Having problems with your Whirlpool 24 in. ADP5962 Free-standing Dishwasher ?

My dishwasher get's stuck during the cycle and just keeps washing. If I dont move the cycle on manually it will wash and wash for hours!! Can any one help??

Answers :

This is probably heating issue. The cycle will not advance if the water is not up to the proper temperature.

Next time you run a cycle, open up the door after a few minutes. A large ball of steam should roll out of the machine. No steam = no heat = no timer movement.

The most common suspect for repair is your heating element. The fix may be a simple as a loose or broken wire leading to the element.

The element itself may also be bad. This is easily checked with a multitester. Set the tester to ohms or resistance. The element should have an actual reading. A result of zero or infinity or overlimit is not acceptable for your heating element. It should then be replaced. Good luck
Repair Help & Product Troubleshooting for Whirlpool 24 in. ADP5962 Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dishwasher get's stuck during the cycle and just keeps washing. If I dont move the cycle on manually it will wash and wash for hours!! Can any one help??

This is probably heating issue. The cycle will not advance if the water is not up to the proper temperature.Next time you run a cycle, open up the door after a few minutes. A large ball of steam should roll out of the machine. No steam = ... Whirlpool 24 in. ADP5962 Free-standing Dishwasher

Hotpoint Model HDA 3500N 10 BB Unit is only about a year old. The dial does not move. I noticed it when the washer was on for more than 3 hours and saw that the dial was still in the middle of the wash cycle. I then turned it to the rince cycle which operated there (not moving) until I manually moved it to dry. Did not move from there either. Thank you for any help you can give me.

HiThanks for using FixYa. From what you have described it seems to be an issue with the timer that has gone bad, they don’t often fail but if everything else is working fine then it is the Timer ... Hotpoint Dishwashers

DWI612C wash cycle runs on and on and on. Believing to be a problem with water heating I tried putting a couple large pan fulls of boiling water into machine during wash cycle and this did move it on from wash to rinse. How do I replace the heating element I cant see it it is not in the dish washing compartment? I dont want to call out a repair agent as one can probably buy a new machine for what that will cost. Thank you.

... Smeg 24 in. DWI612 Built-in Dishwasher

We just installed a new kenmore dishwasher yesterday. Model 13242 It has been running for almost2 hours and is still on the washing cycle--no water in it however--is this normal? I'm in a bit of a panic as we are canning and I need the jars washed--we didn't get a manual with it as it was a floor model so I don't know how lon the normal cycle ids. HELP

THAT IS NOT NORMAL!!!!!!! A normal wash and dry cycle will take approx. 2 hours in length including drying cycle.\012You should see that water has been present in the machine within the first 2 minutes of the start of the wash cycle, you shou ... Kenmore Dishwashers

Kenmore 17369 When cycle starts... it sounds terrible (crackly sounding).... doesn't sound like the water is coming into the dishwasher. If I add water to the machine during a rinse cycle...it will wash and drain on its own.... Then I hit cancel. Please help.. I can't locate the owners manual.. Do you know where I can get one.. I understand that you can open the bottom up and see if there is anything lodged in the bottom of the dishwasher. Please help! thanks Cheryl

The problem is your water inlet valve. If you remove the panel at the bottom of the dishwasher you will see\015\012either a copper hard pipe, or a flexible steel hose leading into the\015\012water inlet valve.BE SURE TO CUT OF ... Kenmore 24 in. 17362 / 17364 / 17369 Built-in Dishwasher

Hi I have a Blanco dishwasher BFDw8 which is having poor wash results in the top tray I have tried all the trouble shooting things in manual. Investigated further by opening door during wash cycle several times and discovered the top arm is not moving although water is still coming out of the arms. I did get a split pea particle out of the arm approx 2mm and have since had a mildly better wash and have used superior wash powder and rinse aid to try and help. Also have put a cleaner through di

\015\012\015\012Check the water temperature. Should be 125 to 140 F. \015\012\015\012Check pump re-circulation., Listen, see if it sounds like it is spraying the water around with enough pressure. ... Dishwashers

Cycle time Just moved in, started the Bosch dishwashe that appears to be less than two years old, left for one-hour and came back to find the wash cycle still going; hasn't cycled in thirty minutes since I've returned. Is this normal? What is the standard cycle time?

Yes its normal.bosch dishwashers use very little water and energy but,the cycles need to be longer to get the dishes clean. its perfectly OK.(ps use cascade powder if you can) ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

Hi, I have a Siemens SE24A230GB/17 dishwasher and it is not completing the wash cycle (any selected). It appears to be stuck on the 'wash' part of the program. I have done the reset actions as advised in the User Manual and tried another program, without success. I have found that the possible causes could be the timer or thermostat. The estimated time remaining display counts down, but the program does not complete the wash and move onto rinse and dry. Any help or advice you can provide would

... Siemens Dishwashers

My dishwasher BOSCH SGS4802EU/12 dont stop after 92 minutes, wich is the time of one cycle. it take more than 3 hours to finish. I think that can be resolved if y make a reset on the dishwashwer, but y dont how to make the reset. Can you help me please? Best regards. Pedro Antunes

... Bosch Dishwashers

The wash cycle seems to take hours. the water wont drain away and i get a little blinky light on the front. i dont have the manual either so i dont even know what the arrow buttons mean on the front of the machine

... Zanussi 24 in. IZZI ALU Built-In Dishwasher

Any of the programs start ok (water enters etc..) but the program does not move on, will stay at the same place early in the program cycle for hours. You can move the program on manually and the water ext will exit but the dishes are not properly washed. Changed program timer switch but still same - zdi6041x dishwasher - any idea why ?

Thanks for your question!I'm sorry that you haven't received an answer yet.The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:1. the question is unclear, incomplete, or poorly ... Zanussi 23 in. ZDI6041 Built-in Dishwasher

My bosch excel dishwasher has the following fault: start the cycle, water starts to fill but then check water light comes on and it then starts to empty again. Pump then keeps going. I have checked the hose and even swapped it round with my washing machine one but this makes no difference. I have cleaned all the filters and taken off the cover to check the 'propeller' as sugested in the instruction manual. But no joy - check water light still illuminated and willnot continue with cycle. - Help!!

This unit im sure has a water flowmeter that measures the water intake.. if this cannot read then the unit shuts down to avoid flooding.. \015\012it needs replacing... it is attached between the valve and the side tank or attached to the tank d ... Bosch Dishwashers

Hello I have a LG Dishwasher which is flashing OE on the left side with bells going off, the wash rinse dry lights are also flashing can you help me please? I can not get it to go any further in the cycle. Unfortunately I dont; have the manual

What is the model number of your LG dishwasher? Look on the edge of the door (right side) for a silver tag. ... LG Dishwashers

My Bosch SHU5316UC won't finish cycle. When I turn it on it resets to 13 minutes and goes down to 1 but stays at one and never finishes. Except on rinse and hold where it goes to 1 and stays there. It would run all night if I let it. How do I reset adn try to fix it. I tried to hold POWER SCRUB and REGULAR WASH as suggested by manual and no luck. Any help?

Hello, welcome to FixYa. ... Bosch SHU5316UC Dishwasher

New dishwasher (Beko 2542F slimline model). Put it on for 1st time last night -when I got up this morning, the cycle which should have taken just over 2 hours hadn't finished. There's soapy water in the bottom of the machine which hasn't drained and the "wash" light is still on. Looks like the dishes are clean but hasn't moved onto the rinse/dry part. Followed instruction in manual to drain it (hold start stop button till lights flash and should drain in 45 sec) but nothing happened.

... Beko Dishwashers

Kenmore model 665.16509200 Does not clean very well and now dry cycle not working. Wash cycle takes almost 2 hours, and still dishes had gradoo and white detergent on them, even ones that were clean when they went in. The drying coil had plastic melted on it once before, so that could have caused that malfunction. I am not so concerned about that, it is the dirty dishes after 2 hours that is driving me nuts. The short wash cycle leaves EVERYTHING dirty, so I just quite even trying that.

... Kenmore 13599 / 13594 / 13592 Built-in Dishwasher

Bosch dishwasher, Model SMU 7056, UC 09, FD 7309. My older unit has operated flawlessly for years. Two days ago it started to "stall" in one cycle and not progress to the next, e.g., stayed in the wash cycle and would not move on to rinse. In addition the heat generated in the machine was way below normal. A repairman told me that if the water doesn't get hot enough, the unit will not move on to the next cycle. I always use the "Regular Wash" option, but tried other options such as 'Economy

... Bosch Dishwashers

KENMORE DISHWASHER STUCK IN WASH CYCLE it will not move off of this postion water heats up it cleans but does not move off this cycle. New 2008 Kenmore 1610 built-in dishwasher won't leeave wash cycle. repair person says it is supposed to take 3 hours.

... Dishwashers

During wash cycle it gets stuck and won't move past the wash cycle. On a regular wash it is at 28minutes and when it is on a fast wash it is at 25 minutes. If I stop it and turn on the rinse cycle it will run through the 12minute rinse cycle with no problems. It is only the top dishwasher that does this, the bottom one is running just fine.

I've got the same problem with the bottom drawer on the DD605. No fault codes were set. I checked the heating element and it produced heat quickly. I suspect that the water temp sensor isn't satisfied, and the timer is waiting for the water to rea ... Fisher and Paykel DD605BK Dishwasher

Operations manual Need to know where i can get a manual for my dishwasher as when we bought the house, one wasnt provided. Dont know what the cycles are all i know is how to turn it on and do a full cycle..dont know what the other buttons are for and I LOVE buttons...but...need to know what they are for

Get the model number from the dishwasher. Most brands have websites where you can find owners manuals and print them off. ... Dishwashers

KUDS30IXSS1 dishwasher will pump out water completely on the one hour wash cycle, leaves water in tank at end of all other cycles. Will completely drain when cancel/drain cycle is pushed. Is there a re-set code, or sequence; or is there a diagnostic code or sequence tohelp me? Like push Heat/dry, then normal wash, then Heat/dry, then normal wash within 6 or 7 secs? Or is my circuit board just shot?

... Dishwashers

I have an equator PLS600 and I can't seem to get it to work. I have tried the WikiFix to help a stalled dishwasher, by adding water and vinegar. When I put on the wash cycle it does not run. Even with the short rinse cycle, the sprayer will not move, and the machine will just run through the cycle until it starts to drain. Please help!!! Thanks =)

Give the spray arm a spin to make sure it rotates. It should spin freely. If not, remove plastic spray arm clip, flip it over, replace it, and try again. Make sure holes in the spray arm are clear of debris. Spray arm must be clean for it to spin ... Equator 20 in. PLS600 Free-Standing Dishwasher

Hi, I have a bosch SGS43E02Z dishwasher that dont seem to wash clean. It would seem that some times the presure from the spinning washers arnt working well enough as it dont even move rice from plates stacked next to each other. i have checked all filters inside the machine and if you start a wash program the sprayers work and the water is splasing. please help with sugestions.

... Bosch Dishwashers

I have an Electrolux Dishlex DX303 Dishwasher. Recently it has been stopping early in the cycle and the display shows -10. The selected program is flashing. The cycle will restart by pressing the program button again but it no longers wash's right through the wash pe=rogram as it is meant to. I do not have the manual to trouble shoot and find out what this means. Your help would be appreciated. Regards Peter H

Hi peter,\012according to manual book -10 is not filling water fast enough.\012check inlet hose and valve, check pressure switch and pressure SW hose and clean sump filter which located bottom of tub that plastic strainer and stainless mesh clean the ... Dishwashers

I have a Bosch dishwasher that is about 4-6 years old (model SHU8805UC/U12). A few days ago I found clear water in the tub hours after the wash cycle had completed. I drained the tub by resetting the cycle as instructed in the user manual, but the tub gradually filled up with water again after several hours.. will replacing the inlet valve solve this issue?according to what I can tell for my model the water valve assembly (part No. AP3783031) is the part I need. How difficult and expensive

Just pulled mine out last night. You have a different model but it should be the same. Remove the bottom dress panel and detach your inlet hose from the water valve assembly (have a rag handy to catch a little water). Two torx screws on the front ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1329 seconds