Having problems with your Whirlpool Dishwashers ?

I have a Whirlpool dishwasher, model DU943 that's under 7 years old. I went to use it last night and it won't power on. I tried selecting all of the cycles, but the dishwasher never came on. I looked through the troubleshooting tips in my manual (like checking the circuit breaker for a tripped fuse, which was fine) and I still have a problem. what else can I try? thanks.


Answers :

Hello- This unit has a thermal fuse inside the door panel on the control. This part is replaceable. If it is bad, replace.- and would suggest not using heated dry as this is most common cause of fuse failure. Let me know if this info helps- have more if needed.- Thanks- ED
Repair Help & Product Troubleshooting for Whirlpool Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Whirlpool dishwasher, model DU943 that's under 7 years old. I went to use it last night and it won't power on. I tried selecting all of the cycles, but the dishwasher never came on. I looked through the troubleshooting tips in my manual (like checking the circuit breaker for a tripped fuse, which was fine) and I still have a problem. what else can I try? thanks.


Hello- This unit has a thermal fuse inside the door panel on the control. This part is replaceable. If it is bad, replace.- and would suggest not using heated dry as this is most common cause of fuse failure. Let me know if this info helps- have more ... Whirlpool Dishwashers

My Maytag dishwasher stopped working during a cycle. It looks like an electrical problem. I checked the breaker and looks OK. Looks like no power is getting to the dishwasher. Can you help ?


Your maytag dishwasher should hav a free inhome service\015\012\015\012http://www.bobvila.com/OnTheLevel/Maytag-Dishwasher-Reca ... Dishwashers

SEARS/WHIRLPOOL DISHWASHER Model 665.16014401. The CLEAN light keeps blinking and washer will not run. Op. instructions say to check the heater circuit. Heater element tests at 12.9 Ohms and thermo unit at 55 K ohm and the unit I beleave looks like overtemp cut out is less than 1 ohm. these look like good #s to me so I suspect the controller p/n 8564544. When I look up the number online I find it has been replaced with 8564546, but the only picture I can find of it looks like the connections are


... Kenmore Dishwashers

My dishwasher ran this morning with no problems. This evening it won't work at all. No lights come on at all, as if there is no power. I checked the circuit breaker box and all is well there. I flipped the breaker just to double check, but nothing. Sadly, I cannot find my instruction manual. Do you have any ideas?


The manual is no problem you can download it from this site.\015\012The problem you are experiencing will not be described in ... Samsung 24 in. DB5710DT Stainless Steel Built-in Dishwasher

My dishwasher will not start. It is a frigidaire / electrolux FDB1050REQ. I have checked thepower....and reset the circuit breaker.......then pushed the start button.....the light comes on on the front of the washer like normal but no water starts filling. I have jiggled the anti water overfill device but still nothing. HELP!!! The front of the dishwasher says Frigidaire, however, the inside of the door where the model# is says Electrolux


... Frigidaire Dishwashers

Bosch Dishwasher The label is damaged, but it looks like I have M/N: SHV4303UC Bosch dishwasher. I need to reset (reboot) the electronics. It is stuck in the opening cycle of draining excess water. I've tried turning of the circuit breaker for a long time (10 hours overnight) and that did not work. How can I correct this?


The reason it is doing this is because the anti flood valve is either stuck or you have a leak in the bottom of the dishwasher. if you tip it back slightly does water come out? if so you have a leak, If not take the front panel of and you will see a ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I can not turn my dishwasher on. It is acting like there is no power. Model number gu2275xtvq0 I have checked circuit breakers and wiring to dishwasher. Any suggestions?


Check timer and power, motor ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Dishwasher fills with water and then stops. No lights are on at all. I cked wiring and circuit breaker and no issues there. I then flipped off circuit breaker over night. Got up next morning and flipped breaker back on. Dishwasher lights were on and when I pushed Start button, it ran fine. Now it is doing same thing except circuit breaker trick dont work like last time. THERE is NO issues with wiring or connections to dishwasher.


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

BOSCH shu43c02uc my bosch dishwasher blew my circuit breaker and I smelled like an electrical fire when I opened it. Have already replaced the control panal from the recall in 09. Anyone know where to start to troubleshoot?


... Bosch 24 in. SHU43 Built-in Dishwasher

I have a GE 940 DISHWASHER AND IT WILL NOT TURN ON I CHECKED THE CIRCUIT BREAKER IT IS ON, WATER IS NOT GOING IN THE MACHINE .I USED IT 2 DAYS AGO AND IT WAS FINE .ITS LIKE IT JUST WENT DEAD THANK YOU TERRY


Hello, tcI\012 was trying to help you out here. I am not sure if this well help you? \012But here is a link to about everything you want to know about your \012dishwasher, from repair to trouble shooting on most common dishwas ... Maytag Dishwasher

Asko D3530. Program LED does not come on. Also nothing happens when I push Set, Menu or Start. Tried button on the left (cirle with a I, looks like a reset button?). Checked plug and circuit breaker switch


Hello Rick,\015\012make sure you have tested the unit with the door closed all the way ,make sure the delay option is not turned on make sure the power cord is properly plugged into the outlet, and check your fuse box for any blown circuits sor ... Asko D3531XLHDSS Stainless Steel Built-in Dishwasher

See below This is a post that I just copied to this space "I have a whirlpool Quiet Partner II, Model GU2400XTB1, that just suddenly will not start, as if the power was cut. Circuit breaker is fine. from the little Internet research I've done it looks as thou it could be a thermal fuse problem. How easy are these to replace, assuming that's what it is?" Mine is quiet partner III ... there is power to the connection box at the dishwasher it self (checked w/ light tester) ... but there is no power


Have you tryed leaving the power cord out of the socket for an hour or so sometimes they don't lose the memory until they have been left disconnected for a while ... Whirlpool GU2400XTP Built-in Dishwasher

My Kenmore portable dishwasher quit working in the middle of the wash cycle. It has power going in, but no longer runs at all. I need a service manual or a troubleshooting guide. Is there a circuit breaker somewhere on it that needs to be reset? Charlie


This seems to be that the Anti Flood system has triggered. This device detects water leaks / spills to the bottom of the washer and automatically puts the washer in pump out mode and shuts off the water inlet. The device is made up of a pollystireene ... Dishwashers

Wash cycle stopped with water in the bottom. Seems like there is no power. Can't get lights on cycles buttons to turn on. Power button does nothing. Checked circuit breakers. All are on. Lights and outlets around dishwasher area are working.


Check the wiring in the units junction box. Its located at the bottom right corner. You will likely find melted connectors. If so, you need to cut the wires back and replace these connectors. Make sure you turn the power off before doing any of this ... Bosch 24 in. SHX46A05UC Built-In Dishwasher

My Bosch integrated dishwasher(model SGV56A03 GB/12) runs through the cycle but doesn't stop at the end of the cycle. It continues to heat water and it sounds like the motor is running even though the time indicator shows 0 minutes. I have to manually switch it off. Any ideas before I call out an engineer. I have checked all the filters etc included in the troubleshooter info anf there are no blockages.


... Bosch Dishwashers

Whirlpool gu2500xtps6. The dishwasher was working perfectly but one of these days, for no apparent reason, it wouldn't show any sign of life. None of the LEDs on the front panel light up. It does not respond to any button being pressed. Looks like something electrical but all my circuit breakers are fine. Is there any fuse or something simple that I could replace myself?


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Asko D3530. Program LED does not come on. Also nothing happens when I push Set, Menu or Start. Tried button on the left (cirle with a I, looks like a reset button?). Checked plug, GFI and circuit breaker switch. Still no power and no light no response from various buttons.


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012It sounds like you've got a bad power switch or a wire at the power switch or as you described it... (circle with a I, looks like a reset button?) ... Asko 24 in. D3530FI Built-in Dishwasher

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

My dishwasher so my dishwasher seemed to have quitworking during a cycle. like breaker triped or something. i checked the breaker and thats fine. it seams like its hard wired in though. Would that be right? and is there a fuse or something that could/would blow during a wash? I dont know what model it is or anything it was in the house when i got it. The dishwasher is built in and it seems decently old its a kenmore ultra wash and it has like 10 buttons for the differend cycles on the left and a


Sounds like the fuse on the control blew. you can replace the fuse for\015\012around $20 or you can cut and splice the wires for free. If that doesnt\015\012work then you may have a loose conection in your junction box under the\015\012dishwasher. ... Kenmore 24 in. 15932 Built-in Dishwasher

Frigidaire dishwasher Rylee, the circuit breaker is fine. There is no fuse on the dishwasher according to the owners manual, the parts manual and the wiring diagram. There is no timer selector switch on this model. While I changed the control circuit board, the only other thing I can think it would be is the control panel with the buttons on it. What do you think


Hi Todd,As a rule:\015\012\015\012Black Smoke = Unburnt Fuel, incomplete combustion, bad mix\015\012Blue Smoke = Burning Oil\015\012White Smoke = Water Va ... Frigidaire 24 in. PLD2560LCC Energy Star® Built-in Dishwasher

My Bosch dishwasher Model SHE44C02UC just went completley dead while washing. My wife and I were in the living room and heard a ''pop'' and went to investigate. We discovered the dishwasher was completely dead with no lights on at all. The on/off switch does not work. I checked the breaker and it is okay. Also the disposal is also on this circuit and it still works so I know the circuit is okay. There is still water in the bottom of the dishwasher - no suds - so it may have been in a rinse cycle


Well done on confirming that the outlet is not the problem. This problem will not be able to fixed by the owner and a service call is the next step. (unless you want to dig into the problem, which could easily be a failed pump motor which took out t ... Bosch Dishwashers

Kenmore Elite - 9 Year old Dishwasher - A circuit blew and the dishwasher stopped in mid-cycle and did not drain.... I reset the circuit breaker and "manually" took the water out of the dishwasher. When I push buttons to restart the "95" shows up for the normal cycle. However, when I push start the "95" becomes a "--". Suggestions???


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Power off I have an ASKO D3100 Dishwasher, which is a few years old now. It stopped working a while ago where the power went off and stayed off (no lights anywhere). I've checked the power point and it's okay. I've flipped the dishwasher over to look inside and I can't see a fuse or anything that looks helpful. Can someone help me troubleshoot this one?


Howdy. I suspect a power surge went through your machine and fried its itsy bitsy brain.Its time for a new one unless you have a good supplier and serviceman who will replace the control unit. Get an estimate with a closed top cost before you agree. ... Asko 24 in. D3112 Free-Standing Dishwasher

We have a IKEA Whirlpool DWF 407 dishwasher that suddenly stopped pumping in water. It's just stuck in a loop where it sounds like the water pump is dryheaving and soon after it starts smelling a bit burnt and smells a bit like a battery. I've checked the overflooding breaker and there's no water down there and I can hear the switch turning on if I move the floater upwards. Also checked so that the water hose up on top of the machine is securely fixed. Any ideas?


... Whirlpool 24 in. ADG6340 Built-in Dishwasher

Hi I have a bosch diswahser smu 7000. No power when I push button. Manual says its could either be fuse or circuit breaker. Checked breaker its ok. My manual does not say anything about location fuse. Called bosch. And they said they cant tell me. I nee to have a service call. Any help. Thanks.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2128 seconds