Having problems with your Whirlpool Dishwashers ?

I have a whirlpool ADP-4685 WHM model. When i just switched it on there was a grinding noise at first then that stopped and it sounded ok and started to fill with water. It has now stopped again and the bottom left side light is flashing. Can you please help. I live in Spain, so my instructions book is in spanish! Thanks

Answers :

Repair Help & Product Troubleshooting for Whirlpool Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a whirlpool ADP-4685 WHM model. When i just switched it on there was a grinding noise at first then that stopped and it sounded ok and started to fill with water. It has now stopped again and the bottom left side light is flashing. Can you please help. I live in Spain, so my instructions book is in spanish! Thanks

... Whirlpool Dishwashers

Have a whirlpool ADP 951 and no manual for it. Is was working fine and now the red light in the left hand corner is on and machine wont fill. When I start it by holding the button on the right hand side in, it will drain for about 30 seconds and then stop and green start light flashes. Can anyone offer a solution?

Some mod have codes / could be suds lock or slow drain . i would ( if front loader ) clean out pump . hope this helps . **** ... Dishwashers

I have an Hotpoint LS12 -EV03 integrated dishwasher. It will not start/fill. The forst two lights on the left hand side of the light cluster are flashing at the same time. There is a small amount of water also at the bottom of the machine

... Hotpoint 23 in. BFI62 Built-in Dishwasher

I have a 4yr old Smeg freestanding dishwasher. Model is DF612SDX. The problem is that a wash cycle will start but about 15 mins in it stops and 2 of the programme option lights (on the left hand side of the programme options), start flashing. If you open the machine the soap dispenser has failed to open. This problem has been a bit of a slow deterioration as we've had a number of washed that have managed to finish and then noticed that although the dispenser has opened it must have been to

... Smeg 24 in. DWF612SS Free-standing Dishwasher

Kitchenaid kudc03fvss0 dishwasher stopped mid cycle without drying dishes last week and then stopped altogether with lights flashing and full basin. I disassembled filter/pump cover in bottom and cleared several plastic pieces and cleaned chopping blade and screen. After unplugging/plugging and pressing cancel button the pump runs for about 10 seconds and stops with normal and heavy duty lights flashing. What should I check next?

... Dishwashers

The Start button does not light up, yet the left side did light up for wash cycles. I'm guessing the PC Control board has some issue with touch button panel, as a faint high pitched shrill can be heard from the board after I took the door off and put my ear to the board. Also, over time the left side of the panel stopped lighting up too, so I through the circuit breaker. Can you advise which component it is. I'm guessing the faint high pitched shrill is the PC COntrol board attempting to communi

You have a faulty touch pad that will need to be replaced. Below is a \015\012link to a video you will want to download so you can see how to replace \015\012the touch pad.\015\012\015\012\015\012\015\012 ... Haier ESD400 Stainless Steel 24 in. Built-in Dishwasher

Leak from a De Dietrich Integrated Dishwasher has caused 3 red lights on the left of the Control Panel to flash and also a Blue Light on the right hand side of the Control Panel to flash. On resetting the Appliance Controls, the machine starts pumping out and then closes down, with the Control Panel lights flashing again. Help

Pull the built in unit out and tilt towards the rear right leg and the water will drain on to the floor. The Dishwasher then restarts but the anti flood sensor will reactivate after 2-3 more washes. Do not know final fix yet. ... De Dietrich Dishwashers

Maytag MDB5601AWS Dishwasher worked fine when I moved into my new home less than 2 weeks ago. It just stopped working a few nights ago and the sellers did not leave info on the dishwasher. The only buttons that light up are the buttons on the right side of the START/CANCEL button (which does not light up at all) and the LIGHT WASH button on the left side of the panel. The DELAY WASH button blinks for a while, and then all lights on the panel go off completely. No noise at all comes from the

CLICK HERE for your owners manual.\015\012\015\012If, after reading through it, You feel you h ... Dishwashers

First 2 weeks ago i put an electric control module into the upper section. what comes on is the green flashing light for clean. in checking connections i found the paper for trouble shouting. i did what they said to do. they said hit the time saver - high temp - time saver - high temp. from there all the lights went on & the wash cycle started and ran. then it just stopped & the green light for clean just flashes. the water is still in the bottom & won't drain.

The error indicates that the machine has taken too long to drain the water. Do the following.\015\012 \015\012\015\012Switch off the machine, unplug or disconnect the ma ... Kenmore 16874 Built-in Dishwasher

Bosch dishwasher I have a month old Bosch dishwasher. It was stopped mid cycle. I drained the water at the bottom, but the active light keeps flashing, and when I press the start,reset button, then turn it off, it does the same thing when I turn it back on. active light keeps flashing and the wash light is on. It won't even lock the door. How do I fix this because there is no Bosch dealers here to help with the problem.

... Hotpoint 23 in. BF41 Built-in Dishwasher

I have model GU3600XTSY2. Sometimes the pots and pans light flashes for no reason. Sometimes I can push that button and it stops. However, the cycle I select to wash the dishes is constantly interupted by the pots and pans (P&P) light flashing. If I push the P&P button, the wash cycle usually starts where it left off. Sometimes it will go back to the beginning of the cycle and begin all over again and get caught in a loop; start washer, P&P flashes, push P&P, begins cycle from beginning, P&

... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Lights on Dishwasher light up but nothing happens. When I reset power it lights up the high temp and sanitize button light up and LED displays PF. After I open the door they stop flashing. the far left five buttons light up when I push them and a corresponding number displays on the LED screen. the only lights that do not come on are the Delay button and power button. Don't know if they are working or just don't light up. No matter what lights up the unit does not turn on....:( ? help can't fin

Pf is power failure\015\012 your loosing voltage to the unit \015\012it may just be the door switch or it could be in the control\015\012 try starting the unit but keep your hand on the unit pushing the door in place,, its not a g ... Electrolux 24 in. EDW5500DSS Stainless Steel Built-in Dishwasher

My Dishlex global 300's rinse light is flashing after 5 mins use. About 2 inches of water stays at the bottom of the washer. Bought this second hand and it has not been used for a few months. Do I need to fill the reservoir under the washer or lean it at 45 degrees to dislodge anything in the sump. If you have had the problem of the washer starting its program and then stopping after 5 minutes and the rinse light flashing I would appreciate your advice. Cheers Hyph

The flashing rinse light is an error code. I am assuming that your control board is good because the lights are working. I'm also assuming that this model has two pumps. One for filling and one for draining. The rinse light flashing is probably i ... Dishwashers

My Kenmore model 665.16022401 has the problem w/ the clean light flashing. I tried the bottom combo of hi temp wash, heated dry, high temp wash, heated dry and it re-set my dishwasher but then after I tried to run a new load it doesn't seem like it finishes all the way through because there is still soap left in the soap dispenser and the dishes arn't all clean, plus the green clean light begins flashing again. Don't know what to do.

... Kenmore 24 in. 16022 Built-in Dishwasher

Green light flashing and water still in bottom of dishwasher. I have cleaned the filters also I cannot reset the start button it just keeps starting again and then stops and green light flashes again

Hi,If this is the clean light the follow the link below, it will explain the flashing and how to reset the control so you can use the dishwasher again. ... Whirlpool Dishwashers

Dishwasher fdw60g fault lights i have the eco and prewash light flashing. i know that this means the filter is blocked. i have cleaned the filters and checked the hoses for blockages and they are all clear and kink free. i have tipped the machine on its side and checked the pump , which is clear aswel. i dont know what to try next to get the machine working and the lights to stop. thanks

... Dishwashers

Ariston LI620 dishwasher. Stopped on first rinse, 1st and 2nd lights from left flashing

... Ariston Technologies Dishwashers

Hello I have a LG Dishwasher which is flashing OE on the left side with bells going off, the wash rinse dry lights are also flashing can you help me please? I can not get it to go any further in the cycle. Unfortunately I dont; have the manual

What is the model number of your LG dishwasher? Look on the edge of the door (right side) for a silver tag. ... LG Dishwashers

I have an Ariston LI45. The stupid thin one. It's not seen much work & is just out of Guarantee. It's stopped working & is showing 2 flashing lights. Stops partway in to a cycle with water in the base, but not enough to cover the element. Tried re-setting, no difference. I have also noticed that it's melted a plastic wheel off the bottom tray at the back. After reading problems with other washers, i'm guessing the water level switch & maybe element too. If this is the case, i'm ok finding the

... Dishwashers

Asko 1996 appears "dead".....no lights flashing, won't respond to repeatedly pushing on/off button. Some water left in the bottom...siphoned it out, cleaned filters, no blockage there. Almost like it's not getting electricity, but breaker is on. Noticed this when I went to empty clean dishes, and noticed that detergent hadn't dissolved and dishes weren't clean and about a gallon of water was still in the bottom.....

Don't know if this will help, but my dishwasher has a "propeller" device above the top and bottom racks that spins while dispensing the water. If the dishes on either rack are stacked too high (i.e. if even one plate comes in contact with that ... Asko D1996SS Built-in Dishwasher

After selecting a program, the dishwasher beeps for a while and the 3 buttons on the left flash too. Program wont start, water wont fill and nothing happens. THe lights keep flashing but the beeps stop for about 30 secon ds then start again. Help me Please.

Basically the dishwasher is telling you there is a fault - Not so useful I know! Plug out the machine and leave it for five minutes and see will it reset. If that does not work, you will need to reset it manually. To do this consult the manual. If yo ... Hotpoint 18 in. DC28 Slim-Line Built-in Dishwasher

I have a SMEG DWI 46.1 dishwasher that has stopped working. Lights 2 and 4 (counting from the left) are on constantly and light 5 is flashing. By pressing the program button nothing happens. I cannot find a user manual online. Thanks

It is very likely the manual at this site is for your SMEG DWI46. The troubleshooting information is on page 59. \015\012It is ... Dishwashers

My dishlex globale 300 has a modle no that is dx300wa*02 the eco light and pump keeps running i have recieved advice to drain/dryout the kidney shapped over flow tray but mine doesn't seem to have one. i've taken off the bottom cover to get a closer look but still can't see it i've also tried tipping the washer on it's left side right side,backside and even upside down to try and drain the extra water but that has made no difference please help

Hi,\015\012Try taking the dishwasher out of its wall space and tipping it back and forth. Apparently the weight of water gathering in some component triggers the 'eco' function. Allow it to evaporate by waiting for few days. ... Dishwashers

I have a miele model G2470 SCVI under cabinet dishwasher it worked great until i ran out of cascade and starting using a liquid brand (Sun Light Oxi Action) we dont use the system on a regular basis so when i turned the unit on and attempted to use it , it started up filling and then sounded like it was running, the alarm tone came on with all the lights blinking a code F14 was flashing on the left side display.

... Miele Dishwashers

My electrolux dish washer model eidw6105gso stopped before it completed the cycle. All the selection lights were flashing and i could not get any functions to change. I killed the power at the breaker to try to reset and that didn't work either. I removed the panel on the front on the bottom to see if there was a reset button and found another display that is showing a light on the turbidity location. what is this and what might i do to get my washer back working?

... Electrolux Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1060 seconds