was back. Once again, Drained all the water, sucked it out with a turkey baister, moved the dishwasher and checked hoses etc. Once again, it worked fine for about 10-14 runs. It now


It is probably clogged at the pump or before. See if you can get outlet hose off the bottom before the pump. ... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

Bosch Model SHV46C03UC/14 Dishwasher won?t drain completely. The drain hose is not kinked or obstructed and it drains into the garbage disposal. If I push the combination of two buttons on the panel, I can pump out residual water, but if I don?t, it stays there. It will become foul smelling within a day if I do not manually remove the water. Bosch technical support won?t talk to me unless I am a service technician, but I can handle this as I do all my appliances. The screens at the bottom o


THE DISHWASHER DO NOIT DRY THE DISH ... Bosch Dishwashers

I have a haier dishwasher model WQP12 AFM, I've replaced the wash pump motor and drain pump (they had been damaged with water after last repair person didn't put widget around drain hose which split and water accumulated on bottom). It well for about two weeks, then it would not go through it's cycle and I noted water not heating up. Have checked element with meter, thats fine, I replaced timersince it wasn't going through its cycle and that has not changed anything. Any suggustions?? Cheers


... Haier Dishwashers

Dishwasher does not drain all water after wash, code C=drain hose,coase or fine strainer or sink blocked.(all checked & are ok) then towards end of wash code H= Call AEG service force ,comes up. but if i put machine on pre-rinse it driains ok, so pump is working. only seem's to be end of wash programe fault accurs


... AEG 22 in. Favorit 55750IM Built-in Dishwasher

Our GE model GSD4320Z00B is having a problem with the drain system. I've run the unit in the test mode and it does pump the dishwasher down. The problem is the unit does NOT pump down during a normal wash cycle. The fact that the unit works in test tells me it is not the pump. I've checked all the hoses and drain paths and there are no obstructions, again verified by the fact it works in test mode. Any test that can be used to determine the problem besides replacing parts one by one?


... GE 24 in. GSD4320Z Built-in Dishwasher

My GE dishwasher Model # GSD2200GO2WW will not drain. I took it apart cleaned out the food particles that were in the filter basket and checked the hoses... put it all back together... Still won't drain. now what?


Did you check the drain pump? if you remove the pump and take an extension cord and cut off the end and add two connetion terminals to the end plug em in then plug them to a wall outlet you willbe able to tellhow well your pump is actually working if ... GE 24 in. GSD2220Z Built-in Dishwasher

Hi, I have a De Dietrich dishwasher model VW8810U2/2 approx 12 years old. The water is not draining, I have checked the filter is not blocked and the drain hose is clear of any kinks etc. I'm guessing it could be the pump. Can you advise of the cost of repair please. Many thanks Derek Springthorpe Willaston Nantwich Cheshire


... De Dietrich Dishwashers

I recently replaced the chopper in my whirlpool quiet partner III. now it won't drain. I can push the cancel drain button and hear the pump running, but nothing happens. I tried reversing the wires to see if I had switched them around when I was trying to figure out why it wasn't cleaning the dishes and that didn't work either. I checked the hose for cloggs and nothing. I am left scratching my head. model # gu1200xtkt0


It sounds like you've done a lot to try and fix your dishwasher. Make sure your air gap is not plugged up and double check the drain hose. If those are clear change out your drain hose. Part#8270145 the elbow connector sometimes have a bad chec ... Whirlpool GU2400XTP Built-in Dishwasher

Dishwasher model c5420 won't drain. Checked drain hose and air gap, both are clean.


Dear friend,\015\012\015\012ngfam at you service! happy to assist!\015\012\015\012 Sounds like a pump problem !We sell appliances for 65 years and I recommend this nation wide Factory repair service!\015\012\015\012 ... GE Dishwashers

Hi Our Smeg dishwasher model ST 663-1 is not finishing a cycle. It beeps intermitently towrds the end and won't drain (stuck that part of the cycle). I have checked the filter and the drain hose isn't kinked.


... Dishwashers

Dish Washer, Electrolux Home Products, Model FDB2510LCC0, Serial NO: 7H34962223 Machine does not drain or add water. The machine has been worked for a couple of years. I checked the following: 1. Overfill Protector not stuck 2. Motor turns on and the machine cycles correctly 3. Since the machine has been running correctly the unit is hooked up correctly: hoses, garbage disposal, knockout plug. Again everything has worked and the motor does cycle and the machine will perform the different cycles


... Electrolux 23 in. ESI602 Free-standing Dishwasher

We have a Brandt Aa Class Dishwasher that will start and run the fill cycle for about a minute with the red operating light on but then stops and the red light goes out. I suspect it may be a timer related problem but can you tell me where the timer is on this model ? I have checked the filter and that the water supply and drain hoses are not kinked.


... Dishwashers

Hello. i have a kenmore model 363.1522100 serial vf308860r dishwasher. recently with the last 3 cycles there has been about 4 gallons of water at the bottom of the tub. There is no air gap. I cleaned the drains(there were no clogs). I checked the pump and it turns. All hoses are clear of clogs. Any suggestions?


... Kenmore Dishwashers

I have a GE dishwasher model no. PDW9280J00SS. After 5 years of faithful service, it quit draining last week. I am unsure how to fix this. Is this a problem that only a repairman or plumber can fix? Any ideas?


Hi\015\012 \015\012Dishwasher not draining issue usually occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no v ... GE 24 in. Profile PDW9280JSS Built-in Dishwasher

Getting error code 0E on LD-14AW3 model dishwasher after 2 minutes. Checked drain hose and water seems to be coming out but won'y go any further in cycle Also makes a loud humming noise when running.


To little info, but looks like pipe is much to low. Not getting the opportunity to fill up properly.Raise it higher.(Im asuming that you can hear the drain pump run and water is being pumped out as wall. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1463 seconds